Jeep Enthusiast Forums banner
Showcase cover image for Jordan

General Information

Grand Cherokee
Metallic Black
Laredo (with upgraded interior including leather seats, door bezels, and wood grain trim)


Iron Rock Off-Road Center Console MOLLE Panel
MyMedic Solo First Aid Kit (with LifeStraw)
Midland MicroMobile 15W GMRS Radio
Rexing V1 Basic Dash Cam
YESCOM Rooftop Retractable Awning
Midland 3dB Ghost Antenna (GMRS Radio)
Limited Grill Swap
Jeep WK2 Black & Chrome Door Badging
Backup Camera
Head Unit: Boss Audio BE9ACP-C with 340w Amplified Deck (Elite Series)
Front Door Speakers: Pioneer TS-A6990F 5-way Speakers (A-Series)
Rear Door Speakers: Pioneer TS-A1375R 3-way Speakers (A-Series)
Dash Speakers: Pioneer TS-A878 2-way Speakers (A-Series)
A-Pillar Speakers: Kicker KST25 1” Tweeters (KS Series)
2 - 12” Kicker CompR Subwoofers (Loaded Enclosure)
Kicker CX 1200.1 Mono Amplifier (Sub Amp.)
Spyder Auto Signature Series V.2 Light Bar Projector Headlights
Spyder Auto V.2 Smoked LED Taillights
KC HiLiTES 315 C-Series Amber 3" C3 LED's
GOVEE RGBW Rock Lights
2.5” Coil Spring Lift
Rusty’s Offroad Front Coil Springs
BDS-Suspension Rear Coil Springs
FOX Shox Performance Series 2.0 Smoothbody BDS IFP
ZONE Offroad Extended Front/Rear Sway Bar End Links
Rancho RS5409 Steering Stabalizer
MOOG/ACDelco Coil Isolators
Wheel and Tire
16in ProComp La Paz Series 29 (4.5" Backspacing - 0 Offset)
29.5" Hankook Pathfinder AT (245/70r16)
PowerTech 4.0L I6
42RE Automatic Transmission
Future Modifications
*BFG KO2's, off-road lights, potentially a front selectable locker and rear Detroit TrueTrac*
RotoPAX 3.5 Gallon Fuel Tank
Apollointech Auxilary Switch Pod (Pro Series)
Viper Remote Start System
MAXHAUL Roof Basket
Recovery Gear
ARB Onboard Air Compressor
MAXSA Traction Mats
Bubba Rope Power-stretch Kinetic Rope
EAG Modular Front Bumper
Rusty's Off-road Transfer Case Skid Plate
Axle Gear Ratio
Rear Axle
Dana 35
Transfer Case
Front Axle
Dana 30
Here's the build! Slowly adding as the days go on and the funds come in.


23 Posts
Nice rig man! Got a question about your headlights. How is those projectors doing for you? I had a pair of them myself and loved the crap out of them, but the cutoff shield on the projectors were not cut with much quality. IIRC, the right one had virtually no cutoff on the right half of the beam though adjusted correctly. Then I had some fool back into me and ruined both headlights, so in a pinch I just threw my stock reflectors back in. I don't currently have the funds right now, but I see Spyder only makes them in chrome and saw a site say the black version I prefer will be available again in July. If I manage to snag a set, I will probably end up retrofitting with a set of comparably sized Morimotos if I get the time, money and patience lol.

Amateur Wrencher
2004 Jeep Grand Cherokee
68 Posts
Appreciate the kind words! I totally understand where you're coming from - I had the same issue with mine funny enough in regard to the cutoff. When I first got these headlights, and in similar fashion to the halos I originally had, the cutoff always seemed off. No matter what I did to adjust the angle it just never seemed to get better. However, I recently decided to change my bulbs in the projectors since I noticed a flickering when going over bumps. Now with those new headlights in they fit better, no flickering, AND the cutoff is where it should be. All that to say, in my experience, sometimes the fixture isn't the problem but rather the bulbs you're using. In which case, the bulbs I got are the Marsauto 9006's off of amazon. 30 bucks for the pair and it'll autofill the correct size and whatnot once you put in your Jeep specs. Hope this helps!

23 Posts
Hey no problem man.

And hmm that is very interesting. That could potentially have been my problem as well with the cutoff. For as long as I have owned my WJ, I have ran the Sylvania zXe 9006 bulbs and been very pleased with the whiter spectrum of light they output compared to the non Xenon-infused halogen bulbs. But when I got those projector headlights, it output a yellowish color as if it had regular halogens. I personally cannot see very well with that color of lighting, part of why I like my zXe bulbs so much, but I could not afford an HID kit that I wanted. Unfortunately those headlamps did end up being recycled as they were crunched in from the collision. I see ProTuningLabs has these lights with an included HID kit which I can get with 6000k bulbs. If they do get them back in stock, I will try to jump on it as soon as possible when funds allow. If I am unable to get them, but can get just the housings from another vendor, I will for sure keep the bulbs you mentioned in mind.

And I look forward to seeing the future progress on your WJ. About everyone I know that owns a WJ sure do love em.

Amateur Wrencher
2004 Jeep Grand Cherokee
68 Posts
21panzer;41331373 said:
Jordan what are wheels and tires? Love the look!
Thank ya! So we’ve got the 16in ProComp La Paz Series 29 which has 4.5” of backspacing and zero offset, which is perfect especially when you want to increase tire size as it gives you a little more wiggle room. Overall though, I love these wheels, and the picture doesn’t do them justice but they’re a deep matte black with a slight polish so they look amazing when clean. Tires are a 245/70r16 Pathfinder AT which are a discount tire exclusive but if I recall the tire is in-fact made my Hankook and is set to replace their Dynapro AT2 as they’re pretty much carbon copies of each other. Nonetheless, it’s a great tire and very budget friendly. Was able to make my away around Moab without much of an issue last I went and my local trails here in Colorado with some snow. However, I’m getting a 2.5” lift installed as of right now so I’ll be changing these out for some Goodyear Wrangler Ultraterrains AT as I’m wanting something a a little larger and more aggressive.