JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 106
Search took 0.01 seconds.
Search: Posts Made By: mystert29
Jeep Forums: Wanted   07-12-2021, 07:50 PM
Replies: 0
Views: 66
Posted By mystert29
WTB pair of 6 bolt 27 Spline Manual Hubs

I’m looking for a pair of 6 bolt 27 spline manual locking hubs on a Dana 30. Looking for a good deal on a used Warn set. Let me know if any of you have some.
Jeep Forums: Jeep CJ Forum   07-12-2021, 07:47 PM
Replies: 5
Views: 419
Posted By mystert29
I took it all apart today and had to drill out...

I took it all apart today and had to drill out the small stripped hub screws. Need a pair of working 6 bolt hubs now. Warn hubs would be nice.
Jeep Forums: Jeep CJ Forum   07-12-2021, 01:57 PM
Replies: 5
Views: 419
Posted By mystert29
I have a Trutrac geared limited slip in the front...

I have a Trutrac geared limited slip in the front and its pretty beefy. My rotors are a bit rusted and are only like 25$ each. Just need to find another superwinch hub, turns out im missing the...
Jeep Forums: Jeep CJ Forum   07-12-2021, 12:06 PM
Replies: 5
Views: 419
Posted By mystert29
Hub and Brake Upgrade for 84 CJ

I picked up an empty front diff with spindles from a 77 CJ5 yesterday. It has 6 bolt hubs and disc brakes. Is it worth upgrading the stock 5bolt hubs I currently have? Also the stock
disc brakes...
Jeep Forums: Jeep CJ Forum   07-07-2021, 08:11 PM
Replies: 4
Views: 600
Posted By mystert29
Worn Clutch Linkage

I was adjusting the clutch in the Jeep the other day. I noticed there was some play in the pivot of the clutch fork lever. Take a look at the wear on this thing. It’s about 2/3 worn through! I...
Jeep Forums: Jeep CJ Forum   07-05-2021, 09:16 AM
Replies: 3
Views: 457
Posted By mystert29
When i sprayed PB blaster on the shaft the idle...

When i sprayed PB blaster on the shaft the idle settled down and became more consistent. After a few minutes it went back to being inconsistent. The throttle body is from Howell and has the brass...
Jeep Forums: Jeep CJ Forum   07-04-2021, 08:55 PM
Replies: 6
Views: 829
Posted By mystert29
I had a similar issue. Sometimes she would just...

I had a similar issue. Sometimes she would just randomly die then star back up fine after 5-10 min. It turned out to be where I spliced the purple the Howell EFI fuse block didn’t have a good...
Jeep Forums: Jeep CJ Forum   07-04-2021, 03:35 PM
Replies: 3
Views: 457
Posted By mystert29
The idle on my Howell EFI is inconsistent,...

The idle on my Howell EFI is inconsistent, sometimes idles perfectly at 750rpm, other times it’s 1100rpm. I’ve smoke checked it for vacuum leaks and there are none. I’ve hooked up my laptop to it and...
Jeep Forums: Jeep CJ Forum   06-30-2021, 10:33 AM
Replies: 9
Views: 1,260
Posted By mystert29
Instead of just guessing on what you need to...

Instead of just guessing on what you need to pass, or dealing with DMV beaurocracy to find the old paperwork, just go to the referee. The referee may pass it as is or instead he may require you to...
Jeep Forums: Jeep CJ Forum   06-25-2021, 08:14 AM
Replies: 40
Views: 5,441
Posted By mystert29
I have Howell FI on my 1984 CJ and I love it....

I have Howell FI on my 1984 CJ and I love it. Sure its 30 year old fuel injection technology but its waaaay better than the performance compromising Malaise Era emissions equiped carburetor setup...
Jeep Forums: Jeep CJ Forum   05-13-2021, 09:12 AM
Replies: 10
Views: 893
Posted By mystert29
Ive changed the rear main seal, oil pan gasket,...

Ive changed the rear main seal, oil pan gasket, and timing cover w/gasket with the engine in the jeep. Ive seen BMW get rod bearings installed with the engine in the car. You should be able to do...
Jeep Forums: Jeep CJ Forum   02-19-2021, 08:30 AM
Replies: 6
Views: 940
Posted By mystert29
Do you mind sending me the top half? PM me with...

Do you mind sending me the top half? PM me with how much you want for it plus shipping and a paypal address and I can send payment over. Thanks
Jeep Forums: Jeep CJ Forum   02-13-2021, 08:32 AM
Replies: 6
Views: 940
Posted By mystert29
Thanks. The bottom part is in good shape. Just...

Thanks. The bottom part is in good shape. Just need to replace the oring if you have the top half.
Jeep Forums: Part-Out   02-12-2021, 06:46 PM
Replies: 6
Views: 772
Posted By mystert29
Do you have the liquid check valve that’s back...

Do you have the liquid check valve that’s back behind the drivers side wheel wheel? I’ve attached a pic. DM me if you have one thanks.
Jeep Forums: Jeep CJ Forum   02-12-2021, 06:40 PM
Replies: 6
Views: 940
Posted By mystert29
I broke the nipple off the top of my liquid check...

I broke the nipple off the top of my liquid check valve changing out the hoses today because I failed CA Smog EVAP test. One of the hoses was leaking and when I was taking it off the nipple broke....
Jeep Forums: Jeep CJ Forum   12-22-2020, 10:36 AM
Replies: 6
Views: 404
Posted By mystert29
I remember reading on here somewhere that with...

I remember reading on here somewhere that with the high diff gears/big tires the T5 transmission is stressed/highly loaded. Sometimes when the correct gears are put in the diffs to match the tires,...
Jeep Forums: Jeep CJ Forum   12-15-2020, 05:24 PM
Replies: 12
Views: 556
Posted By mystert29
If you look at the throttle body, by the throttle...

If you look at the throttle body, by the throttle linkage, there is a brass serial number plate riveted onto the throttle body that designates it as the California Edition. In additon to the heated...
Jeep Forums: Jeep CJ Forum   09-08-2020, 07:52 AM
Replies: 0
Views: 141
Posted By mystert29
EGR Valve Differences

My EGR valve is causing a vacuum leak and I need to replace it. I live in California and my 1984 CJ7 has the California only serpentine belt setup. I also have the Howell Fuel Injection so most of...
Jeep Forums: Jeep CJ Forum   07-09-2020, 07:26 AM
Replies: 21
Views: 2,725
Posted By mystert29
Is a Scout Dana 44 really the easiest? I live in...

Is a Scout Dana 44 really the easiest? I live in Socal where old cars dont rust and fall apart yet hardly ever see a Scout driving around. I have also NEVER seen axles for them for sale on any of the...
Jeep Forums: WJ Grand Cherokee Forum   05-27-2020, 05:17 PM
Replies: 6
Views: 367
Posted By mystert29
Im going to grab the door harness from the...

Im going to grab the door harness from the junkyard for the one side. Its pretty small and easy to remove. That solves half the issue. I found the pins from cconnectorexperts.com but they want almost...
Showing results 1 to 20 of 106

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome