JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.05 seconds.
Search: Posts Made By: relgnarw
Jeep Forums: TJ Wrangler Technical Forum   12-26-2015, 06:10 AM
Replies: 19
Views: 1,047
Posted By relgnarw
My only advice would be to have someone help you...

My only advice would be to have someone help you when it comes time to remove and replace the head. It can be heavy and awkward and you could hurt your back. I speak from firsthand experience as I...
Jeep Forums: XJ Cherokee Technical Forum   11-22-2015, 08:23 AM
Replies: 0
Views: 581
Posted By relgnarw
Electrical problem

I removed the AC system from my 99 XJ and now have no electrical power at all. I used the doorman bypass pulley and everything was hunky dorey until I tried the HVAC system. I cycled the controls and...
Jeep Forums: TJ Wrangler Technical Forum   10-18-2015, 05:47 PM
Replies: 8
Views: 856
Posted By relgnarw
At least this wasn't a Hinkley thread.

At least this wasn't a Hinkley thread.
Jeep Forums: TJ Wrangler Technical Forum   09-18-2015, 08:34 AM
Replies: 17
Views: 1,415
Posted By relgnarw
[QUOTE=stripperguy;31954322]OK, here are a couple...

[QUOTE=stripperguy;31954322]OK, here are a couple of photos, I hope they're clear enough...

http://lh3.googleusercontent.com/--WGRabjdo2c/VfwB4BesGiI/AAAAAAAAQDA/Sit7FCW_hKM/s800-Ic42/DSC_5324.JPG...
Jeep Forums: XJ Cherokee Technical Forum   09-09-2015, 04:50 AM
Replies: 1
Views: 702
Posted By relgnarw
I thought it was a bolt on kit with no welding...

I thought it was a bolt on kit with no welding required. Did you print out the installation instructions? You will have to cut off and then grind smooth the lower control arm brackets. Everything...
Jeep Forums: Wrangler General Discussion   08-20-2015, 05:16 AM
Replies: 12
Views: 6,059
Posted By relgnarw
Just soak the pins for a few days with PB...

Just soak the pins for a few days with PB Blaster. Give it time and work with it and they will come loose.
Jeep Forums: Jeep Builds   08-01-2015, 05:50 AM
Replies: 56
Views: 8,398
Posted By relgnarw
It looks great!

It looks great!
Jeep Forums: Engines & Drivetrain   06-26-2015, 08:24 PM
Replies: 7
Views: 648
Posted By relgnarw
I think you might have better luck posting your...

I think you might have better luck posting your questions in the WJ section. They have a ton of knowledge on the 4.7 motor, maybe they can guide you on what to look for.
Jeep Forums: Engines & Drivetrain   06-25-2015, 06:37 PM
Replies: 7
Views: 648
Posted By relgnarw
Sure would if the oil was dripping onto the...

Sure would if the oil was dripping onto the exhaust manifold or the down pipes. If you are talking about white smoke and a burning oil smell coming from the tail pipe, then that is a different matter...
Jeep Forums: Engines & Drivetrain   06-22-2015, 03:27 AM
Replies: 7
Views: 648
Posted By relgnarw
I'm thinking it's the valve cover gasket.

I'm thinking it's the valve cover gasket.
Jeep Forums: TJ Wrangler Technical Forum   06-21-2015, 05:46 AM
Replies: 8
Views: 1,125
Posted By relgnarw
I bought these from Ebay. Ultra Car Care...

I bought these from Ebay. Ultra Car Care Products, great customer service, and good switches.
Jeep Forums: Engines & Drivetrain   06-19-2015, 11:28 PM
Replies: 8
Views: 615
Posted By relgnarw
OK, check the lower hose it could be collapsed...

OK, check the lower hose it could be collapsed and stopping coolant flow. Also how does the coolant look? Any oil in it or is it clean?
Jeep Forums: Wrangler General Discussion   06-19-2015, 04:24 AM
Replies: 14
Views: 2,463
Posted By relgnarw
Cool, don't forget to seal it up really well. You...

Cool, don't forget to seal it up really well. You don't want water in it.
Jeep Forums: Engines & Drivetrain   06-19-2015, 03:51 AM
Replies: 8
Views: 615
Posted By relgnarw
The pulley will still spin freely even though the...

The pulley will still spin freely even though the impeller is bad. Have you run it with the radiator cap removed? You should see some circulation in the radiator. I think that the water pump is the...
Jeep Forums: Engines & Drivetrain   06-18-2015, 06:29 PM
Replies: 8
Views: 615
Posted By relgnarw
I have heard of the impeller on the water pump...

I have heard of the impeller on the water pump going bad. The only way to check it would be to pull it and inspect it. If you pull it you might as well replace it and the T stat.
Jeep Forums: Wrangler General Discussion   06-18-2015, 09:31 AM
Replies: 14
Views: 2,463
Posted By relgnarw
Cool, thanks I wasn't sure and my notes are in my...

Cool, thanks I wasn't sure and my notes are in my garage.
Jeep Forums: Wrangler General Discussion   06-18-2015, 04:50 AM
Replies: 14
Views: 2,463
Posted By relgnarw
I bought a couple of the Amazon ones over the...

I bought a couple of the Amazon ones over the winter and just got around to installing one on my TJ. (The other one is for my girls XJ) From everything I read about those, people were saying to pull...
Jeep Forums: TJ Wrangler Technical Forum   06-17-2015, 02:58 AM
Replies: 9
Views: 773
Posted By relgnarw
Timken lists at 67.00 bones each. ...

Timken lists at 67.00 bones each.
http://www.rockauto.com/catalog/raframecatalog.php?make=JEEP&ck[ID]=0&ck[idlist]=0&ck[viewcurrency]=USD&ck[PHP_SESSION_ID]=4d9th73b3md79fo5p62l2sofb7
Jeep Forums: TJ Wrangler Technical Forum   06-07-2015, 12:33 PM
Replies: 16
Views: 1,285
Posted By relgnarw
I cant help but notice that the people telling...

I cant help but notice that the people telling you to leave them in are from states that don't use road salt. If you drive your Jeep in the winter and they use salt on the roads it will get behind...
Jeep Forums: TJ Wrangler Technical Forum   05-29-2015, 06:05 PM
Replies: 1
Views: 411
Posted By relgnarw
U-joints. Notice all of the rust around them.

U-joints. Notice all of the rust around them.
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome