JeepForum.com - Search Results
JeepForum.com > Search Forums > Search Results
Advanced Search
Page 1 of 13 1 2 3 11 Last
Showing results 1 to 20 of 250
Search took 0.09 seconds. Search: Posts Made By: GOLDWING
Jeep Forums: ZJ Grand Cherokee Forum   12-07-2019, 07:24 PM
Replies: 7
Views: 284
Posted By GOLDWING
^^^^^I recommend that anyone with a ZJ having...

^^^^^I recommend that anyone with a ZJ having phantom random issues make sure that all engine bay grounds and battery connections are pristine and in A1 condition prior to replacing sensors and...
Jeep Forums: ZJ Grand Cherokee Forum   12-07-2019, 07:11 PM
Replies: 51,840
Views: 3,005,548
Posted By GOLDWING
I humbly disagree. My stock headlights were...

I humbly disagree. My stock headlights were operating on just over 11 volts due to voltage drop through lots of undersized wiring and several junctions and switches. I built my own relay harness and...
Jeep Forums: ZJ Grand Cherokee Forum   12-04-2019, 09:00 PM
Replies: 51,840
Views: 3,005,548
Posted By GOLDWING
Check the wiring between the door hinge point and...

Check the wiring between the door hinge point and the the body. Pull the rubber boot from the door to body back and look for breaks.

GW
Jeep Forums: ZJ Grand Cherokee Forum   12-04-2019, 11:51 AM
Replies: 18
Views: 616
Posted By GOLDWING
I suspect there's a bubble of air that you are...

I suspect there's a bubble of air that you are not getting out when you "bleed" the cooling system. I use a Lisle brand coolant funnel when I burp my coolant. I fill the funnel about 1/3 full after I...
Jeep Forums: ZJ Grand Cherokee Forum   12-03-2019, 10:20 PM
Replies: 1
Views: 232
Posted By GOLDWING
Charge the battery and disconnect it from the ZJ....

Charge the battery and disconnect it from the ZJ. Take a voltage reading with your DVM. Check the voltage a day later and if it is lower, have the battery load tested. If the voltage stays up,...
Jeep Forums: ZJ Grand Cherokee Forum   12-03-2019, 09:49 PM
Replies: 6
Views: 273
Posted By GOLDWING
^^^^This. Look by the cat near the front of...

^^^^This.
Look by the cat near the front of the rear driveshaft.

GW
Jeep Forums: ZJ Grand Cherokee Forum   12-03-2019, 09:39 PM
Replies: 14
Views: 327
Posted By GOLDWING
For threaded connections I use "Monster" brand...

For threaded connections I use "Monster" brand PTFE tape that I buy at my local Menards. Unlike regular teflon tape, it actually is reliable for keeping leaks from happening. I get paid for no leaks,...
Jeep Forums: ZJ Grand Cherokee Forum   12-02-2019, 01:25 AM
Replies: 57
Views: 2,771
Posted By GOLDWING
How about "Overpriced"? GW

How about "Overpriced"?

GW
Jeep Forums: ZJ Grand Cherokee Forum   11-27-2019, 11:57 PM
Replies: 51,840
Views: 3,005,548
Posted By GOLDWING
Nicely done! GW

Nicely done!

GW
Jeep Forums: ZJ Grand Cherokee Forum   11-27-2019, 01:50 PM
Replies: 21
Views: 584
Posted By GOLDWING
Is the rocker arm tight as in slack on the valve...

Is the rocker arm tight as in slack on the valve and push rod? Can you move it with your fingers? Can you post a pic or two?

GW
Jeep Forums: ZJ Grand Cherokee Forum   11-27-2019, 04:41 AM
Replies: 51,840
Views: 3,005,548
Posted By GOLDWING
[QUOTE=JColee;40803939]Alright, I’m still on my...

[QUOTE=JColee;40803939]Alright, I’m still on my quest to solve the dead spot in my steering. I’ve replaced the front hubs, I’ve replaced the trackbar, I’ve replaced the steering box with a reman from...
Jeep Forums: ZJ Grand Cherokee Forum   11-26-2019, 08:40 PM
Replies: 21
Views: 584
Posted By GOLDWING
That would indicate a bent pushrod, a broken...

That would indicate a bent pushrod, a broken valve spring or less likely a cam lobe that has flattened out somehow. Did you see any issue with #2?

GW
Jeep Forums: ZJ Grand Cherokee Forum   11-26-2019, 07:48 PM
Replies: 57
Views: 2,771
Posted By GOLDWING
https://live.staticflickr.com/65535/49130439617_96...

https://live.staticflickr.com/65535/49130439617_9677885553_b.jpg

The Green Laredo on the left was purchased 4 years ago for $450 minus the $100 visa for the hitch recall. I put in a 242 T/C and a...
Jeep Forums: ZJ Grand Cherokee Forum   11-26-2019, 07:20 PM
Replies: 57
Views: 2,771
Posted By GOLDWING
I have three '98s of my own and the wife has one....

I have three '98s of my own and the wife has one. They all run and drive great. I guess your either your brother did not know how to take care of his or he bought one that had been neglected.

BTW,...
Jeep Forums: ZJ Grand Cherokee Forum   11-24-2019, 05:37 PM
Replies: 4
Views: 179
Posted By GOLDWING
Since it is a "Hall effect" sensor there is no...

Since it is a "Hall effect" sensor there is no need for a magnet. a chisel or wrench will work fine.

GW
Jeep Forums: ZJ Grand Cherokee Forum   11-24-2019, 05:21 PM
Replies: 8
Views: 380
Posted By GOLDWING
[/B] Eric the car guy recommends "T-pins" to...

[/B]

Eric the car guy recommends "T-pins" to back probe wiring but I like the piercing probes I got for my power probe IV. https://live.staticflickr.com/65535/49118169713_d003e8f987_n.jpg

GW
Jeep Forums: ZJ Grand Cherokee Forum   11-22-2019, 09:29 PM
Replies: 19
Views: 1,868
Posted By GOLDWING
I bought my last np 242 for well under $100. What...

I bought my last np 242 for well under $100. What is your time worth?

GW
Jeep Forums: ZJ Grand Cherokee Forum   11-22-2019, 07:35 PM
Replies: 3
Views: 142
Posted By GOLDWING
As Wingless said, the IAC is suspect for the rpm...

As Wingless said, the IAC is suspect for the rpm change. A vacuum leak generally is constant whereas the IAC has a moving part that is affected by carbon or trash in the IAC port. You tube it and DO...
Jeep Forums: ZJ Grand Cherokee Forum   11-22-2019, 06:54 PM
Replies: 6
Views: 264
Posted By GOLDWING
NTK is OEM for our O2 sensors and is recommended...

NTK is OEM for our O2 sensors and is recommended highly. DO NOT bypass the cat.
JTECH would recommend reading all codes and I can't argue with the suggestion that he has not made yet.

GW
Jeep Forums: ZJ Grand Cherokee Forum   11-18-2019, 06:16 PM
Replies: 2
Views: 214
Posted By GOLDWING
When I bought my '98, the 249 had already broken...

When I bought my '98, the 249 had already broken the ring and pinion on the D30. In order to drive it I pulled out the diff carrier and removed the ring gear. I re-installed the carrier and axles and...
Showing results 1 to 20 of 250
Page 1 of 13 1 2 3 11 Last

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome
 
Terms of Use
Copyright
Privacy Policy