JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.50 seconds.
Search: Posts Made By: Berniebikes
Jeep Forums: YJ Wrangler Technical Forum   09-08-2016, 05:54 PM
Replies: 17
Views: 938
Posted By Berniebikes
If you want to keep the Silicone then use some...

If you want to keep the Silicone then use some adhesion promotor and spray with the rest of the roof. It will probably hold a season or two, but fail before you need to repaint. If you want a...
Jeep Forums: YJ Wrangler Technical Forum   06-09-2016, 06:07 AM
Replies: 18
Views: 942
Posted By Berniebikes
so how did things turn out?

so how did things turn out?
Jeep Forums: YJ Wrangler Technical Forum   06-06-2016, 06:30 PM
Replies: 18
Views: 942
Posted By Berniebikes
do yourself a favor and wire up a check engine...

do yourself a favor and wire up a check engine light. you can use a cheap radio shack led. Tap a positive wire off of your ignition 12v source and run your negative to pin A-5 on your ecm. That...
Jeep Forums: YJ Wrangler Technical Forum   06-06-2016, 06:02 PM
Replies: 18
Views: 942
Posted By Berniebikes
It should be a blue wire going to Pin D-16 on...

It should be a blue wire going to Pin D-16 on your ecm connector and a green wire going to pin D-14 on your ecm connector. just do a continuity check from the injector connector to the ecm...
Jeep Forums: YJ Wrangler Technical Forum   06-06-2016, 11:37 AM
Replies: 18
Views: 942
Posted By Berniebikes
you'll have two wires to each injector. One wire...

you'll have two wires to each injector. One wire will carry 12v and be connected to your 12v power supply. the other wire to the injector will connect to the ECM (one to pin D14, the other to pin...
Jeep Forums: YJ Wrangler Technical Forum   05-14-2016, 11:08 AM
Replies: 72
Views: 3,779
Posted By Berniebikes
so is everything up and running fine now?? How...

so is everything up and running fine now?? How do you like the system?
Jeep Forums: YJ Wrangler Technical Forum   05-08-2016, 02:46 PM
Replies: 72
Views: 3,779
Posted By Berniebikes
not sure what you are referring to. for the fuel...

not sure what you are referring to. for the fuel pump relay you should have the following connections:
Pin 85, connected to the green/white wire from the ECM pin A1
Pin 86, connect to chassis...
Jeep Forums: YJ Wrangler Technical Forum   05-01-2016, 03:08 PM
Replies: 72
Views: 3,779
Posted By Berniebikes
During the install process, once you have set...

During the install process, once you have set your dist. to 0 degrees at TDC, you will lock the mechanical advance plates inside the distributor (either by tack welding them or putting a screw into...
Jeep Forums: YJ Wrangler Technical Forum   05-01-2016, 10:05 AM
Replies: 72
Views: 3,779
Posted By Berniebikes
Set the timing to 0 before you begin doing any...

Set the timing to 0 before you begin doing any work. When you finish your install you will go through the initial startup procedures outlined here:...
Jeep Forums: YJ Wrangler Technical Forum   04-29-2016, 06:03 AM
Replies: 72
Views: 3,779
Posted By Berniebikes
A separate relay would work fine, but if you...

A separate relay would work fine, but if you follow the colored wiring diagram you really are running one relay powering the fuel pump and a second powers the ignition(minus a few miliamps to the...
Jeep Forums: YJ Wrangler Technical Forum   04-25-2016, 02:06 PM
Replies: 11
Views: 1,518
Posted By Berniebikes
The Howell system is an adaptation of the GM...

The Howell system is an adaptation of the GM Throttle Body system used nearly across the board on most gm vehicles from the mid/early 80s to the mid 90s. However, the Howell system is a "fuel" only...
Jeep Forums: YJ Wrangler Technical Forum   04-21-2016, 03:17 PM
Replies: 8
Views: 702
Posted By Berniebikes
If you buy it and need a fuel pump, I have a new...

If you buy it and need a fuel pump, I have a new mechanical one in my garage, yours for a beer (I'm 15 to 20 min away in Williamsburg). Send me a pm if interested.
Jeep Forums: YJ Wrangler Technical Forum   04-21-2016, 10:36 AM
Replies: 72
Views: 3,779
Posted By Berniebikes
Unless you have a HEI with coil you are going to...

Unless you have a HEI with coil you are going to use, probably the GM TBI Epoxy Core coil or the Ford TFI coil would be the ones to use. I think the Ford might have a bit of a hotter spark.
Jeep Forums: YJ Wrangler Technical Forum   04-21-2016, 05:50 AM
Replies: 72
Views: 3,779
Posted By Berniebikes
Voltagechecks.xls Look Here, about 3/4 of...

Voltagechecks.xls

Look Here, about 3/4 of the way down the page

http://www.binderplanet.com/forums/index.php?threads/gm-wiring-harness-octopus.45293/
Jeep Forums: YJ Wrangler Technical Forum   04-20-2016, 04:30 PM
Replies: 72
Views: 3,779
Posted By Berniebikes
My donor was an 88 S10 Blazer. I'm sure you will...

My donor was an 88 S10 Blazer. I'm sure you will be fine! Good job. Now time to prep the harness and get ready for install (plus gather whatever parts you don't have)! Once again I will suggest...
Jeep Forums: YJ Wrangler Technical Forum   04-20-2016, 10:29 AM
Replies: 72
Views: 3,779
Posted By Berniebikes
On the Binder Planet site there is a BCC list...

On the Binder Planet site there is a BCC list that you can use to find the car an ecm came from. Just get one from a 4.3 truck van or mini blazer and you should be fine.
Jeep Forums: YJ Wrangler Technical Forum   04-20-2016, 06:39 AM
Replies: 72
Views: 3,779
Posted By Berniebikes
I would pull the entire TBI harness and leave it...

I would pull the entire TBI harness and leave it as intact as possible. You can cut and resolder as necessary and it should not cause any problems, but it increases your work and when you are...
Jeep Forums: YJ Wrangler Technical Forum   04-19-2016, 07:25 AM
Replies: 72
Views: 3,779
Posted By Berniebikes
Yes, if you use a knock sensor you will need the...

Yes, if you use a knock sensor you will need the ESC(electronic spark control) module that goes with it and communicates with the ECM when knocks are sensed and tells it to retard the spark.

I...
Jeep Forums: YJ Wrangler Technical Forum   04-18-2016, 02:32 PM
Replies: 72
Views: 3,779
Posted By Berniebikes
Timatoe, don't really think that statement is...

Timatoe, don't really think that statement is correct. The VSS will help with timing and fuel delivery and is read by the ECM. It isn't just a California thing.
Jeep Forums: YJ Wrangler Technical Forum   04-18-2016, 02:23 PM
Replies: 72
Views: 3,779
Posted By Berniebikes
I would use the VSS. will facilitate proper fuel...

I would use the VSS. will facilitate proper fuel delivery and spark based on acceleration/deceleration. It costs about $75 from Jags That Run.

You probably have a decent map sensor from your...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome