JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 97
Search took 0.01 seconds.
Search: Posts Made By: meon2wheels
Jeep Forums: JK Wrangler Technical Forum   12-21-2013, 10:31 PM
Replies: 26,359
Views: 3,856,667
Posted By meon2wheels
Doing it myself, $200 for the Synergy units, 70...

Doing it myself, $200 for the Synergy units, 70 for the tools, and 20 for the speed sensor. I like doing my own work. Didn't pursue warranty cause I didn't want the OEM joints and I have a lift and...
Jeep Forums: JK Wrangler Technical Forum   12-21-2013, 08:49 AM
Replies: 26,359
Views: 3,856,667
Posted By meon2wheels
Replaced the ball joints with Synergy units after...

Replaced the ball joints with Synergy units after early signs of death wobble. 34K miles with 35's on for the last year and only light wheeling'. Not a simple task. One speed sensor broke, I...
Jeep Forums: JK Wrangler Technical Forum   12-20-2013, 07:43 PM
Replies: 3
Views: 4,532
Posted By meon2wheels
Thanks for the advice. It worked. The epoxy...

Thanks for the advice. It worked. The epoxy method would have been my backup. That thing was in there TIGHT! Had to hold the screw with vice grips and pry on it with a lever. I cleaned up the...
Jeep Forums: JK Wrangler Technical Forum   12-19-2013, 07:27 PM
Replies: 3
Views: 4,532
Posted By meon2wheels
How to remove broken front wheels speed sensor

Well, not such a good day in the garage today, but better than being at work. One of the speed sensors broke off in the sealed hub. Does anyone know how to get this dang this out? I tried an easy...
Jeep Forums: JK Wrangler Technical Forum   12-17-2013, 10:11 PM
Replies: 1,436
Views: 280,322
Posted By meon2wheels
I would pull the fuse for 5 mins, put it back in...

I would pull the fuse for 5 mins, put it back in and try again. This worked for me.
Jeep Forums: JK Wrangler Technical Forum   08-16-2013, 09:18 PM
Replies: 33
Views: 8,471
Posted By meon2wheels
I'm with you... the power gain, if real, is way...

I'm with you... the power gain, if real, is way up there at RPM my engine has never seen, or is way too small at the revs I run to make a difference for me to be excited about a programmer. Don't...
Jeep Forums: JK Wrangler Technical Forum   08-15-2013, 09:50 PM
Replies: 33
Views: 8,471
Posted By meon2wheels
Why no 4WD High Locking Differential feature for...

Why no 4WD High Locking Differential feature for the 2011??? For us 6 speed guys, not much bang for the buck. :mad:
Jeep Forums: JK Wrangler Technical Forum   04-30-2013, 09:44 PM
Replies: 4,013
Views: 3,068,607
Posted By meon2wheels
Nice! You went big on this one. Nice wheels too....

Nice! You went big on this one. Nice wheels too. I just put 35x12.5x15s on mine and love it. Pics back a few pages. Jim
Jeep Forums: JK Wrangler Technical Forum   04-07-2013, 08:24 PM
Replies: 1,436
Views: 280,322
Posted By meon2wheels
Mine repeats every 3weeks or so, curious how you...

Mine repeats every 3weeks or so, curious how you make out.
Jeep Forums: JK Wrangler Technical Forum   04-07-2013, 07:51 PM
Replies: 4,013
Views: 3,068,607
Posted By meon2wheels
Just installed AEV 3.5in lift with 35x12.5x15in...

Just installed AEV 3.5in lift with 35x12.5x15in Wrangler MTR Kevlars! The ride is awesome. Can't wait to try it off road. Gearing is fine for me with 6 speed 4.10s.


603157
Jeep Forums: JK Wrangler Technical Forum   04-07-2013, 01:24 PM
Replies: 6
Views: 2,001
Posted By meon2wheels
Yea, that was it. That's what I get for...

Yea, that was it. That's what I get for following the instructions "install the shock, tighten the nut" and you can't see the female hex with the shock installed! Thanks for the help.
Jeep Forums: JK Wrangler Technical Forum   04-06-2013, 09:10 PM
Replies: 26,359
Views: 3,856,667
Posted By meon2wheels
Installed AEV 3.5in lift with Goodyear...

Installed AEV 3.5in lift with Goodyear 35x12.5x15in tires. Drives great!
...
Jeep Forums: JK Wrangler Technical Forum   04-05-2013, 10:29 PM
Replies: 6
Views: 2,001
Posted By meon2wheels
I don't recall seeing it, but I'll look in the...

I don't recall seeing it, but I'll look in the morning and see. Based on further research i think you are correct. Thanks for responding. Jim.
Jeep Forums: JK Wrangler Technical Forum   04-05-2013, 10:23 PM
Replies: 48
Views: 24,993
Posted By meon2wheels
Dude, nice job! If I did this I'd install the...

Dude, nice job! If I did this I'd install the outlet inside the cargo compartment, but that's just me. Very nice DIY! So the bumper is not pressurized, just the pump outlet? Thanks for sharing. ...
Jeep Forums: JK Wrangler Technical Forum   04-05-2013, 09:34 PM
Replies: 6
Views: 2,001
Posted By meon2wheels
Bilstein 5100 Front Shock Install -Need Help Fast

Searched but couldn't find the answer... AEV lift comes w/Bilstein 5100 shocks. On the front, there are no flats to use to keep the shock shaft from rotating while installing the locknut. Neither...
Jeep Forums: JK Wrangler Technical Forum   04-02-2013, 04:06 PM
Replies: 1,436
Views: 280,322
Posted By meon2wheels
I have a similar problem on my RHB. Cleaned...

I have a similar problem on my RHB. Cleaned connectors, checked pins, found nothing. I also have the LockPick and have not been able to isolate who's causing the problem. Interested in what you...
Jeep Forums: JK Wrangler Technical Forum   03-30-2013, 09:57 PM
Replies: 26,359
Views: 3,856,667
Posted By meon2wheels
TS Offroad Bumper

That's a good lookin' bumper! TS Offroad needs to user your picture on their site - their pics are not so good...
Jeep Forums: JK Wrangler Technical Forum   03-30-2013, 09:41 PM
Replies: 26,359
Views: 3,856,667
Posted By meon2wheels
Got my 35X12.5X15 Goodyear MTR Kevlar's on Level...

Got my 35X12.5X15 Goodyear MTR Kevlar's on Level 8 Tracker polished aluminum wheels today. The guys at Discount Tire Direct are super! Shipped same day. AEV 3.5in lift on it's way. Pictures next...
Jeep Forums: JK Wrangler Technical Forum   03-23-2013, 06:28 PM
Replies: 4,013
Views: 3,068,607
Posted By meon2wheels
MNJeetTraveler, Love those wheels! What diameter...

MNJeetTraveler, Love those wheels! What diameter are they?
Jeep Forums: JK Wrangler Technical Forum   12-17-2012, 12:57 PM
Replies: 3
Views: 540
Posted By meon2wheels
Yea, I should have said I contacted Coastal and...

Yea, I should have said I contacted Coastal and they never heard of such a thing. They recommended I look for a bent pin. Thanks for the help though.
Showing results 1 to 20 of 97

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome