JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 52
Search took 0.01 seconds.
Search: Posts Made By: Temujin
Jeep Forums: XJ Cherokee Technical Forum   08-23-2021, 07:51 PM
Replies: 8
Views: 1,010
Posted By Temujin
This is pretty obvious question but just in case...

This is pretty obvious question but just in case . Did you bleed the master cylinder?
Jeep Forums: ZJ Grand Cherokee Forum   08-21-2021, 10:18 PM
Replies: 8
Views: 681
Posted By Temujin
If your going to pull the heater box make sure...

If your going to pull the heater box make sure you have the to tool to open the safety springs on the ac lines. they are 2 different sizes. Thats the only specialty tools for the whole job. I bought...
Jeep Forums: ZJ Grand Cherokee Forum   08-21-2021, 09:38 AM
Replies: 8
Views: 681
Posted By Temujin
both refer to to much door travel so it would...

both refer to to much door travel so it would seem the the servo's are ok. I think the ac is bad and the door is stuck blocking the heat which is why you get no heat. that is just a guess. while...
Jeep Forums: ZJ Grand Cherokee Forum   08-20-2021, 10:24 AM
Replies: 8
Views: 681
Posted By Temujin
was going to upload but the site won't let me...

was going to upload but the site won't let me upload the images some thing about a security token. I guess they did up load lol
Jeep Forums: ZJ Grand Cherokee Forum   08-19-2021, 09:26 PM
Replies: 8
Views: 681
Posted By Temujin
I was going to look in my haynes manual and take...

I was going to look in my haynes manual and take a pic of the procedure if it was in there but I cant find it . I will look for it tomorrow when I get some decent light for the code procedure if its...
Jeep Forums: ZJ Grand Cherokee Forum   08-19-2021, 08:49 PM
Replies: 8
Views: 681
Posted By Temujin
Thats the fan motor wires. The plug on the right...

Thats the fan motor wires. The plug on the right is the blower motor resister. There is a plug up under there for it to plug into. Could be a real pain if the other end is loose.Might have to remove...
Jeep Forums: TJ Wrangler Technical Forum   08-19-2021, 02:02 PM
Replies: 7
Views: 763
Posted By Temujin
You could also go in threw the fill hole with a...

You could also go in threw the fill hole with a 10 dollar advance auto pump and pump out as much as you can then open the drain plug if there is no hole in the skip plate for the oil to drain. Then...
Jeep Forums: Cheap Tricks & Fixes   08-18-2021, 07:27 AM
Replies: 7
Views: 878
Posted By Temujin
I used this mix also in a pinch. The problem is...

I used this mix also in a pinch. The problem is acetone is combustible. Get it on paint, a seal or plastic is not good. If I have a real problem especially on longer studs with a nut I brush on...
Jeep Forums: Engines & Drivetrain   08-16-2021, 10:34 AM
Replies: 0
Views: 322
Posted By Temujin
bottom end rebuild

Have a 95 zj 4.0 242 . ive been reading around on crankshafts. Are the cranks all uniform for main bearings and rods or are they all different sizes ? I should have checked when the oil pan was off...
Jeep Forums: Engines & Drivetrain   08-13-2021, 03:47 PM
Replies: 6
Views: 491
Posted By Temujin
Ah on my 4.0 the fan is bolted to the pump in...

Ah on my 4.0 the fan is bolted to the pump in front of the pulley on studs. Do you have an electric fan? Any way that's what I thought he was talking about. A clutch fan usually is on the water pump....
Jeep Forums: Engines & Drivetrain   08-13-2021, 07:45 AM
Replies: 6
Views: 491
Posted By Temujin
what jeepdaddy is saying is the bolts that hold...

what jeepdaddy is saying is the bolts that hold the fan on are the same bolts that hold the pulley on. Starting it with the pulley not bolted down is asking for trouble. Actually on mine I have studs...
Jeep Forums: ZJ Grand Cherokee Forum   08-07-2021, 08:53 PM
Replies: 5
Views: 603
Posted By Temujin
You really need to have some drive with you that...

You really need to have some drive with you that has good ears and can get you close. They need to try and locate it while you drive. Sounds can be very deceptive. I would look at the molding or seal...
Jeep Forums: Wanted   08-03-2021, 10:13 AM
Replies: 2
Views: 192
Posted By Temujin
95 ZJ looking for lsd for the dana 35 first as I...

95 ZJ looking for lsd for the dana 35 first as I have a lunch box in the front dana 30. found quite a few on car parts I just have to call almost every last yard for fit and price. For what they want...
Jeep Forums: Advanced Jeep Tech   07-29-2021, 07:08 PM
Replies: 1
Views: 441
Posted By Temujin
I really should not be posting but lol. The...

I really should not be posting but lol. The yellow is to check the contact pattern of the gears them selves. To me the contact looks ok but I never seen a good pattern as an example on a axle . a lot...
Jeep Forums: Jeep CJ Forum   07-27-2021, 04:30 PM
Replies: 15
Views: 1,102
Posted By Temujin
A friend of mine had the same problem with his...

A friend of mine had the same problem with his cj-7. We use to take turns driving to work in it one week on and one week off. He bought it from a mechanic that did all sorts of things to it. 2 weeks...
Jeep Forums: ZJ Grand Cherokee Forum   07-27-2021, 03:42 PM
Replies: 4
Views: 471
Posted By Temujin
brand new high flow melling pump with new pickup....

brand new high flow melling pump with new pickup. I have a press so it was easy to attach ounce I got it into a position to press it on. Well I grabbed the pickup with a pair of vice grips in a cloth...
Jeep Forums: ZJ Grand Cherokee Forum   07-27-2021, 11:40 AM
Replies: 4
Views: 471
Posted By Temujin
The v8 exhaust that makes sense to me. The only...

The v8 exhaust that makes sense to me. The only thing I could not remember was if I torqued just the outward bolt on the oil pump. Then took an open end and applied pressure the that one bolt till...
Jeep Forums: ZJ Grand Cherokee Forum   07-27-2021, 11:23 AM
Replies: 2
Views: 343
Posted By Temujin
Thanks my man!

Thanks my man!
Jeep Forums: ZJ Grand Cherokee Forum   07-27-2021, 10:35 AM
Replies: 2
Views: 343
Posted By Temujin
tranny filler dipstick tube

I was wondering if some one with an FSM could give me the part number for the 0-ring on the filler tube for the tranny. I have a 95 zj 4.0 42re trans thanks in advance.
Jeep Forums: ZJ Grand Cherokee Forum   07-27-2021, 10:26 AM
Replies: 4
Views: 471
Posted By Temujin
oil pan gasket rear main seal replacement

I did some work on my zj 1995 4.0. I had a rear main seal leak oil pan needed a gasket and I wanted to replace the oil pump as I hit 180,000 miles
I read and watched all the videos on this....
Showing results 1 to 20 of 52

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome