Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 92 Results
  1. XJ Cherokee Technical Forum
    I'm new to the Jeep world, and bought an '00 XJ/4.0. It's got a 4.5 inch lift on 33's. The ball joints are shot and I'm up to replacing them, but need to know if they require an adjustable or offset pair of ball joints. Any clue on whether to go back with a standard pair, or is there a way to...
  2. General Discussion
    Good Evening, Can anyone recommend an alignment shop in Indianapolis to have a lifted WJ aligned? I have a 2004 Grand Cherokee with Quadra-Drive and a 4.7. The vehicle has a ZONE 4in lift, adjustable control arms in the rear, adjustable upper control arms in the front and the fixed ZONE lower...
  3. WK Grand Cherokee & XK Commander Forum
    Hello gents, Long-time post cruiser, first time posting. I have a 2008 WK grand Cherokee limited, quadra drive CRD diesel that I accidentally lifted too high. ( said no one ever) Seriously though, I did not mean to have such a big lift. I skimmed the sparse databases I could find on affordable...
  4. ZJ Grand Cherokee Forum
    It's a '96 5.2. I just installed 3.5" RC springs and shocks and it drives surprisingly well with no further mods. Tends to wander back and forth slightly at 60+mph with some vibration, presumably from the driveline. I'm not sure if this is toe in or camber but I suspect camber. I blame the pops...
  5. ZJ Grand Cherokee Forum
    Hey all, I recently lifted my ZJ (95 Laredo 4.0) with the rough country 3.5" lift kit (front lower control arms/bushings, extended coils etc.). Since I was doing the lift I decided to do a whole front end rebuild as I was tearing it apart anyway. I am experiencing issues with steering and...
  6. WK Grand Cherokee & XK Commander Forum
    A few days back I replaced both of my lower control arms and afterwards the alignment was out by a mile, with the wheels visibly crooked. I adjusted the toe so that it at least wouldn't squeal the tires and went for an alignment. On the way to get it aligned the steering wheel was way off...
  7. XJ Cherokee Technical Forum
    The wheel on the passenger side of my XJ locks up while attempting an alignment but moves just fine while driving. The wheel on the driver side is fine and moves as it should. What is causing this? I am experiencing steering wheel pull on the road, hence, the attempt at alignment.
  8. Tires & Wheels
    The passenger side wheel is locking up while attempting to do an alignment but turns fine while driving. What is causing this? I am experiencing steering wheel pull on the road which is the reason for attempting alignment.
  9. General Jeep & Off-Road Equipment
    I recently started experiencing the death wobble. I had my 2010 Jeep Wrangler Rubicon 2 door(stock) looked at and I was told it was because my alignment was thrown off which was caused by my shocks being worn out. Therefore my death wobble was essentially caused by bad shocks in the end. I am...
  10. WK Grand Cherokee & XK Commander Forum
    Hello! I have a 2005 Grand Cherokee Limited 5.7L. 2" Strut spacers lift with General Grabber AT2 tires (265/70R17). I've noticed that, over the last year of regular driving, both of my front tires are worn considerably more than both rears (about 30% less tread at least). Yeah, I probably...
  11. TJ Wrangler Technical Forum
    Rotated my tires today after noticing that the fronts where significantly worn, after only about 10,000 miles of driving. When I pulled the fronts off, I noticed some serious negative camber wear on the tires. Ball joints appear to be fine, but standing in front of the jeep, it does indeed look...
  12. TJ Wrangler Technical Forum
    I've been reading up on caster and what it should and shouldn't be set to. I understand factory is at 7 and that with a lift and larger tires, it should be less. I recently lifted my jeep and netted about 2-2.5" lift and have 265/75/16 (~32") tires. The alignment shop printout reads that my...
  13. TJ Wrangler Technical Forum
    I was recently hit pretty hard in my back left tire and now I'm dealing with some serious alignment issues leaving my 2004 Jeep Rubicon crippled afraid to drive it anywhere. I will be taking it in to the local shop this week, but wanted to see if anyone could speculate what I'm potentially...
  14. YJ Wrangler Technical Forum
    Hey guys, I've searched the internet and this forum for someone with a similar issue to mine and haven't had any luck so far. I just bought a hard top and full doors for the first time. Got the hardtop on with no issues at all. Put the passenger side door on and loosened the torx bolts on...
  15. Jeep CJ Forum
    Bought 304, 75 CJ5. It was running but the frame modifications were haphazard. The cab is raised on 4" bushings and and it's got 8" shackles. In the process of fabricating motor mounts because the old ones were sheared off because bad alignment. Need advice on aligning/mapping engine to frame...
  16. Jeep CJ Forum
    Bought 304, 75 CJ5. It was running but the frame modifications were haphazard. The cab is raised on 4" bushings and and it's got 8" shackles. In the process of fabricating motor mounts because the old ones were sheared off because bad alignment. Need advice on aligning/mapping engine for new...
  17. WK Grand Cherokee & XK Commander Forum
    Getting ready for purchasing and installing the OME HD lift on my WK. I understand there is a lot more expenses that go with installation than the kit itself. So to the jeepers who have gone through installation, what items are needed? I've read that many people buy a adjustable trackbar, new...
  18. KJ Liberty Forum
    Recently I replace both lower ball joints and installed new upper control arms. Before this, all of the ball joints where almost completely shot, so getting an alignment did nothing. After the work, I took it in to get it aligned, and I was told that the right rear camber was maxed out and was...
  19. JK Wrangler Technical Forum
    im a jk newbie, i went to get my jk 2011 alignment, he called and told me that this type of car does not have a caster or camber and can only due the toe alignment, i did a quick search online and havent found anything of this sort? so what im asking is this true?
  20. KJ Liberty Forum
    My 2003 Liberty Limited (purchased about a year and a half ago) experienced a lower ball joint failure recently. Fortunately we were only traveling about 5 miles an hour when it happened, pulling into a parking spot. I usually try to do work on the car myself, but when this happened about a...
1-20 of 92 Results
Top