JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.02 seconds.
Search: Posts Made By: ddawg16
Jeep Forums: Jeep CJ Forum   05-30-2021, 09:34 AM
Replies: 220
Views: 54,564
Posted By ddawg16
Yuppppp............at over $600

Yuppppp............at over $600
Jeep Forums: Jeep CJ Forum   05-26-2021, 11:13 PM
Replies: 32
  Test
Views: 3,647
Posted By ddawg16
Some one is getting testy

Some one is getting testy
Jeep Forums: Jeep CJ Forum   05-23-2021, 09:34 AM
Replies: 220
Views: 54,564
Posted By ddawg16
Get all the parts except the bracket first. It...

Get all the parts except the bracket first. It appears not all Maxima calipers are the same. The ones I ended up with had holes closer to the axle.

I have the dxf for both. It's easy to modify...
Jeep Forums: Jeep CJ Forum   05-22-2021, 10:22 PM
Replies: 10
Views: 1,516
Posted By ddawg16
Had some time to work on it this week. I've been...

Had some time to work on it this week. I've been out of town pretty much for the past 2 months. On a positive note....I've got plenty of hotel and airline points.

My big push at the moment is to...
Jeep Forums: Jeep CJ Forum   05-19-2021, 05:45 PM
Replies: 96
Views: 8,127
Posted By ddawg16
Because the crank turns 2x to every turn of the...

Because the crank turns 2x to every turn of the cam. Even at 180 off, the timing mark will show up in the same place
Jeep Forums: Jeep CJ Forum   05-14-2021, 06:20 PM
Replies: 10
Views: 890
Posted By ddawg16
10PSI at Idle? I know a lot of guys who would be...

10PSI at Idle? I know a lot of guys who would be happy with that.

Drive it. I bet you get plenty of mileage out of it.

No need to worry until it drops below 5 PSI at idle.....then you just go...
Jeep Forums: Jeep CJ Forum   05-14-2021, 06:15 PM
Replies: 22
Views: 2,229
Posted By ddawg16
Bent crank would show up related to engine RPM ...

Bent crank would show up related to engine RPM

If the vibration/harmonic gets worse with vehicle speed, drivetrain.
Jeep Forums: Jeep CJ Forum   05-09-2021, 10:31 PM
Replies: 9
Views: 1,199
Posted By ddawg16
All suggestions above good (almost all) Also...

All suggestions above good (almost all)

Also check to make sure your bellhousing bolts are tight. Happened to me....and I had exactly the same symptoms.
Jeep Forums: Jeep CJ Forum   05-09-2021, 10:22 PM
Replies: 14
Views: 1,186
Posted By ddawg16
Textbook case of 'shotgun troubleshooting'. To...

Textbook case of 'shotgun troubleshooting'. To say I've never done that would be a HUGE lie.

I recall an issue I was having with the ignition on my SBC. Every now and then it would stumble. I...
Jeep Forums: Jeep CJ Forum   05-09-2021, 09:38 PM
Replies: 22
Views: 2,229
Posted By ddawg16
Sounds like a fun project to try..... I like...

Sounds like a fun project to try.....

I like the simple way.....Is the vibration worse under accel or decel?

Too bad to OP doesn't have access to a vibration analyzer. Any decent sized company...
Jeep Forums: Jeep CJ Forum   05-08-2021, 05:57 AM
Replies: 220
Views: 54,564
Posted By ddawg16
I wish I had seen this thread sooner. ...

I wish I had seen this thread sooner.

Guys....I'm CAD'ing up a file now for mine. When I'm done I should have 2 versions.

It seems the caliper I got has the mounting holes a little...
Jeep Forums: Jeep CJ Forum   05-08-2021, 05:43 AM
Replies: 16
Views: 1,313
Posted By ddawg16
I just use one of those compression testers that...

I just use one of those compression testers that screws in.
Jeep Forums: Jeep CJ Forum   05-08-2021, 05:40 AM
Replies: 22
Views: 2,229
Posted By ddawg16
Same here. Put the jeep in gear with the...

Same here.

Put the jeep in gear with the engine OFF. Crawl under it and using your foot to push on the rear axle, rock it back and forth while looking at the drive shaft. If the u-joints are...
Jeep Forums: Jeep CJ Forum   05-08-2021, 05:34 AM
Replies: 12
Views: 2,465
Posted By ddawg16
I'm thinking float level. To confirm, pop it in...

I'm thinking float level. To confirm, pop it in neutral without touching anything else. When you downshift the fuel in the bowl goes forward. It might be enough to lean it out if the level is too...
Jeep Forums: Jeep CJ Forum   05-02-2021, 12:09 PM
Replies: 13
Views: 2,296
Posted By ddawg16
My BIL buys and sells war birds....like P51's...

My BIL buys and sells war birds....like P51's P38's, etc.

Some of his customers have restored jeeps to use around the flightline.

He just 'procured' an hold WWII motorcycle that is going...
Jeep Forums: Jeep CJ Forum   05-02-2021, 11:55 AM
Replies: 16
Views: 1,468
Posted By ddawg16
I'm pretty sure he was. His topic was about both...

I'm pretty sure he was. His topic was about both water and oil....

I've made a LOT worse typo's
Jeep Forums: Jeep CJ Forum   05-02-2021, 08:46 AM
Replies: 16
Views: 1,468
Posted By ddawg16
If your oil is starting to boil.....you have...

If your oil is starting to boil.....you have MAJOR issues.

The boiling point of oil is around 1000 or more
Jeep Forums: Jeep CJ Forum   05-01-2021, 11:57 PM
Replies: 10
Views: 1,516
Posted By ddawg16
The axle came out of a FS 77 Cherokee

The axle came out of a FS 77 Cherokee
Jeep Forums: Jeep CJ Forum   04-26-2021, 10:28 PM
Replies: 10
Views: 1,516
Posted By ddawg16
I thought about doing that. The outers on my...

I thought about doing that. The outers on my existing D30 are the same as the D44 so If I pop off the steering linkage, I can turn my wheel as far as I want.

I'm SOA....and I already have some...
Jeep Forums: Jeep CJ Forum   04-25-2021, 07:38 PM
Replies: 10
Views: 1,516
Posted By ddawg16
Always here.....the leak in the windshield frame...

Always here.....the leak in the windshield frame was tossing water down that side.
Compounding the issue...I have a the Duraback rubber liner inside....so it looks like it trapped water as well. ...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome