Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 349 Results
  1. WK Grand Cherokee & XK Commander Forum
    Bought a 06 grand Cherokee limited w the 5.7 a few weeks ago. I swapped a used transmission and torque converter in a few days ago because the originals od clutch was completely burnt and it didn’t have 3rd or 4th gear. Now when I put it into gear the display says it’s in all gears. It looks...
  2. WJ Grand Cherokee Forum
    Update: With the help of a local vendor and @underscore here are the yoke numbers you'll need: Front diff (Dana 30) - Spicer: 2-4-8091-1x Transfer case - Dana 10049138 - comes up for a JK Wrangler but the specs match And still need to confirm but the driveshaft is out of a 93-95 5.2L ZJ -...
  3. YJ Wrangler Technical Forum
    Hello All, I'll start off with a bit of back story here. I purchased this jeep years back and the PO had recently done a swap to an NV3550. For the longest time, I had issues with the tranny popping out of 1st, followed by an eventual failed syncro going into 2nd. I did not know any of the...
  4. Jeep CJ Forum
    I have a 1981 Jeep CJ7 with 258 I6. Currently swapping the Carter carb with a Motorcraft 2100. I've noticed the OEM air filter and Carter carb have a lot of vacuum/air hoses compared to the Motorcraft. Which air hoses are needed for this swap? Which ones can I get rid of? Most how to's...
  5. Jeep Grand Cherokee & Commander Forums
    I have a chance to get a great deal on a 5.7l hemi out of a 2014 overlandand want to swap it into my 3005 laredo if possible. any thoughts? If it is compatible is there anything I should know? thanks ahead of time for any help.
  6. WJ Grand Cherokee Forum
    Hey yall, I have a V8 WJ w/ 4" lift, locker, NP247 which has blown a head gasket and I've been thinking about buying an I6 WJ with the NP242 and swapping all my goodies over to it. So my question is would this be a bolt on swap, and would there be any driveshaft issues doing this? I have the...
  7. ZJ Grand Cherokee Forum
    So the time has arrived, i just purchased an AX-15 and I’m going to swap it onto my 95 zj. Im making this post in hopes to get any information that could aid me in the swap, when I’m done I’m going to make a separate post going over the process as much as i can so i can help aid others if they...
  8. WK Grand Cherokee & XK Commander Forum
    Hey guys. 07 CRD that isn't charging, and it may be an ecm/pcm issue. Has anyone swapped in a 2 pin alternator with an external voltage regulator? If so, what Alt did you order, or can I rebuild my oem alt with proper components? Any guidance would be appreciated TIA CD
  9. TJ Wrangler Technical Forum
    Recently I’ve been thinking of putting a large displacement v8 in my TJ. It might be a crazy idea however it’s something I really want to do. I’m thinking a 6.2 and as of right now I’m set on it I wanna know if it’s even possible first. However if anyone has any better idea I would like to hear it.
  10. YJ Wrangler Technical Forum
    Hello guys, i’m in the middle of an aw4 swap to my 4.0 HO YJ, i got a wintershifter and the control kit from Radesign. How can i locate the solenoid wires? Is there any other surprises should i expect (flexplate, cranshaft sensor…)? thank you!
  11. Engines & Drivetrain
    I bought a 2002 4.7 out of a liberty and am trying to put it into my 2005 GC limited everything went I. Fine the old motor had a egr as the 02 does not everything else plugged I. Just fine however now it cranks but won’t start. I’ve replaced the crank and cam sensor and checked all the coils...
  12. ZJ Grand Cherokee Forum
    I am looking more if this can be done. My 4.0 has developed a issue, it feels like low compression in a cylinder. Basically it has a shake at low idle, but it seems to run ok and the vacuum is ok and the mileage is not that bad, so I am going to have to do a compression test and see. It does...
  13. YJ Wrangler Technical Forum
    Hi all, first post here on wrangler forum, but by far not the first visit. My father has a 1989 Jeep YJ which he has supped up with the following upgrades. - Nv4500 4x4 ram - Atlas transfer - Tomwood CV - ARB back diff - Dana 30 with warren disconnect hub front diff - Rear disc brake - old man...
  14. TJ Wrangler Technical Forum
    About 4 months ago I had a stock 3 speed auto in my Tj. Unfortunately, it was starting to go out and none of the transmission shops near me would touch it. Well I always wanted a manual transmission and always wanted to learn how to drive one. I did a bunch of research and after two weeks of...
  15. TJ Wrangler Technical Forum
    I've been lurking long enough to know of the very ubiquitous 8.8 rear axle swap. I haven't seen a great deal of info on what are the common front axle swaps people do barring a jump to one tons. I'd be really interested to see what people have swapped or commonly swap for the front axle...
  16. TJ Wrangler Technical Forum
    Alright, so I got a wild hair and thought that I could swap in an 8.8 for my dana 35 in the rear. I am about halfway through my project and I am having some concerns. 1. When I weld up all the mounts and mock it all up if my measurements are off a little bit whats going to happen? 2. If it is...
  17. Jeep CJ Forum
    For my birthday I acquired a 1979 CJ7 with an AMC304 swapped in, but on the hour and a half drive home it ate some crankshaft bearings. The whole thing needed a bit of work work, so I decided to do a full frame up restoration (not going full original, but as reasonably close as I want) but it...
  18. Engines & Drivetrain
    Looking for any and all advice on an engine replacement. I'm a relative novice when it comes to engine work, so hear me out here. I've got a 2000 TJ Wrangler with the ol' 2.5L 4 cylinder engine. It recently developed a knocking, and as opposed to diagnosing and attempting to fix whatever is...
  19. YJ Wrangler Technical Forum
    Hi everyone! I'm in search of some answers regarding rear axles in the YJ's. I have a 88 YJ Base that I bought a while back. When I bought it the previous owner said that the owner before him replaced the rear axle with a higher ratio gear setup. I'm not sure what it is currently but I know the...
  20. YJ Wrangler Technical Forum
    On 1995 Jeep YJ 2.5L with 3 speed automatic it is originally equipped with ECM part #56028833 for an automatic; these are hard to find, especially in Belize. Chrysler discontinued making them. I sourced a 56028842 for same year from...
1-20 of 349 Results
Top