JeepForum.com - Search Results
Advanced Search
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Search: Posts Made By: Rologold0505
Jeep Forums: TJ Wrangler Technical Forum   03-20-2015, 07:06 AM
Replies: 9
Views: 772
Posted By Rologold0505
I'm almost certain that I need the following. ...

I'm almost certain that I need the following.
http://www.moserengineering.com/other-parts/bearings/part-9mtr-timken-tapered-roller-bearing.html

But does anyone have any extra information or...
Jeep Forums: TJ Wrangler Technical Forum   03-20-2015, 05:47 AM
Replies: 9
Views: 772
Posted By Rologold0505
Help Need new Rear Bearings for 33 Spline Superior Axles

Looking for any help or advice on acquiring new bearings and seals for my rear 33 spline superior axles. I am currently lost after ordering three different sets of bearings. Basically everyone is...
Jeep Forums: XJ Cherokee Technical Forum   01-22-2015, 02:07 PM
Replies: 20
Views: 11,271
Posted By Rologold0505
Could you PM this link to me as well. Thanks

Could you PM this link to me as well. Thanks
Jeep Forums: TJ Wrangler Technical Forum   10-08-2014, 02:34 PM
Replies: 36
Views: 3,099
Posted By Rologold0505
I m looking at doing the same with mine right...

I m looking at doing the same with mine right now. Found a rubicon axle with the 4:10 and it is out of an 05. Anyone know if the 05 will bolt directly into my 97 tj? I believe their the same until...
Jeep Forums: TJ Wrangler Technical Forum   08-27-2014, 10:14 AM
Replies: 33
Views: 1,913
Posted By Rologold0505
Well lucky I figured it out. I was looking at the...

Well lucky I figured it out. I was looking at the crank as needing to be centered. But after much pondering I realized the the fan pulley is what needs to be centered and not the crank. Everything...
Jeep Forums: TJ Wrangler Technical Forum   08-23-2014, 12:32 PM
Replies: 33
Views: 1,913
Posted By Rologold0505
When you did the swap does the 4.0 motor line...

When you did the swap does the 4.0 motor line straight up with the frame rails? Or is it pushed toward the passenger side.
I have my mounts on and measured everything and have motor in the frame...
Jeep Forums: TJ Wrangler Technical Forum   08-23-2014, 09:13 AM
Replies: 0
Views: 323
Posted By Rologold0505
Help 4.0 Engine Alignment!! dry fit in frame

Currently have a 98 tj and I am in the middle of a total frame off restoration. During which I am installing a 4.0 into a good frame where a 2.5 once sat. The 2.5 brackets are cutoff and the 4.0...
Jeep Forums: TJ Wrangler Technical Forum   08-14-2014, 12:22 PM
Replies: 173
Views: 255,133
Posted By Rologold0505
Does anyone know where to get the stock 6 cy...

Does anyone know where to get the stock 6 cy motor mounts now. I am in the middle of a swap and found out the parts are discontinued. I find them on multiple websites but after calling they state...
Showing results 1 to 8 of 8

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome