JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 25
Search took 0.01 seconds.
Search: Posts Made By: Nic
Jeep Forums: Engines & Drivetrain   07-25-2016, 11:31 AM
Replies: 0
Views: 420
Posted By Nic
Diagnosing Grind Noise in 4L

Hi Jeepforum. I have a 1995 Jeep YJ SOA, 33's, 5spd with 8.8 rear, NP231 w/ SYE.
Recently when I have been doing light rock crawling I have been experiencing intermittent "Grinding" or "Scraping"...
Jeep Forums: YJ Wrangler Technical Forum   08-15-2013, 10:57 PM
Replies: 13
Views: 921
Posted By Nic
Re indexed the speedo gear and the speedo is now...

Re indexed the speedo gear and the speedo is now functioning. Went for a drive and didnt expirence any stalling. Hopefully that did the trick. Thanks for the help! Much appreciated. -Nic
Jeep Forums: YJ Wrangler Technical Forum   08-15-2013, 09:48 PM
Replies: 13
Views: 921
Posted By Nic
Thank you for the quick reply. This is...

Thank you for the quick reply. This is interesting! I didnt think that would cause this issue. Is it actually possible to install the speedo sleeve on backwards on the sye shaft? If so is there...
Jeep Forums: YJ Wrangler Technical Forum   08-15-2013, 09:28 PM
Replies: 13
Views: 921
Posted By Nic
Only managed to find the typical codes: 12, 33,...

Only managed to find the typical codes: 12, 33, 15, 55. I currently have no speedometer because I believe when I installed the new sye I put the new speedo sleeve on backwards. Thanks - Nic
Jeep Forums: YJ Wrangler Technical Forum   08-15-2013, 06:47 PM
Replies: 13
Views: 921
Posted By Nic
I was just looking at my 4x4 actuator lines and...

I was just looking at my 4x4 actuator lines and the vacuum plugs appear to be not on 100% due the enlarged size of the soa spring plates. could this cause the stall only when slowing down? when...
Jeep Forums: YJ Wrangler Technical Forum   08-15-2013, 06:35 PM
Replies: 13
Views: 921
Posted By Nic
4.0L stalling after rapid deceleration.

I recently did a spring over axle conversion to my 1995 Jeep YJ 5sp 4L. Along with the lift came some new 33" tires. Now it seems that most of the time when I have to slow from highway speeds...
Jeep Forums: TJ Wrangler Technical Forum   11-16-2012, 10:08 PM
Replies: 14
Views: 7,299
Posted By Nic
If you grab the top fin of your fan (with engine...

If you grab the top fin of your fan (with engine off), are you able to wiggle it up and down? This could mean its the water pump, I had a bad one and this gave it away pretty easily; however, I...
Jeep Forums: YJ Wrangler Technical Forum   11-16-2012, 06:57 PM
Replies: 5
Views: 488
Posted By Nic
Joker is right, a car with that few miles very...

Joker is right, a car with that few miles very well could have been sitting for extended periods time, this could lead to rust forming. Be sure to ask for any receipts the owner may have from work...
Jeep Forums: YJ Wrangler Technical Forum   11-14-2012, 07:21 PM
Replies: 41
Views: 3,875
Posted By Nic
Yes the belt is taking the correct route. ...

Yes the belt is taking the correct route. Actually had it wrong at first because the PO had a very interesting but incorrect route that worked somehow. And I replaced the rad hoses when I was doing...
Jeep Forums: YJ Wrangler Technical Forum   11-14-2012, 08:31 AM
Replies: 41
Views: 3,875
Posted By Nic
I am actually on my third thermostat so I am also...

I am actually on my third thermostat so I am also alittle bit confused. I replaced it with a NAPA one yesterday that looked like a slightly different design (still 195*) but had the same results. I...
Jeep Forums: YJ Wrangler Technical Forum   11-13-2012, 11:16 PM
Replies: 41
Views: 3,875
Posted By Nic
Sorry I'm not quite familiar with this procedure....

Sorry I'm not quite familiar with this procedure. Disconnect the heater core hose (the one on top of the tstat housing) from the firewall and have to lead back into the water pump?
Jeep Forums: YJ Wrangler Technical Forum   11-13-2012, 07:58 PM
Replies: 41
Views: 3,875
Posted By Nic
Tried running the Jeep without the thermostat in...

Tried running the Jeep without the thermostat in it, it ran super cool, around 45*C. With out the tstat in it I could also see the coolant flowing through the radiator so I dont believe its clogged....
Jeep Forums: YJ Wrangler Technical Forum   11-12-2012, 06:42 PM
Replies: 41
Views: 3,875
Posted By Nic
Just replaced the water pump, still having the...

Just replaced the water pump, still having the overheating issue. Perhaps the rad is clogged.
Jeep Forums: YJ Wrangler Technical Forum   11-11-2012, 01:11 PM
Replies: 41
Views: 3,875
Posted By Nic
Fan clutch tested ok. Gonna replace water pump I...

Fan clutch tested ok. Gonna replace water pump I think. Could a small coolant leak cause this overheating? My driveway is currently covered in coolant from the flush but it looks like a small...
Jeep Forums: YJ Wrangler Technical Forum   11-11-2012, 10:59 AM
Replies: 41
Views: 3,875
Posted By Nic
Is the any more effective method of getting air...

Is the any more effective method of getting air out of the system? I've tried running it with the rad cap off for a few hours now on an off. While doing this I was also squeezing the top rad hose,...
Jeep Forums: YJ Wrangler Technical Forum   11-10-2012, 10:25 PM
Replies: 41
Views: 3,875
Posted By Nic
Just for fun I put in the old coolant sensor and...

Just for fun I put in the old coolant sensor and found that it reads around 90-95, normal running temperature. While the new one I just got from NAPA is reading 115 or higher. Not sure which one to...
Jeep Forums: YJ Wrangler Technical Forum   11-09-2012, 07:10 PM
Replies: 41
Views: 3,875
Posted By Nic
Replaced the rad cap but it didnt change...

Replaced the rad cap but it didnt change anything, still stuck in the same situation. I am getting alot of squealing from the belt, perhaps it has to be tightened?
Jeep Forums: YJ Wrangler Technical Forum   11-08-2012, 11:21 PM
Replies: 41
Views: 3,875
Posted By Nic
Also when the temp. gauge read around 115 C (well...

Also when the temp. gauge read around 115 C (well above correct temperature) after running for a bit I removed the Rad cap and there was no hiss or anything. Could the cap be bad and not holding...
Jeep Forums: YJ Wrangler Technical Forum   11-08-2012, 08:52 PM
Replies: 41
Views: 3,875
Posted By Nic
Checked the resistance at the sensor, was around...

Checked the resistance at the sensor, was around 270 ohms when engine temp. was around 100-110, which I think is around the appropriate amount. Replaced the thermostat and that didnt change...
Jeep Forums: YJ Wrangler Technical Forum   11-07-2012, 10:14 PM
Replies: 41
Views: 3,875
Posted By Nic
I just ran it for about an hour on and off. No...

I just ran it for about an hour on and off. No change in the overheating. I also burped the system and got out quite a bit of air. I think air might be getting into the cooling system but im not...
Showing results 1 to 20 of 25

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome