JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.07 seconds.
Search: Posts Made By: mukluk
Jeep Forums: TJ Wrangler Technical Forum   11-14-2019, 09:52 PM
Replies: 1
Views: 89
Posted By mukluk
High idle speed is often due to vacuum leaks on...

High idle speed is often due to vacuum leaks on the intake side of the engine. With the engine running, spray short bursts of sensor safe carb/intake cleaner at all mating surfaces, vacuum...
Jeep Forums: TJ Wrangler Technical Forum   11-14-2019, 09:34 PM
Replies: 2
Views: 231
Posted By mukluk
Might be worthwhile to pose your question to the...

Might be worthwhile to pose your question to the seat cover manufacturer.
Jeep Forums: TJ Wrangler Technical Forum   11-14-2019, 09:31 PM
Replies: 3
Views: 174
Posted By mukluk
The P020x series fault codes are basically...

The P020x series fault codes are basically telling you the PCM isn't sensing that the injectors are firing properly on those cylinders. You should inspect the wiring for the injectors on the...
Jeep Forums: Engines & Drivetrain   11-14-2019, 05:13 PM
Replies: 3
Views: 322
Posted By mukluk
I'd add check the wiring for excessive resistance...

I'd add check the wiring for excessive resistance or loose terminal connections, and monitor the cam sensor signal with a DRBIII or oscilloscope during startup and initial cold operation.
Jeep Forums: Engines & Drivetrain   11-13-2019, 07:37 PM
Replies: 8
Views: 285
Posted By mukluk
ECT = Engine Coolant Temperature You might...

ECT = Engine Coolant Temperature

You might want to check for exhaust leaks at the manifold and near the upstream o2 sensor as these can cause the sensor to send a false lean signal to the computer...
Jeep Forums: TJ Wrangler Technical Forum   11-13-2019, 05:02 PM
Replies: 6
Views: 301
Posted By mukluk
The Rubicon t-case uses a variable resistance...

The Rubicon t-case uses a variable resistance sensor versus the 231's simple open/closed switch. Based on the signal value through the 241's sensor, the Jeep will determine what range the t-case is...
Jeep Forums: TJ Wrangler Technical Forum   11-13-2019, 03:13 PM
Replies: 6
Views: 301
Posted By mukluk
I'm not following the desire to swap out the...

I'm not following the desire to swap out the 241OR with a 231, my thought being if 1st gear low range is too deep then just shift the transmission into a higher gear. Doesn't make much sense to me...
Jeep Forums: TJ Wrangler Technical Forum   11-13-2019, 02:32 PM
Replies: 67
Views: 13,404
Posted By mukluk
EricD Yes, you'd need to provide an AC request...

EricD
Yes, you'd need to provide an AC request signal to the PCM to engage the compressor in non-AC modes. The easiest way to do this would be to connect your aftermarket select switch directly to...
Jeep Forums: TJ Wrangler Technical Forum   11-13-2019, 02:22 PM
Replies: 15
Views: 782
Posted By mukluk
Ah, now we can see what the filter mesh looks...

Ah, now we can see what the filter mesh looks like. :wink2:
Looks like it'd be handy for folks that park under trees.
Jeep Forums: Audio, CB & Ham Radios, GPS, & Electrical   11-12-2019, 10:34 PM
Replies: 20
Views: 473
Posted By mukluk
Unplug both stock headlamp connectors from both...

Unplug both stock headlamp connectors from both aftermarket headlamp pigtails. Use a meter or test lamp to verify you have good continuity to ground at the black wire, power at the violet/white wire...
Jeep Forums: TJ Wrangler Technical Forum   11-12-2019, 09:03 PM
Replies: 4
Views: 181
Posted By mukluk
Could also be the 3-4 shift fork broke or came...

Could also be the 3-4 shift fork broke or came loose on the shift rail. Regardless, losing just 3rd and 4th gear means the transmission needs to come out and be torn down to determine the cause.
Jeep Forums: Engines & Drivetrain   11-12-2019, 03:06 PM
Replies: 3
Views: 322
Posted By mukluk
What code is being thrown that causing the CEL to...

What code is being thrown that causing the CEL to illuminate? If it's P0016, you should be able to fix this by reclocking the OPDA to get the CKS/CPS sensor synch in range when it's cold.
Jeep Forums: Audio, CB & Ham Radios, GPS, & Electrical   11-12-2019, 02:31 PM
Replies: 20
Views: 473
Posted By mukluk
A bad alternator won't create problems with just...

A bad alternator won't create problems with just your headlights and dash lights, you would also have voltage readings that are out of range and fault codes being thrown.

If you look at the wire...
Jeep Forums: Audio, CB & Ham Radios, GPS, & Electrical   11-11-2019, 04:32 PM
Replies: 20
Views: 473
Posted By mukluk
Do you have a picture or part number of the MFS...

Do you have a picture or part number of the MFS you used? Is the Jeep modified or possibly a non-US market vehicle?
Jeep Forums: Wrangler General Discussion   11-11-2019, 04:28 PM
Replies: 8
Views: 342
Posted By mukluk
I drove through there about twenty years ago in a...

I drove through there about twenty years ago in a stock '68 Beetle, you'll be perfectly fine in your Jeep. Best advice I can give is don't be in a hurry, downshift and use your gearing to minimize...
Jeep Forums: TJ Wrangler Technical Forum   11-11-2019, 04:08 PM
Replies: 6
Views: 249
Posted By mukluk
Try two things to see if either gets the engine...

Try two things to see if either gets the engine to start: unplug the crank sensor plug, clean the terminals with spray contact cleaner, then firmly reconnect the plug; hold the throttle pedal down...
Jeep Forums: Audio, CB & Ham Radios, GPS, & Electrical   11-11-2019, 02:08 PM
Replies: 20
Views: 473
Posted By mukluk
The beam selector switch is internal to the left...

The beam selector switch is internal to the left MFS, yes.
Jeep Forums: Audio, CB & Ham Radios, GPS, & Electrical   11-11-2019, 01:33 AM
Replies: 20
Views: 473
Posted By mukluk
Sounds like the beam selector switch in the left...

Sounds like the beam selector switch in the left MFS is bad.

You can rule out a bad fuse or shorted wire because both the high and the low beams will work, albeit not correctly. The only item...
Jeep Forums: TJ Wrangler Technical Forum   11-10-2019, 09:40 PM
Replies: 8
Views: 411
Posted By mukluk
Crown and Omix-ADA both make quite a few...

Crown and Omix-ADA both make quite a few replacement parts for Jeeps that are NLA from the factory. Like so many things aftermarket though, quality varies.
Jeep Forums: Engines & Drivetrain   11-10-2019, 08:09 PM
Replies: 4
Views: 226
Posted By mukluk
The coil should have an electrical plug attached;...

The coil should have an electrical plug attached; one wire in the plug is the power wire, usually orange with or without another colour tracer, and the other will be the coil driver wire. When you...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome