JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.06 seconds.
Search: Posts Made By: BM3
Jeep Forums: TJ Wrangler Technical Forum   06-24-2020, 09:35 AM
Replies: 18
Views: 820
Posted By BM3
Keep the TJ....

Keep the TJ....
Jeep Forums: TJ Wrangler Technical Forum   06-18-2020, 08:27 AM
Replies: 4
Views: 209
Posted By BM3
IMO get the rubber stock style whenever possible,...

IMO get the rubber stock style whenever possible, Poly anything on a jeep isn't a upgrade, CA bushing, body mounts, Jounce bumpstops, trans mount, etc... way to hard causing a rough ride
Jeep Forums: TJ Wrangler Technical Forum   06-18-2020, 08:10 AM
Replies: 17
Views: 397
Posted By BM3
Does anything happen when you turn the key to the...

Does anything happen when you turn the key to the start position? Not sure if it could be the NSS, but another thing to check it the actuator pin in the ignition cylinder, seems a lot of those have...
Jeep Forums: TJ Wrangler Technical Forum   06-17-2020, 08:31 AM
Replies: 5
Views: 223
Posted By BM3
Verify if they are talking body mounts, or the...

Verify if they are talking body mounts, or the torque boxes.
Jeep Forums: TJ Wrangler Technical Forum   06-16-2020, 05:48 AM
Replies: 11
Views: 483
Posted By BM3
No lag: the supercharger's biggest advantage over...

No lag: the supercharger's biggest advantage over a turbocharger is that it does not have any lag. Power delivery is immediate because the supercharger is driven by the engine's crankshaft. Low RPM...
Jeep Forums: TJ Wrangler Technical Forum   06-10-2020, 07:23 AM
Replies: 7
Views: 312
Posted By BM3
That's how mine acted when the started went, you...

That's how mine acted when the started went, you can give the starter a tap with a hammer and see if it helps....
Jeep Forums: TJ Wrangler Technical Forum   06-08-2020, 09:43 AM
Replies: 11
Views: 483
Posted By BM3
IMO Supercharge it before turbo, and as far as I...

IMO Supercharge it before turbo, and as far as I know, not able to tune those years PCM, have to use a piggy back tuner. Boosted Tech has a solution if running their SC...
Jeep Forums: TJ Wrangler Technical Forum   06-02-2020, 07:01 AM
Replies: 9
Views: 297
Posted By BM3
Fuel pressure should be 49 5 psi, you can try...

Fuel pressure should be 49 5 psi, you can try starting it with starter fluid. If it starts off that it would lead to a fuel delivery problem. I'm sure someone with more experience will chime in...
Jeep Forums: TJ Wrangler Technical Forum   05-29-2020, 10:25 AM
Replies: 16
Views: 636
Posted By BM3
Looks good, remember to flush all the old brake...

Looks good, remember to flush all the old brake fluid out too... seems like that get overlooked a lot.
Jeep Forums: TJ Wrangler Technical Forum   05-19-2020, 12:26 PM
Replies: 42
Views: 1,437
Posted By BM3
I don't think you can do a tummy tuck without a...

I don't think you can do a tummy tuck without a body lift. I'd do the Zone 4.25" lift combo, spend the $$ for adjustable control arms, SSYE & DC DS, upgrade brakes for the larger tires (IMO minimum...
Jeep Forums: TJ Wrangler Technical Forum   05-05-2020, 12:24 PM
Replies: 48
Views: 1,998
Posted By BM3
Re-Gear or motor swap is the only thing that will...

Re-Gear or motor swap is the only thing that will help....
Jeep Forums: TJ Wrangler Technical Forum   04-30-2020, 11:39 AM
Replies: 8
Views: 374
Posted By BM3
Also if planning on doing the 4" lift and the...

Also if planning on doing the 4" lift and the tummy tuck, I would suggest going with a SS-SYE (SuperShort SYE). That will increase your DS length and should help with the DS angle. It will remove...
Jeep Forums: TJ Wrangler Technical Forum   04-17-2020, 07:04 AM
Replies: 2
Views: 346
Posted By BM3
I have had that top for a few years now, IMO not...

I have had that top for a few years now, IMO not a lot of difference except the Quadratop doesn't fit as tight as the stock Bestop did. But I would have no problems ordering it again if I needed to.
Jeep Forums: TJ Wrangler Technical Forum   04-15-2020, 07:45 AM
Replies: 12
Views: 509
Posted By BM3
I've used Yukon gears on the 2 I had re-geared,...

I've used Yukon gears on the 2 I had re-geared, no issues
Jeep Forums: TJ Wrangler Technical Forum   03-20-2020, 11:24 AM
Replies: 5
Views: 334
Posted By BM3
Fresh Gas, Oil, Coolant, Plugs, Dist. Cap &...

Fresh Gas, Oil, Coolant, Plugs, Dist. Cap & Rotor, Plug wires before starting. Before driving, Transfer case fluid, brake fluid, maybe transmission fluid
Jeep Forums: TJ Wrangler Technical Forum   03-18-2020, 12:35 PM
Replies: 43
Views: 1,541
Posted By BM3
The speedo gear is based off of tire size, and...

The speedo gear is based off of tire size, and very easy to change yourself.
Wrong chart was uploaded, my bad sorry
Jeep Forums: TJ Wrangler Technical Forum   03-13-2020, 09:30 AM
Replies: 3
Views: 431
Posted By BM3
From wranglerforum from Rubi4mymrs "It sounds...

From wranglerforum
from Rubi4mymrs
"It sounds like the inlet check valve (ICV) is stunk closed. You can remove the inlet hose & try pushing the valve open with a long screwdriver. If you do that...
Jeep Forums: TJ Wrangler Technical Forum   03-13-2020, 09:15 AM
Replies: 4
Views: 408
Posted By BM3
Here is a link from the other wranglerforum with...

Here is a link from the other wranglerforum with FSMs, just remove a couple spaces

wrangler tjeepforum.com /threads/jeep-wrangler-tj-factory-service-manuals-fsm-technical-documentation.4618/
Jeep Forums: TJ Wrangler Technical Forum   03-13-2020, 08:01 AM
Replies: 7
Views: 569
Posted By BM3
If there was a cracked block, or head, wouldn't...

If there was a cracked block, or head, wouldn't the oil look like chocolate milk like in the pic??
When you did the radiator change did you use compatible coolant types? I know if yo mix hoat &...
Jeep Forums: TJ Wrangler Technical Forum   03-12-2020, 11:33 AM
Replies: 23
  Fuse 11
Views: 734
Posted By BM3
Ok I think I got my head outta my a** now. Fuse...

Ok I think I got my head outta my a** now. Fuse 11 is also in the charging circuit

When the ignition switch is in either the START or
RUN positions, it connects circuit Al from fuse 3 in
the PDC...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome