JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 59
Search took 0.01 seconds.
Search: Posts Made By: riverzj
Jeep Forums: Engines & Drivetrain   06-03-2019, 11:15 AM
Replies: 0
Views: 70
Posted By riverzj
1994ZJ-1997/8truck 5.9 swap

Long story short sourced a 5.9 motor and trans rebuilt..buddy bought truck to swap cummins in so he will have motor trans and harness’s. Apparently motor swaps is fine. Mess around with motor mounts...
Jeep Forums: ZJ Grand Cherokee Forum   05-15-2019, 06:26 PM
Replies: 1
Views: 325
Posted By riverzj
Stumped and broke

Hate to have another death wobble question but this one is..every single thing has been replaced on the front end. It still death wobbles but only above 40 and reliably in overdrive at 45+, but not...
Jeep Forums: ZJ Grand Cherokee Forum   05-04-2019, 08:42 PM
Replies: 10
Views: 469
Posted By riverzj
Check water pump, thermostat could be sticky, old...

Check water pump, thermostat could be sticky, old coolant/clogged radiator.


Sent from my iPhone using Tapatalk
Jeep Forums: ZJ Grand Cherokee Forum   05-04-2019, 06:22 PM
Replies: 7
Views: 302
Posted By riverzj
I’ve had to do it the hard way several times..get...

I’ve had to do it the hard way several times..get it to temp then wait for it to depressurize pull the cap off and bleed the air. The 5.2 always sucks to bleed..squeezing the upper hose can be a big...
Jeep Forums: ZJ Grand Cherokee Forum   05-01-2019, 04:17 AM
Replies: 3
Views: 213
Posted By riverzj
My friend has a 4.5” ome lift and 32x11.5” stt...

My friend has a 4.5” ome lift and 32x11.5” stt pros and only has had to trim the front facia but everything else clears. Offroad the tires will take off the inside mud plastic protectors during a...
Jeep Forums: ZJ Grand Cherokee Forum   03-14-2019, 04:02 PM
Replies: 8
Views: 389
Posted By riverzj
Fuel smell could be issue but dropping mpg...

Fuel smell could be issue but dropping mpg usually points to wheel bearing or brakes eating it.


Sent from my iPhone using Tapatalk
Jeep Forums: ZJ Grand Cherokee Forum   03-07-2019, 11:46 AM
Replies: 1
Views: 139
Posted By riverzj
Rip tranny

I got a 94 ZJ with the 5.2 and the 46RH. The tranny gotta lotta metal in it. My question is what brands of reman transmissions have people had experience with? Going to be pricing out reman v...
Jeep Forums: ZJ Grand Cherokee Forum   02-03-2019, 12:08 AM
Replies: 4
Views: 220
Posted By riverzj
Rear hatch will probably be the black...

Rear hatch will probably be the black bushings-called like gate stops or something, about 3/4 of the way up on the side of gate, they just slip on to a metal post


Sent from my iPhone using...
Jeep Forums: ZJ Grand Cherokee Forum   01-22-2019, 05:36 PM
Replies: 11
Views: 609
Posted By riverzj
What kg6 said Sent from my iPhone using...

What kg6 said


Sent from my iPhone using Tapatalk
Jeep Forums: ZJ Grand Cherokee Forum   01-14-2019, 06:10 PM
Replies: 14
Views: 580
Posted By riverzj
Idk. I'm sure acetone would do the trick if you...

Idk. I'm sure acetone would do the trick if you wanted to change colors, depending on the liner. Wouldn't be fun tho


Sent from my iPhone using Tapatalk
Jeep Forums: ZJ Grand Cherokee Forum   01-14-2019, 05:18 PM
Replies: 14
Views: 580
Posted By riverzj
https://uploads.tapatalk-cdn.com/20190115/60d80951...

https://uploads.tapatalk-cdn.com/20190115/60d8095190e3fd58ed043f9667689065.jpghttps://uploads.tapatalk-cdn.com/20190115/2106af9aa5d2cd82c3c00874d1e70848.jpg
Black is just rustoleom paint sprayed and...
Jeep Forums: ZJ Grand Cherokee Forum   01-14-2019, 04:25 PM
Replies: 14
Views: 580
Posted By riverzj
I pulled rear and front facia then taped off...

I pulled rear and front facia then taped off doors to paint claddings. Sprayed on paint with a gun and air compressor, just used rustoleom, buddy of mine did a fine bed liner. Both sprayed on both...
Jeep Forums: ZJ Grand Cherokee Forum   12-03-2018, 05:08 PM
Replies: 3
Views: 219
Posted By riverzj
Fuel pressure regulator fixed my issue, and...

Fuel pressure regulator fixed my issue, and sounds like it could be yours due to problem only being at idle. Could be iac


Sent from my iPhone using Tapatalk
Jeep Forums: ZJ Grand Cherokee Forum   12-02-2018, 03:36 PM
Replies: 46
Views: 2,277
Posted By riverzj
Run some flush cleaner through your coolant might...

Run some flush cleaner through your coolant might help but it's probably gonna be your heater core. Mine sucks and I've done everything besides that and it was the problem in my xj as well had to...
Jeep Forums: ZJ Grand Cherokee Forum   10-29-2018, 04:54 PM
Replies: 4
Views: 228
Posted By riverzj
I had hesitation at idle and drop in rpms after...

I had hesitation at idle and drop in rpms after reving and letting off the gas. FPR (fuel pressure regulator) was the cause. I would say that sounds like injectors fuel not being able to get in there...
Jeep Forums: ZJ Grand Cherokee Forum   10-14-2018, 05:13 PM
Replies: 5
Views: 449
Posted By riverzj
https://uploads.tapatalk-cdn.com/20181014/4406ddc4...

https://uploads.tapatalk-cdn.com/20181014/4406ddc49675cc3ef044b2007ee4f37c.gif


Sent from my iPhone using Tapatalk
Jeep Forums: ZJ Grand Cherokee Forum   10-06-2018, 04:06 PM
Replies: 15
  shocks
Views: 694
Posted By riverzj
Doesn't matter. People mount the chamber up so it...

Doesn't matter. People mount the chamber up so it doesn't get dented or smacked on rocks. Only matters if the mounting points are different


Sent from my iPhone using Tapatalk
Jeep Forums: ZJ Grand Cherokee Forum   09-29-2018, 01:12 PM
Replies: 7
Views: 270
Posted By riverzj
The only thing holding it from moving left or...

The only thing holding it from moving left or right


Sent from my iPhone using Tapatalk
Jeep Forums: ZJ Grand Cherokee Forum   09-29-2018, 12:42 PM
Replies: 7
Views: 270
Posted By riverzj
*really a lot. Also if you do that double shear...

*really a lot. Also if you do that double shear up top, if you have the stock 30 I'd look into beefing up that axle side bracket. Those 2 holes especially when you bore one out for a bigger bolt can...
Jeep Forums: ZJ Grand Cherokee Forum   09-29-2018, 12:37 PM
Replies: 7
Views: 270
Posted By riverzj
Yeah, there's not really a lot of force on the...

Yeah, there's not really a lot of force on the bar or bracket. As long as the nuts don't back off you should be good. What're you doing to match the draglink angle to the track?


Sent from my...
Showing results 1 to 20 of 59

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome