Search Results for ‘2000 tj’

Hey Ya'll, New guy from Panama City Beach, FL. Running a 2000 TJ, 4.0, 5sp manual, tow package (i.e. Dana 44 rear), 3.73 gearing, 4" lift, 33x12.5r15 Gen Grabber AT2 (totally worn) on ProComp series 69 alloys, and a Besttop Frameless top.

Ok, so what do ya do when you need help? Reach out to the experts so here it goes. In terms of mechanic skills I'm not too bad. I recently bought my first Jeep after years of wanting one and now there is no turning back. I have been reading posts on here and been getting some ideas for...

What Up?!?! I have been behind the wheel of a jeep since 2002, don't know if I would ever consider anything less...I'm coming from a Little suburb outside of Pittsburgh, although we consider it the sticks here. Been all over the county, and my jeeps never let me down. I'm a typical backyard/...

So I have a growing problem with my '00 TJ Sahara inline 6 4.0L. I had the radiator replaced recently along with my thermostat,temperature sensor, spark plugs and drive belt thinking that it would get my jeep fixed up for a while. After the repairs were made the jeep begin to turn itself off...

Hey everyone... I'm in search of a PCM pinout diagram for both a 2000 and 2004 TJ 4.0 (all three plugs for both). Long story, short... I've got an '04 TJ (originally with the 42RLE trans) with it's original engine harness and I'm swapping over to an NV3550 from my 2000 parted out TJ. I've got...

i got my first jeep registered a few months ago and i wanted to install this 4'' rc lift http://www.roughcountry.com/jeep-suspension-lift-kit-906s.html is there anything i should know before buying it. i also wanted to buy some 33'' tires to go with it, any recomendations for good A/T tires and...

I have the door jamb switch byt the pig tail it plugs into is gone. The wires are just hanging there. I have no access to junk yards. Anyone know where I can get the pigtail part without buying entire wiring harness? Is there another switch I can use that will fit that has leads so I can...

I live north of Boston, Andover MA. I am looking for a welder/fabricator to fix my rusted out 2000 tj. I'm having trouble locating anyone. Any help would be appreciated. I'm new to these forums, new to Jeeps and have no welding experience. I am not looking to get soaked. Should I buy some...

Does anyone have any advice on the procomp lift kit in this link. I am willing to spend the extra money for a quality lift kit, but not over the top. Just doing some research...

I have a 2000 TJ. It starts fine and idles great like 750 rpm when cold. As it warms up the idle increases and once warm it is idling at like 1750 rpm. Also when I'm driving the idle will be high like at a stop sign and also when I take my foot off the gas and push in the clutch the rpm's will...

Hello all, I am brand new to this site and not a jeep specialist, but know a little bit about them. I bought a 2000 Wrangler TJ that has 4 banger in it that has a cracked head. I bought it because the jeep is very nice and I got a slamming deal on it. Now here's the question, I have a friend...

hey guys sooo i rolled my tj :thumbdown: (frame seams straight but body is trashed) and found an 03 tub for cheap i was wondering if this would work or what problems i might run in to? i want to keep all the guts and my 4inch longarm lift will this tub still bolt into place?

Could someone please tell me this. I brought my Jeep, just bought recently, to a reputable repair shop and told them the problem. So they said I needed a new clutch, transmission, etc. It's still making the noise tons of money later. What are they missing? What should I do? I have to drive...

i just did an oil change on my 2000 jeep tj. I drove it about for about half an hour with no problem than the oil pressure dropped to zero when i came to a stop. I pulled over let it sit for 5 min than restarted and was fine for about 10 min than started running at low pressure again and dropped...

I have a 2000 TJ 4.0 and I've been reading a lot here about replacing the heater core. The price of an OEM is more than I can spend. I found one on craigslist for a 2000 Cherokee. I emailed the seller and he said it's OEM, but the add states that the asking price ($45) is half the cost of one...

the jeep hunt continues today. today im looking at a 2000 tj sport. i would like some input from the pros. any tips on what to look for would be greatly appreciated. so here it is http://hartford.craigslist.org/cto/2451238926.html

I need to know if a 93' 2.5i wrangler engine will fit in a 2000 wrangler? I have found one with 25k on it for a great deal, and I need to replace my 202,000k engine. Thanks

Guys, I have an issue with my Jeep that Im stuck. Original issue: Heater blows, but only blows outside air temperature air. Fixed so far: took to dealership, they recommended new radiator, coolant system flush. I took it home and did all of that my self New radiator installed New temp...