JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 90
Search took 0.99 seconds.
Search: Posts Made By: GTS225
Jeep Forums: YJ Wrangler Technical Forum   03-26-2020, 07:33 PM
Replies: 13
Views: 303
Posted By GTS225
I like, a lot. I may not be able to afford it,...

I like, a lot. I may not be able to afford it, but that's a nice looking project.

Roger
Jeep Forums: YJ Wrangler Technical Forum   03-10-2020, 08:13 PM
Replies: 4
Views: 174
Posted By GTS225
There's more to it than just a trans swap. ...

There's more to it than just a trans swap. You'll probably have to swap out the bell housing, too. What engine do you have?

Roger
Jeep Forums: YJ Wrangler Technical Forum   03-10-2020, 08:10 PM
Replies: 41
Views: 846
Posted By GTS225
Might I suggest the possibility of putting it on...

Might I suggest the possibility of putting it on the rear pinion? There are some kits available from the hot rod/old car suppliers that might do what's needed. One would probably have to fab a...
Jeep Forums: YJ Wrangler Technical Forum   03-09-2020, 07:34 PM
Replies: 41
Views: 846
Posted By GTS225
I beg to differ. The term "line lock" has been...

I beg to differ. The term "line lock" has been used for decades to describe an electrical solenoid valve that gets put into the front system of a drag car, in order to lock the front brakes so as to...
Jeep Forums: YJ Wrangler Technical Forum   03-09-2020, 07:11 AM
Replies: 41
Views: 846
Posted By GTS225
I would not recommend a line lock. It's...

I would not recommend a line lock. It's electrical, and will probably wear your battery down in short order. On top of that, there's no guarantee it won't leak down slowly, and your rig will roll...
Jeep Forums: YJ Wrangler Technical Forum   02-29-2020, 10:39 AM
Replies: 3
Views: 183
Posted By GTS225
OK. Pull the "sensor" back out, and while...

OK. Pull the "sensor" back out, and while looking into the hole for it, have a friend manipulate the gearshift, without it running. You should be able to see the "comb" in there that is supposed to...
Jeep Forums: YJ Wrangler Technical Forum   02-21-2020, 06:48 AM
Replies: 10
Views: 447
Posted By GTS225
So, y'all are saying I just need to throw a soft...

So, y'all are saying I just need to throw a soft top on it, and do the heater motor conversion so's I get good airflow in the winter? :grin2:

Roger
Jeep Forums: YJ Wrangler Technical Forum   02-16-2020, 08:10 PM
Replies: 5
Views: 179
Posted By GTS225
Remove distributor cap. Get a socket to fit the...

Remove distributor cap.
Get a socket to fit the crank balancer bolt.
Slowly rotate engine in opposite directions, paying close attention to how much crank rotation you get before distributor...
Jeep Forums: Wrangler General Discussion   02-16-2020, 07:11 AM
Replies: 4
Views: 324
Posted By GTS225
I've seen that discussed around a few sites as...

I've seen that discussed around a few sites as well.
Here's a line that bothers me, though.
"2. Conducted on vehicles registered to persons, not currently residing on the lot or parcel;"
That...
Jeep Forums: YJ Wrangler Technical Forum   02-16-2020, 06:36 AM
Replies: 10
Views: 447
Posted By GTS225
DANG! What I want is an upper, (either hard or...

DANG! What I want is an upper, (either hard or soft), that doesn't have sliders. I prefer a larger window opening than sliders can provide. I guess my only option is to get full hard doors, even...
Jeep Forums: YJ Wrangler Technical Forum   02-15-2020, 06:11 PM
Replies: 10
Views: 447
Posted By GTS225
Door expert needed.

'92 Wrangler with a hard top. Jeep has factory hard half-doors, but I suspect it came with a soft top, as there's no wiring harness for the hard top. (Original soft top is long gone.)

Query; will...
Jeep Forums: YJ Wrangler Technical Forum   02-09-2020, 08:42 PM
Replies: 25
Views: 698
Posted By GTS225
I might suggest you work up something for...

I might suggest you work up something for taillights at the ends of those lower swing-out arms. The camera angle makes it look like they extend about 4 feet, which means some non-driving phone...
Jeep Forums: YJ Wrangler Technical Forum   01-30-2020, 06:10 AM
Replies: 17
Views: 592
Posted By GTS225
Hey, Mrit! Does that suggest that it no longer...

Hey, Mrit! Does that suggest that it no longer runs fine? :wink2:>:)

Roger
Jeep Forums: YJ Wrangler Technical Forum   01-29-2020, 07:26 AM
Replies: 11
Views: 411
Posted By GTS225
So did you ever replace the converter? If...

So did you ever replace the converter?
If you're pulling in air and fuel, and burning it, you have to get rid of the gasses. If the converter's clogged, it's not doing that very well, if at all.
...
Jeep Forums: YJ Wrangler Technical Forum   01-28-2020, 01:45 PM
Replies: 17
Views: 592
Posted By GTS225
Broo; The first piece of info you should supply...

Broo; The first piece of info you should supply is the mileage on the engine. If it's a paltry 75K, then there isn't as much bearing wear as if it's got 190K on the odometer, and bearing wear, (or...
Jeep Forums: YJ Wrangler Technical Forum   01-26-2020, 06:54 PM
Replies: 13
Views: 362
Posted By GTS225
A) Did you put the scratch in the bearing cap? ...

A) Did you put the scratch in the bearing cap?
B) Did you buy this Jeep used?

If No and Yes, respectively, then how do you know when the scratch was put into the cap? It could have been there...
Jeep Forums: YJ Wrangler Technical Forum   01-19-2020, 06:33 PM
Replies: 19
Views: 608
Posted By GTS225
Fair enough. It's just that I've seen some weird...

Fair enough. It's just that I've seen some weird stuff done by P/O's on different things through the years, and it always makes me concerned when things don't seem to go right. I back up a step and...
Jeep Forums: YJ Wrangler Technical Forum   01-19-2020, 09:03 AM
Replies: 19
Views: 608
Posted By GTS225
This discussion makes me wonder......the way he's...

This discussion makes me wonder......the way he's holding that pump makes me think it's upside-down. Can a pump be mounted that way on a Jeep, or is it impossible?
I'm thinking that just because...
Jeep Forums: YJ Wrangler Technical Forum   01-10-2020, 07:01 AM
Replies: 11
Views: 545
Posted By GTS225
Any way you can get a "speedi-sleeve" onto that...

Any way you can get a "speedi-sleeve" onto that axle?
If you don't know what those are, they're a thin, stainless sleeve that you can press fit onto a grooved sealing surface. Takes the same seal,...
Jeep Forums: YJ Wrangler Technical Forum   01-08-2020, 07:38 AM
Replies: 7
Views: 455
Posted By GTS225
I would say yes. If it sat open as you say, the...

I would say yes. If it sat open as you say, the ducts could be full of leaves, twigs, or even acorns that the squirrels were trying to stash, and that may be the source of the racket.

Roger
Showing results 1 to 20 of 90

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome