JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 108
Search took 0.01 seconds.
Search: Posts Made By: Chiss
Jeep Forums: Jeep CJ Forum   07-18-2021, 11:53 PM
Replies: 27,664
Views: 2,297,279
Posted By Chiss
Better Picture

Better Picture
Jeep Forums: Jeep CJ Forum   07-18-2021, 11:38 PM
Replies: 27,664
Views: 2,297,279
Posted By Chiss
Wanted bumper to be Period Correct, Didn't like...

Wanted bumper to be Period Correct, Didn't like any of the New Bumpers to Thin. Maybe this Image will show better orientation, Boxed the Channel and 45 the Corners. It's hard to see in the Picture...
Jeep Forums: Jeep CJ Forum   07-18-2021, 02:05 PM
Replies: 6
Views: 977
Posted By Chiss
I purchased some M10 aluminum Lock nuts, which...

I purchased some M10 aluminum Lock nuts, which are about 4 Threads thin, work Great. The nuts are usually found around anything to do with Heims at suppliers.
Jeep Forums: Jeep CJ Forum   07-18-2021, 01:54 PM
Replies: 27,664
Views: 2,297,279
Posted By Chiss
Welded up a 1/4" x 10" channel to make a Bumper...

Welded up a 1/4" x 10" channel to make a Bumper for 12s.
Jeep Forums: Jeep CJ Forum   07-18-2021, 12:36 PM
Replies: 6
Views: 894
Posted By Chiss
To answer your Question you can, but as stated by...

To answer your Question you can, but as stated by the procedure "B" give you , no Fear of Crushing.
Jeep Forums: Jeep CJ Forum   07-15-2021, 11:25 PM
Replies: 6
Views: 903
Posted By Chiss
133" should be Plenty, My Factory Belts were...

133" should be Plenty, My Factory Belts were shorter than that. Mine are back in Factory Location own the B- Pillar. Contacted the Mentioned Company above after 3 weeks, They Sent out Another Set no...
Jeep Forums: Jeep CJ Forum   07-11-2021, 04:03 PM
Replies: 6
Views: 903
Posted By Chiss
1985 Cj7 Replacement Seatbelts

Bought a set off E-Pay advertised as 125" but were only 108", out $170, anybody know of a legitimate Source. These are the ones I Purchased, not even close. ...
Jeep Forums: Jeep CJ Forum   07-09-2021, 09:01 PM
Replies: 3
Views: 530
Posted By Chiss
Oil pan Gasket, one piece should replace this...

Oil pan Gasket, one piece should replace this piece, in other words remove it for the one piece.
Jeep Forums: Jeep CJ Forum   07-09-2021, 08:52 PM
Replies: 15
Views: 1,421
Posted By Chiss
Check the throttle Plate adjustments in the...

Check the throttle Plate adjustments in the Bottom of the Carb, when on the Idle the proper gap will let just enough air for the Idle Drips, if the mixture on the Idle is Off the Carb will Lean out...
Jeep Forums: Jeep CJ Forum   07-09-2021, 08:44 PM
Replies: 5
Views: 509
Posted By Chiss
If it's coming out of that Vent tube on the Front...

If it's coming out of that Vent tube on the Front your Float is set to High.........
Jeep Forums: Jeep CJ Forum   06-16-2021, 12:23 PM
Replies: 41
Views: 3,164
Posted By Chiss
Just for Giggles , Did a Little research, Every...

Just for Giggles , Did a Little research, Every Install I see has a Traditional Hard rubber mount on one end of the Spring. Thats what's keeping the Axle in Place.
Jeep Forums: Jeep CJ Forum   06-16-2021, 12:02 PM
Replies: 41
Views: 3,164
Posted By Chiss
You missing something, You should go back and...

You missing something, You should go back and look at a Toyota, Airbags on one end and Spherical on the other, You are not going to keep the *** end under the Jeep. Built a Load of Rear suspensions...
Jeep Forums: Jeep CJ Forum   06-15-2021, 12:23 PM
Replies: 41
Views: 3,164
Posted By Chiss
I don't see how those Orbitals can be Effective...

I don't see how those Orbitals can be Effective running a Shackle with no Center Support. The Independent Hangers give no Stability and just Lays to the side of the Jeep that is the Heaviest.
Jeep Forums: Jeep CJ Forum   06-15-2021, 12:48 AM
Replies: 41
Views: 3,164
Posted By Chiss
I'd be Looking for a Cracked Frame............Are...

I'd be Looking for a Cracked Frame............Are those Bushing's made out of Foam. Never saw Bushings give that much movement. Bolt Angles in Photo's the Bushings look like ****.
Jeep Forums: Jeep CJ Forum   06-11-2021, 12:10 AM
Replies: 27
Views: 2,779
Posted By Chiss
You can Adjust the Play out of a Manual Box, I...

You can Adjust the Play out of a Manual Box, I loosen Lock Nut and turn Screw an 1/8" at a Time while someone works Steering Wheel back and Forth. Never had one that wouldn't Tighten up. Once Play is...
Jeep Forums: Jeep CJ Forum   06-11-2021, 12:04 AM
Replies: 23
Views: 2,026
Posted By Chiss
Did you disconnect Ignition wiring from Old Carb...

Did you disconnect Ignition wiring from Old Carb Solenoid ?
Jeep Forums: Jeep CJ Forum   06-10-2021, 11:50 PM
Replies: 19
Views: 1,461
Posted By Chiss
Advance Timing a little

Advance Timing a little
Jeep Forums: Jeep CJ Forum   05-04-2021, 11:33 PM
Replies: 17
Views: 1,117
Posted By Chiss
Look @ my Tub Repairs in my Album you will see My...

Look @ my Tub Repairs in my Album you will see My Repairs.........If it will Help
Jeep Forums: Jeep CJ Forum   04-16-2021, 11:44 PM
Replies: 14
Views: 1,712
Posted By Chiss
If you Look up a Post of mine in 2020 Labeled "...

If you Look up a Post of mine in 2020 Labeled " Leaf Bushings" you will see mine With Hand Tool Built Shackles, Best Ride I ever had out of about 10 Cj's I've had. Got Tired of riding around with...
Jeep Forums: Jeep CJ Forum   04-16-2021, 11:30 PM
Replies: 15
Views: 1,445
Posted By Chiss
I Throw them away and use a Nut.......

I Throw them away and use a Nut.......
Showing results 1 to 20 of 108

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome