JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.03 seconds.
Search: Posts Made By: Jonny Jeep
Jeep Forums: TJ Wrangler Technical Forum   11-29-2021, 02:02 PM
Replies: 91
Views: 107,445
Posted By Jonny Jeep
Hi TJosh02, I had a couple of problems...

Hi TJosh02,


I had a couple of problems with my Dorman actuator pin. First problem was that the plastic rod running through the Dorman replacement was longer that that in the original. To fix...
Jeep Forums: TJ Wrangler Technical Forum   11-18-2021, 01:49 PM
Replies: 4
Views: 642
Posted By Jonny Jeep
Headlights are on a different fuse to the parking...

Headlights are on a different fuse to the parking lights and route through the turnsignal switch for the high beam. Check fuse 10 (30A) under the hood.
For the fog and parking light, check/clean the...
Jeep Forums: TJ Wrangler Technical Forum   11-18-2021, 01:39 PM
Replies: 20
Views: 2,379
Posted By Jonny Jeep
Looking at the wiring I don't think the A and E...

Looking at the wiring I don't think the A and E wires needed changing. In 97 the A wire isn't needed as the E wire in 97 is the blower motor feed, but is wired directly to the low speed of the blower...
Jeep Forums: TJ Wrangler Technical Forum   11-06-2021, 11:27 AM
Replies: 6
Views: 1,247
Posted By Jonny Jeep
I honestly thought the ignition switch would be...

I honestly thought the ignition switch would be the problem. I have replaced my ignition barrel, actuator pin and switch at different point about 2-3 years ago. My barrel was worn and I think it was...
Jeep Forums: TJ Wrangler Technical Forum   10-31-2021, 03:36 PM
Replies: 2
Views: 378
Posted By Jonny Jeep
On TJs the wires would be 18G for the tan, green...

On TJs the wires would be 18G for the tan, green and black wires and 20G for the blue.
Jeep Forums: TJ Wrangler Technical Forum   10-31-2021, 03:21 PM
Replies: 4
Views: 991
Posted By Jonny Jeep
The two connectors are for the auto transmission...

The two connectors are for the auto transmission neutral safety switch (fitted with cover, and obviously not used on a manual transmission vehicle) and the downstream O2 sensor.
Jeep Forums: TJ Wrangler Technical Forum   10-29-2021, 12:41 PM
Replies: 3
Views: 925
Posted By Jonny Jeep
I think the only seal that would be in that front...

I think the only seal that would be in that front corner is the windshield header seal which runs across the top of the windshield frame.


99 parts list attached, look in body sheet metal section
Jeep Forums: TJ Wrangler Technical Forum   10-28-2021, 12:58 PM
Replies: 16
Views: 2,352
Posted By Jonny Jeep
Pretty much as Boogieman states, the springs are...

Pretty much as Boogieman states, the springs are considered to be pretty good. The rest is crap. I fitted one of those kits to my TJ about 19-20 years ago. It was all that was available in the UK in...
Jeep Forums: TJ Wrangler Technical Forum   10-27-2021, 02:33 PM
Replies: 6
Views: 1,247
Posted By Jonny Jeep
Radio and turn signal fuses are on the same...

Radio and turn signal fuses are on the same contacts at the ignition switch. As too are the wipers which probably wouldn't have worked either. A new ignition switch would fix that. I had wipers and...
Jeep Forums: TJ Wrangler Technical Forum   10-27-2021, 02:25 PM
Replies: 7
Views: 1,094
Posted By Jonny Jeep
If you are only getting 7-8V with your bridge...

If you are only getting 7-8V with your bridge rectifier circuit you have a bad ground, or a voltage drop on the positive side of the circuit. A bridge rectifier should only drop around 1V so even...
Jeep Forums: TJ Wrangler Technical Forum   10-27-2021, 02:10 PM
Replies: 16
Views: 2,352
Posted By Jonny Jeep
Those two bars highlighted in yellow are...

Those two bars highlighted in yellow are stabiliser bars for the track bar drop kit used on 20 year old Pro-Comp four inch lift kits. The drop pitman arm on the steering gear matches the drop on the...
Jeep Forums: TJ Wrangler Technical Forum   10-25-2021, 01:50 PM
Replies: 6
Views: 508
Posted By Jonny Jeep
On TJ engines you will also find the last eight...

On TJ engines you will also find the last eight digits of the VIN the engine was factory fitted to, are etched onto the flat surface that the dipstick support bolts to. It's between the #4 and 5...
Jeep Forums: TJ Wrangler Technical Forum   10-23-2021, 11:12 AM
Replies: 2
Views: 463
Posted By Jonny Jeep
This should help...

This should help...
Jeep Forums: TJ Wrangler Technical Forum   10-23-2021, 10:58 AM
Replies: 14
Views: 1,652
Posted By Jonny Jeep
The shrouds need to be removed from the steering...

The shrouds need to be removed from the steering column to access the clockspring C1 connector. The shrouds are held in place by three screws which are in recessed holes on the lower cover. I'm not...
Jeep Forums: TJ Wrangler Technical Forum   10-22-2021, 01:39 PM
Replies: 14
Views: 1,652
Posted By Jonny Jeep
These diagrams are for the airbag control module...

These diagrams are for the airbag control module and the yellow clockspring connector on the dash side of the clockspring.


If you were to unplug these and set the meter on the lowest resistance...
Jeep Forums: TJ Wrangler Technical Forum   10-22-2021, 12:48 PM
Replies: 1
Views: 523
Posted By Jonny Jeep
wrangler...

wrangler (https://***************.com/threads/how-to-install-a-gentex-177-compass-mirror-in-a-tj-lj.15323/)
tj...
Jeep Forums: TJ Wrangler Technical Forum   10-20-2021, 03:26 PM
Replies: 14
Views: 1,652
Posted By Jonny Jeep
The FSM shows two ground locations for the ACU....

The FSM shows two ground locations for the ACU. One is the mounting screws, the other is the ground wire going to the panel forward of the door hinge as I described above.


If you remove the...
Jeep Forums: TJ Wrangler Technical Forum   10-18-2021, 02:56 PM
Replies: 14
Views: 1,652
Posted By Jonny Jeep
I swapped my clockspring when I was having an...

I swapped my clockspring when I was having an intermittent light with no change. It wasn't until I got hold of a decent reader that I knew what the issue was.


I would honestly try and find a...
Jeep Forums: TJ Wrangler Technical Forum   10-17-2021, 05:10 PM
Replies: 11
Views: 1,349
Posted By Jonny Jeep
I've tried switching to trip meter and turning...

I've tried switching to trip meter and turning ignition off and back on with my 97 now.

Odometer display defaults to the total mileage display when ignition is turned on.
Jeep Forums: TJ Wrangler Technical Forum   10-16-2021, 02:59 PM
Replies: 11
Views: 1,349
Posted By Jonny Jeep
I've never noticed that on mine, probably because...

I've never noticed that on mine, probably because I normally just have the odometer reading displayed. I'm going to have to try turning my ignition off when the trip meter is showing now. just to see...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome