Search Results for ‘1998 xj’

I'm pulling the engine out of my '98 Cherokee to replace with a 4.6 Stoker (need a bit more power/torque) but the engine runs great so I'm going to let it go to someone that can use it. Comes with exhaust manifold (lifetime warranty from O'Riley's) that has no cracks (Installed October 2020) and...

1998 Jeep Cherokee XJ 4WD 4.0 My heater core broke so I replaced the heater core, ac evaporator, blower motor, relay, and resistor. When I put the box back on and turn it on i can hear the fan working*but nothing*is coming through the vents

A week ago it started after replacing the thermostat, but ran rough then died. I have replaced the CKS, the coolant sensor temperature sensor. No spark. Replaced a worn rotor and distributor. Checked the coil. Getting 5v to both of the above sensors. Not getting voltage to the coil. I hear the...

I recently had to get into my drivers side door jam to replace some broken wires that were shorting out when the door was open more than 10-15 degrees. As far as I can tell, I replaced all of the wires that were frayed or cracked, and this has corrected MOST of the electrical problems coming...

I have a 98 xj with power windows and locks. My front passenger window has recently stopped working, thankfully in the up position. Every other window works correctly from both the master driver door and the respective door (back left and right) controls, so I have ruled out the possibility of...

Hey everyone, So let me start with how I came to this point. My buddy bought a 1998 xj with a beat 4.0 motor. The piston shattered inside! So, he bought a nice rebuilt 4.0 motor. After dropping the new motor in, the engine cranks but doesn't start. It cranks (not the strongest) -brand new...

im looking for a high performance cam for my Jeep as im chasing a bit more power. do you guys hav any recommendations?

i have a 98XJ, 4.0 with about 194k on it. I have had this issue where my XJ will sputter real bad on initial acceleration after i start it. i have a new fuel pump, injectors, and a bunch of sensors. My Chiltons manual says my fuel pressure at idle should be at 31psi. Mine is reading 50psi. could...