JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.08 seconds.
Search: Posts Made By: CarlJH
Jeep Forums: WJ Grand Cherokee Forum   06-29-2020, 06:25 PM
Replies: 4
Views: 138
Posted By CarlJH
take the brakes apart and hold the stud with vice...

take the brakes apart and hold the stud with vice grips, how I did mine when this happened.
Jeep Forums: WJ Grand Cherokee Forum   06-23-2020, 06:39 PM
Replies: 5
Views: 207
Posted By CarlJH
the thing the green arrow is pointing to is the...

the thing the green arrow is pointing to is the cruise control actuator, the bit that holds the throttle open when you set it.
Jeep Forums: WJ Grand Cherokee Forum   06-22-2020, 08:37 AM
Replies: 18
Views: 551
Posted By CarlJH
you need to get a decent scan tool that can show...

you need to get a decent scan tool that can show all the PID's to see what the various sensors are telling the ECM, mine developed a high idle around 900 rpm, scan tool showed the ECM was wanting...
Jeep Forums: WJ Grand Cherokee Forum   06-20-2020, 04:21 PM
Replies: 2
Views: 205
Posted By CarlJH
Tank straps..........

while servicing the rear brakes today I noticed the tank strap has rusted away and snapped, is it possible to change them without having to drop the whole tank down????
Is there enough room between...
Jeep Forums: WJ Grand Cherokee Forum   06-17-2020, 06:57 PM
Replies: 17
Views: 609
Posted By CarlJH
was going to try and do mine also a 2003 HO, got...

was going to try and do mine also a 2003 HO, got the driveshaft off (6mm, 6 point 1/4 inch socket) and measured the nut at 33 ish mm which is 1-5/16" which I did read somewhere was the size needed....
Jeep Forums: WJ Grand Cherokee Forum   06-14-2020, 07:36 PM
Replies: 13
Views: 568
Posted By CarlJH
you mean this bit? ...

you mean this bit?
https://www.rustbustersrepairpanels.com/products/dogleg-drivers-side-1
Jeep Forums: WJ Grand Cherokee Forum   05-29-2020, 04:22 PM
Replies: 49,582
Views: 4,610,617
Posted By CarlJH
Fender and wiring

today's job, replace the rusty right fender with a rust free second hand one and fix the black wire in the door boot
Jeep Forums: WJ Grand Cherokee Forum   05-23-2020, 07:06 PM
Replies: 12
Views: 409
Posted By CarlJH
Aren't they the transmission cooler lines?

Aren't they the transmission cooler lines?
Jeep Forums: WJ Grand Cherokee Forum   05-17-2020, 04:53 PM
Replies: 13
Views: 471
Posted By CarlJH
Rockauto has complete CV shafts from $30 to $47...

Rockauto has complete CV shafts from $30 to $47 depending weather it short or long or Vari-lok or not, they have a wholesaler closeout on one of the long Vari-lok ones for just $23 at the moment.
Jeep Forums: WJ Grand Cherokee Forum   05-15-2020, 07:48 PM
Replies: 24
Views: 1,408
Posted By CarlJH
Autels aren't good on early Chryslers, once you...

Autels aren't good on early Chryslers, once you get past 2005 there a lot better, maybe look into the Launch range of scanners as well, similar Android based system.
If you've ever watched Eric O's...
Jeep Forums: WJ Grand Cherokee Forum   05-15-2020, 07:23 AM
Replies: 8
Views: 324
Posted By CarlJH
If its never been apart before you will need a...

If its never been apart before you will need a good quality 1/2 inch breaker bar, with 15+ years corrosion its going to be a lot tighter than 175 lb/ft.
impact tools are a lot better as it shocks...
Jeep Forums: WJ Grand Cherokee Forum   05-15-2020, 07:16 AM
Replies: 5
Views: 197
Posted By CarlJH
also remember the cv axle holds the wheel bearing...

also remember the cv axle holds the wheel bearing together, that's why the hub nut is torqued to 175 lb/ft.
Jeep Forums: WJ Grand Cherokee Forum   05-14-2020, 06:00 PM
Replies: 49,582
Views: 4,610,617
Posted By CarlJH
the rest of the bodywork back there is in pretty...

the rest of the bodywork back there is in pretty good condition for a 17 year old vehicle, the three nuts and bolts all came out without a fight, not that I needed to undo them to get it out! it just...
Jeep Forums: WJ Grand Cherokee Forum   05-14-2020, 04:12 PM
Replies: 49,582
Views: 4,610,617
Posted By CarlJH
a bit of rust damage.....

Today's job, evap canister bracket
Jeep Forums: WJ Grand Cherokee Forum   05-13-2020, 11:25 AM
Replies: 10
Views: 359
Posted By CarlJH
change them and also check/adjust the bands as...

change them and also check/adjust the bands as the rear can only be done with the pan off, if the governor/pressure transducer is not letting it building the pressure it won't change up, when mine...
Jeep Forums: WJ Grand Cherokee Forum   05-05-2020, 08:45 AM
Replies: 61
Views: 2,167
Posted By CarlJH
When I replaced all the bushings at the back, I...

When I replaced all the bushings at the back, I took one look at those bolts and thought NO! leave well alone till you have to really have to change them.
Jeep Forums: WJ Grand Cherokee Forum   05-01-2020, 07:23 PM
Replies: 13
Views: 4,345
Posted By CarlJH
I'd get the green crusties sorted on those wires...

I'd get the green crusties sorted on those wires soon as well.
Jeep Forums: WJ Grand Cherokee Forum   04-27-2020, 08:03 PM
Replies: 4
Views: 284
Posted By CarlJH
I'll second the need for a genuine Mopar hose, I...

I'll second the need for a genuine Mopar hose, I tried a Crown one and the hose across the top was too long so nothing would line up when I tried it. The fitting into the bottom of the hydro fan just...
Jeep Forums: WJ Grand Cherokee Forum   04-25-2020, 11:25 AM
Replies: 5
Views: 139
Posted By CarlJH
just buy a hose that comes with a new bracket...

just buy a hose that comes with a new bracket like this one...
Jeep Forums: WJ Grand Cherokee Forum   04-23-2020, 08:24 PM
Replies: 2
Views: 219
Posted By CarlJH
found these on UK Ebay,...

found these on UK Ebay,...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome