JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.04 seconds.
Search: Posts Made By: sduncan
Jeep Forums: TJ Wrangler Technical Forum   08-09-2019, 08:22 PM
Replies: 9
Views: 537
Posted By sduncan
Youíll be hard pressed to find a better tire for...

Youíll be hard pressed to find a better tire for sand than a Mickey Thompson MTZ3 at about 5-6 psi. Iím currently using 35 inch Goodyear MTRs on 10 inch wide wheels at 5 psi. They work well, but my...
Jeep Forums: TJ Wrangler Technical Forum   08-06-2019, 08:28 PM
Replies: 9
Views: 355
Posted By sduncan
Metal Cloak.. leave the RE hollow noodle alone..

Metal Cloak.. leave the RE hollow noodle alone..
Jeep Forums: TJ Wrangler Technical Forum   07-27-2019, 04:26 PM
Replies: 20
Views: 691
Posted By sduncan
So everyone with an SYE and no angle on the diff...

So everyone with an SYE and no angle on the diff end is experiencing the same thing I am? Because we all set them up the same, so we should all be having 1310 u joints with heavy wear on the...
Jeep Forums: TJ Wrangler Technical Forum   07-25-2019, 04:56 PM
Replies: 20
Views: 691
Posted By sduncan
All 4 trunnions are showing wear. And at speed...

All 4 trunnions are showing wear. And at speed there is zero vibration. I doing want to introduce a vibration as Iíd be getting one issue over another. Anyway.. if I remember correctly Iím already...
Jeep Forums: TJ Wrangler Technical Forum   07-24-2019, 04:08 PM
Replies: 20
Views: 691
Posted By sduncan
Thank you sir.. I have a beach trip in 10 days so...

Thank you sir.. I have a beach trip in 10 days so Iíll make it with what I have and then swap it. Iíll get a message to you.
Jeep Forums: TJ Wrangler Technical Forum   07-23-2019, 07:40 PM
Replies: 20
Views: 691
Posted By sduncan
Itís the greasable 153x. Iím not have an issue...

Itís the greasable 153x. Iím not have an issue with breakage, just extreme premature wear. There are no vibrations and at the axle there is no angle. The CV DL is pointed straight (well, down 1-2...
Jeep Forums: TJ Wrangler Technical Forum   07-23-2019, 05:23 PM
Replies: 20
Views: 691
Posted By sduncan
Dana 44 1350 yoke

Well.. Iím getting tired of replacing 1310 u joints at the axle end of the rear 44. The Spicer I swapped out today showed noticeable wear on the trunnions after two beach trips and 500ish miles of...
Jeep Forums: TJ Wrangler Technical Forum   07-16-2019, 01:49 PM
Replies: 80
Views: 2,037
Posted By sduncan
The trailer is your answer. Judging by the pic...

The trailer is your answer. Judging by the pic you posted of it sagging, youíre almost on the Ďstops just sitting there.. much less, I canít imagine it steering and handling worth a damn.
My 2...
Jeep Forums: Wrangler General Discussion   06-18-2019, 06:13 PM
Replies: 3
Views: 447
Posted By sduncan
October 2004 for me. My 98 was completely stock...

October 2004 for me. My 98 was completely stock at the time.. not so much now..
Jeep Forums: TJ Wrangler Technical Forum   06-17-2019, 10:29 PM
Replies: 13
Views: 828
Posted By sduncan
You still havenít swapped the baby Hemi out??! ...

You still havenít swapped the baby Hemi out??!

Cmon man!! :)
Jeep Forums: TJ Wrangler Technical Forum   06-14-2019, 09:52 AM
Replies: 13
Views: 828
Posted By sduncan
Yea... never said it would be cheap! But the...

Yea... never said it would be cheap! But the HotWire harness is a work if art and fit perfectly. It was worth it for me to go that route. I also have emissions to deal with and had to make it 50...
Jeep Forums: TJ Wrangler Technical Forum   06-12-2019, 11:01 PM
Replies: 13
Views: 828
Posted By sduncan
While I understand your reasoning for wanting the...

While I understand your reasoning for wanting the Magnum motor, just be aware that your 06 is a prime candidate for a 5.7 Hemi/545RFE swap. Your gauges, fuel system, evap system, and so on can be...
Jeep Forums: TJ Wrangler Technical Forum   05-27-2019, 01:07 PM
Replies: 15
Views: 599
Posted By sduncan
My single cylinder ARB will turn on, pressure up,...

My single cylinder ARB will turn on, pressure up, and lock both diffs in about 2-3 seconds and turn off. Yours shouldnít run all the time and it certainly shouldnít get warm enough in that amount of...
Jeep Forums: TJ Wrangler Technical Forum   05-11-2019, 06:56 PM
Replies: 9
Views: 629
Posted By sduncan
This right here. Best prices and selection. They...

This right here. Best prices and selection. They also offer the extended thread versions too
Jeep Forums: TJ Wrangler Technical Forum   05-07-2019, 06:22 PM
Replies: 19
Views: 1,082
Posted By sduncan
And........I still havenít bought a new soft...

And........I still havenít bought a new soft top.. lol..yet
Jeep Forums: TJ Wrangler Technical Forum   04-30-2019, 05:05 PM
Replies: 20
Views: 1,174
Posted By sduncan
Like Jerry, Iím in California. My 98 TJ has ZERO...

Like Jerry, Iím in California. My 98 TJ has ZERO rust anywhere on it and my chassis looks better today than it did the day it rolled off the line even though I play at the beach a lot with it. I feel...
Jeep Forums: TJ Wrangler Technical Forum   04-29-2019, 07:40 PM
Replies: 13
Views: 762
Posted By sduncan
Probably same as mine.. 1. Ease of maintenance ...

Probably same as mine..
1. Ease of maintenance
2. General hate and disregard towards drums
3. Likely due for shoe replacement and do not want to put anymore into drum parts.

Those are my...
Jeep Forums: TJ Wrangler Technical Forum   04-22-2019, 04:50 PM
Replies: 36
Views: 1,573
Posted By sduncan
I ran mine this way for a while prior to...

I ran mine this way for a while prior to outboarding. I used the the stock uppers and made some lowers that boxed the rear lower CAs, and had no problems at all.
Jeep Forums: TJ Wrangler Technical Forum   04-10-2019, 09:58 PM
Replies: 168
Views: 14,372
Posted By sduncan
Looks great! Glad you got it on the road.

Looks great! Glad you got it on the road.
Jeep Forums: TJ Wrangler Technical Forum   04-09-2019, 10:05 AM
Replies: 12
Views: 721
Posted By sduncan
If your big.. say 250 or above, you may not like...

If your big.. say 250 or above, you may not like them.. I used to be about 280 (now at 220).. I sat in a friends and hated them due to the lower side bolsters.. I currently have the Corbeau Baja...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome