JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.04 seconds.
Search: Posts Made By: Siva283
Jeep Forums: YJ Wrangler Technical Forum   11-13-2019, 11:30 AM
Replies: 12
Views: 285
Posted By Siva283
Well **** if we are going that route I would do...

Well **** if we are going that route I would do it for the spare room and air fair
Jeep Forums: YJ Wrangler Technical Forum   11-13-2019, 06:52 AM
Replies: 12
Views: 285
Posted By Siva283
Also you know its not as easy as just bolting the...

Also you know its not as easy as just bolting the new stuff on right?
New gears new set up. While not hard its not easy either and requires special tools
Jeep Forums: YJ Wrangler Technical Forum   11-11-2019, 11:47 AM
Replies: 103
Views: 2,300
Posted By Siva283
Sooo I just got off the phone with Dead Jeeps...

Sooo I just got off the phone with Dead Jeeps where I got the harness. Amazing customer service I explained what I am seeing and before I was halfway through they issued a return label and were...
Jeep Forums: YJ Wrangler Technical Forum   11-09-2019, 03:38 PM
Replies: 103
Views: 2,300
Posted By Siva283
So I tried test continuity from the connector to...

So I tried test continuity from the connector to the relay and got nothing. I found a diagram that matches the colors though the starter switch pin isn't in the right spot. If I jump 12v to the pin I...
Jeep Forums: YJ Wrangler Technical Forum   11-09-2019, 01:57 PM
Replies: 103
Views: 2,300
Posted By Siva283
Well now I'm waiting to hear back from dead jeeps...

Well now I'm waiting to hear back from dead jeeps on eBay. The harness has the speed sensor circuit at the sensor and the starter circuit at the pdc but both are missing at the bulk head connector...
Jeep Forums: YJ Wrangler Technical Forum   11-09-2019, 11:10 AM
Replies: 103
Views: 2,300
Posted By Siva283
That's my current method but when I have kids in...

That's my current method but when I have kids in the jeep it's frowned upon.

Who needs a horn? There is a finger on both of my hands that replaces it.....[/QUOTE]

Check for voltage before you...
Jeep Forums: YJ Wrangler Technical Forum   11-08-2019, 02:12 PM
Replies: 103
Views: 2,300
Posted By Siva283
Just discovered I have no horn. So I guess I'll...

Just discovered I have no horn. So I guess I'll be tracing that out this weekend too
Jeep Forums: YJ Wrangler Technical Forum   11-08-2019, 08:38 AM
Replies: 103
Views: 2,300
Posted By Siva283
Dude you are awesome. Thank you this had the...

Dude you are awesome. Thank you this had the instructions on which wires and even how to move them. Looks like I have something else to do saturday
Jeep Forums: YJ Wrangler Technical Forum   11-08-2019, 07:54 AM
Replies: 103
Views: 2,300
Posted By Siva283
I do believe the harness is from a 94 or 95 so...

I do believe the harness is from a 94 or 95 so you are probably correct. I really suck with wiring hence why I decided to just replace the entire harness. I do know that I had to use the adapter that...
Jeep Forums: YJ Wrangler Technical Forum   11-07-2019, 05:34 PM
Replies: 103
Views: 2,300
Posted By Siva283
I guess it could also be nss but I thought you...

I guess it could also be nss but I thought you could bypass that by grounding pin 85 of the relay which didn't work
Jeep Forums: YJ Wrangler Technical Forum   11-07-2019, 05:24 PM
Replies: 103
Views: 2,300
Posted By Siva283
OK so I got it all done and she's running no...

OK so I got it all done and she's running no codes runs beautifully again. However I can only start it by jumping the relay for the starter. When I turn the key to start the radio and dash lights go...
Jeep Forums: YJ Wrangler Technical Forum   11-07-2019, 08:36 AM
Replies: 9
Views: 303
Posted By Siva283
There are much better options that are cheaper...

There are much better options that are cheaper than D44's for example the Ford 8.8 rear that gets you 4wheel disc brakes and most of us believe its stronger than a D44 for much less cost.
Jeep Forums: YJ Wrangler Technical Forum   11-07-2019, 08:27 AM
Replies: 15
Views: 403
Posted By Siva283
SOunds like your timing might be 180 out. Are you...

SOunds like your timing might be 180 out. Are you sure you were at TDC compression on cylinder one and not on the exhaust stroke.
Jeep Forums: YJ Wrangler Technical Forum   11-07-2019, 06:50 AM
Replies: 9
Views: 423
Posted By Siva283
As we All know the D35 is junk so of course you...

As we All know the D35 is junk so of course you should drop in a V8 or Cummins 4BT.....

I am surprised the V8 swap guys havent shown up yet.

WIth that said I would look harder for an 8.8 after...
Jeep Forums: YJ Wrangler Technical Forum   11-07-2019, 06:44 AM
Replies: 103
Views: 2,300
Posted By Siva283
Funny you should say that. I have Alt...

Funny you should say that.

I have Alt Positive and Ground going to the Battery with 2/0. Then I have 2/0 From Battery to Block and Battery to Body. I have 2/0 from frame to block. When I add the...
Jeep Forums: YJ Wrangler Technical Forum   11-06-2019, 10:36 AM
Replies: 91
Views: 3,793
Posted By Siva283
This sounds like a solid plan. Before spending to...

This sounds like a solid plan. Before spending to much on upgrades like front chromoloy shafts wheel it and see where the week spot is then upgrade.

As far as Battery I have used the walmart...
Jeep Forums: YJ Wrangler Technical Forum   11-06-2019, 10:31 AM
Replies: 103
Views: 2,300
Posted By Siva283
This is exactly what I am doing 2/0 welding cable...

This is exactly what I am doing 2/0 welding cable from Alt to Battery. The battery will feed the PDC not the alt. It made a difference when I did it this way on my other jeep. The battery removes AC...
Jeep Forums: YJ Wrangler Technical Forum   11-05-2019, 07:55 PM
Replies: 6
Views: 259
Posted By Siva283
Stirring up dirt in an oil system is never a good...

Stirring up dirt in an oil system is never a good idea.
Jeep Forums: YJ Wrangler Technical Forum   11-05-2019, 07:52 PM
Replies: 103
Views: 2,300
Posted By Siva283
Well the ecm won't be here till tomorrow. So I...

Well the ecm won't be here till tomorrow. So I got the old harness out and the new one 90% in. I need to drop the tank to run the fuel pump and gas gauge wires. I got 2 more grounds to hook up and I...
Jeep Forums: YJ Wrangler Technical Forum   11-05-2019, 08:13 AM
Replies: 103
Views: 2,300
Posted By Siva283
Well tonight starts the surgery I wil be pulling...

Well tonight starts the surgery I wil be pulling the old Harness and ECM out. If time permits I will get the replacements in. then I will spend the winter repairing the old harness and eithier...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome