Search Results for ‘360 v8’

Hi everyone. New-ish member here. I am currently digging into my '79 CJ5 project and wanted to get some input. I am having an AMC 360 built with a mild cam and fuel injection. I am bolting that to a Ford T-19 with a Novak Conversion kit. Finally, I am installing Moser one piece axles in my...

hey fellow jeep enthusiasts. for the last 6 months I have been through a whirlwind of problems on this old hunk of metal. first she popped the Neutral safety switch, then i went through about 3 soloniods in a row just kept popping them. 2 things no sweat right. well then she started dying out...

Hello, A few weeks ago my oil pressure went up so high it blew my oil filter, and OPS. I would greatly appreciate some direction here. Here are the details and timeline; 1989 Grand Wagoneer with a 360 and 127k miles Back in October I noticed the oil pressure was very low (single digits) so I...

So my yellow submarine decided to start acting up...I was driving home recently and it just died! Would not start for around 10 minutes while I was stuck in the middle of a bridge :/ got dark and I waited until the following day to do the diagnosing.... Can't figure it out, I replaced ignition...

Well, just bought a AMC 360 to install into my 87' Grand Waggy to at least get it going and smogged. The guy I bought it from is a good customer of ours at the shop I work at. Ran good, decent compression, however he thinks it's a 77', not an 84' so now I am wondering if I opened a can of worms...

77 Cherokee Sport with 360 4 barrel carb won't start after it sits overnight unless primed with gas or starting fluid. Once started runs good, and continues to start every time after initial start of the day. Any suggestions?

This is the beaut started on my way home from work one day, I pulled over and noticed two small holes, one in the front and one in the rear of the intake gasket which obviously where spitting oil of longer than I knew. She was dangerously low on oil and smoke was protruding from both holes...

Hey guys i'm newer to the world of fsj and i can't figure out what's causing my starting issues. i have an 89 grand wagoneer with a 360 amc that won't start most days (usually the colder ones) and if i do get it started it will usually bog way down or stall out when going from braking or...

I have a 1980 cj7, the vin says it has a 304 V8, the block has a 360 raised stamp on the left hand side thats about 1 inch tall, one guy told me the 360 stamp means the engine has been swapped and that it is a 360, someone else has told me that the stamp means nothing, can someone please...

im currently in the process of swapping a amc 360 into my 87 yj, i have some questions on the conversions though, i understand the d35 will explode and i understand that the ax-15 is on limited time but what i need to know is in the hood department - ive heard you can use the stock passenger...

I saw a Grand Wagoneer that was sitting for months and when the truck started up a little steam came out out of that tube, actually the tube did not have the yellow cover like the one on the picture (click or copy the link), it was open, the engine was running nice and no black or blue smoke was...

I have a 1990 Grand Wagoneer (360 V8, 2 barrel carb) and I live in Florida so there are no emission laws. The previous owner removed the air pump belt and everything seems to be running fine. So I am wondering if I can remove the pump and other lines. Can I remove the air injection manifold...

I am buying a 1981 Jeep Wagoneer from a friend and before he stopped driving it he rebuilt the motor and bored it out some so its closer to a 390 CI now but it has been sitting for about 10 years and I was wondering what should I do to hopefully get the motor to run? I had one friend tell me I...

I have a 1981 cj7 that I'm going to be working on soon. Right now I'm just researching. I'm planning on 2.5" of suspension lift, and some shackle lift, with 33" tires. (Along with a new body, and a lot of other work) Now I'm trying to decide what engine I'll use. It's going to be a daily...