JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 98
Search took 0.01 seconds.
Search: Posts Made By: bartimusmaximus
Jeep Forums: Advanced Jeep Tech   07-28-2021, 05:48 AM
Replies: 3
Views: 932
Posted By bartimusmaximus
I didn't have a choice really. Tom woods wouldn't...

I didn't have a choice really. Tom woods wouldn't build me a shaft with the angles I was at. The core 44 rear axle takes up alot more space and has a longer pinion. The only way I can move it back is...
Jeep Forums: General Jeep & Off-Road Equipment   07-27-2021, 10:20 AM
Replies: 14
Views: 802
Posted By bartimusmaximus
The pinion moves within that same tolerance. I...

The pinion moves within that same tolerance. I decided to call g2 yesterday. I explained to Tom that I have a new waggy 44 front with the exact same g2 gears and eaton E-Locker in it that I use 1...
Jeep Forums: General Jeep & Off-Road Equipment   07-26-2021, 02:30 PM
Replies: 14
Views: 802
Posted By bartimusmaximus
jeepdaddy2000 ring gear back lash is 0.008

jeepdaddy2000 ring gear back lash is 0.008
Jeep Forums: General Jeep & Off-Road Equipment   07-26-2021, 02:05 PM
Replies: 14
Views: 802
Posted By bartimusmaximus
jeepdaddy2000 I'm headed out there this evening...

jeepdaddy2000 I'm headed out there this evening to check it. I forgot to mention that I removed the brakes and it was still hard to rotate the pinion. The axles rotate fairly easy.. but the yoke...
Jeep Forums: General Jeep & Off-Road Equipment   07-25-2021, 01:20 PM
Replies: 14
Views: 802
Posted By bartimusmaximus
jeepdaddy2000 I'll do that next and report back.....

jeepdaddy2000 I'll do that next and report back.. Thank you
Jeep Forums: General Jeep & Off-Road Equipment   07-25-2021, 01:17 PM
Replies: 14
Views: 802
Posted By bartimusmaximus
I can not rotate the yoke without a huge Cresent...

I can not rotate the yoke without a huge Cresent wrench. It doesn't turn smooth either. It slips every once and a while. Would the fact it's never been oiled cause this issue? Because it was shipped...
Jeep Forums: General Jeep & Off-Road Equipment   07-25-2021, 11:29 AM
Replies: 14
Views: 802
Posted By bartimusmaximus
[QUOTE=jeepdaddy2000;41320549]LS? are both tires...

[QUOTE=jeepdaddy2000;41320549]LS? are both tires off the ground?
Can you pull the axles and check the pinion rotational torque again?

Can you post pictures of your diff?
Sounds a lot like a...
Jeep Forums: General Jeep & Off-Road Equipment   07-25-2021, 11:02 AM
Replies: 14
Views: 802
Posted By bartimusmaximus
CJ7-Tim the closest one is an hour north of me. I...

CJ7-Tim the closest one is an hour north of me. I have all the special tools required to swap out a ring and pinion. I have no experience with this axle. There are no shims. If I had a manual I'd...
Jeep Forums: General Jeep & Off-Road Equipment   07-24-2021, 09:09 AM
Replies: 14
Views: 802
Posted By bartimusmaximus
G2 Core 44 owners manual?

Is there such a thing? I bought a complete rear axle and it's got adjusters on it to change bearing preload and pinion depth and all kinds of cool crap but no paper work telling you what does what or...
Jeep Forums: Full Size Jeep Forum   07-19-2021, 03:21 AM
Replies: 2
Views: 307
Posted By bartimusmaximus
Thanks!

Thanks!
Jeep Forums: Full Size Jeep Forum   07-18-2021, 10:18 PM
Replies: 2
Views: 307
Posted By bartimusmaximus
85 Grand wagoneer front brake job help

I purchased a front axle out of a 85 grand wagoneer and it doesn't have any of the braking components on it. I purchased new calipers and pads and for the life of me I can't figure out where the...
Jeep Forums: Advanced Jeep Tech   07-04-2021, 09:11 AM
Replies: 3
Views: 932
Posted By bartimusmaximus
So far my options are lowering my skid plate with...

So far my options are lowering my skid plate with some 1.5"h x 3""w x 1/4" T c channel I have, using the same c channel to make new frame side motor mounts 2" forward and 1" taller, put the gas tank...
Jeep Forums: Advanced Jeep Tech   07-03-2021, 03:44 PM
Replies: 3
Views: 932
Posted By bartimusmaximus
Does a steep angled drive shaft exist? Tummy tuck problems

I just did a tummy tuck and I need a drive shaft that works at steep angles. I've tried everything to get mine within requirements needed with no luck. I can't even bolt it on because the angle is so...
Jeep Forums: Street Jeep Forum   07-01-2021, 12:13 PM
Replies: 3
Views: 1,089
Posted By bartimusmaximus
ok. Thanks. Is it possible to install this switch...

ok. Thanks. Is it possible to install this switch with a 32rh from.a 87 yj that has no electronics? Or do I need to find a newer version to do this?
Jeep Forums: Street Jeep Forum   05-30-2021, 07:55 PM
Replies: 3
Views: 1,089
Posted By bartimusmaximus
Lllneed advice on making a 32rh engine brake like a manual

I have a 01 tj with 4.0 and 89 32rh. I want to be able to use my engine and gearing when traveling down steep hills to go slow instead of using my breaks. In the same manner you can use a manual...
Jeep Forums: TJ Wrangler Technical Forum   05-05-2021, 07:42 AM
Replies: 7
Views: 975
Posted By bartimusmaximus
The 32RH's lockup torque converter won't operate...

The 32RH's lockup torque converter won't operate on the '04 (due to the '04 PCM not having that output signal) but that's not a big deal other than the transmission will run hotter and you won't get...
Jeep Forums: Suspension Parts   05-04-2021, 06:50 AM
Replies: 2
Views: 747
Posted By bartimusmaximus
Does it come with shocks

Does it come with shocks
Jeep Forums: TJ Wrangler   03-29-2021, 07:41 AM
Replies: 0
Views: 264
Posted By bartimusmaximus
which jeep should i build for offroad adventures use for

im wanting to build a tj for the rocks and need some advice on which jeep i should use and what my money needs to go to. I have a bone stock 01 TJ with a blown 4.0 and a 5spd has hardtop and a solid...
Jeep Forums: TJ Wrangler   03-29-2021, 07:07 AM
Replies: 0
Views: 190
Posted By bartimusmaximus
highline fender question

does anybody know what company has a highline front fender that starts with a negitive flare upfront and tapers to at least a 3" in tge back? I know someone makes it but i cant figure out who does
Jeep Forums: Engines & Drivetrain   03-14-2021, 06:46 PM
Replies: 0
Views: 323
Posted By bartimusmaximus
Wht year flex plate needed a999 swap

I have a 04 tj x with a 5spd and I'm swapping in a a999 from a 89 yj. Could someone tell me If I need a flex plate from a 97-02 tj or do I need one from the yj?
Showing results 1 to 20 of 98

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome