JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.05 seconds.
Search: Posts Made By: Paul_C
Jeep Forums: XJ Cherokee Technical Forum   10-23-2011, 03:46 PM
Replies: 7
Views: 928
Posted By Paul_C
I'm sure you want to hear how the saga ends....

I'm sure you want to hear how the saga ends. Kevin, I ran into your article previously and was something on my mind to check. So this morning I set up the ramps and drove up. Yesterday I didn't see...
Jeep Forums: XJ Cherokee Technical Forum   10-22-2011, 10:03 PM
Replies: 7
Views: 928
Posted By Paul_C
Thanks for the tips. I'll check that but unless...

Thanks for the tips. I'll check that but unless there is some kind of funky wiring I would suspect it would also effect the other primary circuits. I imagine I could bypass the relay easily for...
Jeep Forums: XJ Cherokee Technical Forum   10-22-2011, 05:39 PM
Replies: 7
Views: 928
Posted By Paul_C
Strange 2000 misfire

A few miles from my home on Friday driving the back roads. All of a sudden severe misfire and a blinking CEL. Codes were P0300, P0303, P0304 and P0353. Figured I would take a shot and replace the...
Jeep Forums: XJ Cherokee Technical Forum   08-29-2009, 07:56 PM
Replies: 2
Views: 637
Posted By Paul_C
I haven't investigated the wiring but I had an...

I haven't investigated the wiring but I had an interesting thought. I might try to connect the rear wiper trigger to the front wiper trigger. That way when the front wipers are set on intermittent...
Jeep Forums: XJ Cherokee Technical Forum   06-20-2009, 11:20 AM
Replies: 90
Views: 5,746
Posted By Paul_C
Their not illegal but check the state and local...

Their not illegal but check the state and local laws. Even if it's legal in your area you might want to get a set of covers for them. I know in PA and I believe it's the same in NY. You can have them...
Jeep Forums: XJ Cherokee Technical Forum   11-16-2008, 05:21 PM
Replies: 6
Views: 861
Posted By Paul_C
Update. Autozone had an adapter behind the...

Update.
Autozone had an adapter behind the counter that fit perfectly with one exception. The tapered tip that fit the female nut was not threaded about 1/4 inch. It only allowed about two turns of...
Jeep Forums: XJ Cherokee Technical Forum   11-16-2008, 10:00 AM
Replies: 6
Views: 861
Posted By Paul_C
It's factory. On the bottom pic the flare fitting...

It's factory. On the bottom pic the flare fitting on the right attaches to the bottom of the proportioning valve. Doing some research Edelmann makes 3/8 24 to 10-1.25mm inverted tube flare adapters...
Jeep Forums: XJ Cherokee Technical Forum   11-16-2008, 09:24 AM
Replies: 6
Views: 861
Posted By Paul_C
Pics ...

Pics
http://i207.photobucket.com/albums/bb10/Paul_C_XJ/brakeline1.jpg
http://i207.photobucket.com/albums/bb10/Paul_C_XJ/brakeline3.jpg...
Jeep Forums: XJ Cherokee Technical Forum   11-15-2008, 03:41 PM
Replies: 6
Views: 861
Posted By Paul_C
2000 rear hard brake line

I am working on replacing the hard brake line from the proportioning valve to the rear. There is a short piece of line that comes off the bottom of the proportioning valve and has a dog leg in it. It...
Jeep Forums: XJ Cherokee Technical Forum   11-08-2008, 05:54 PM
Replies: 4
Views: 781
Posted By Paul_C
Hypertech locks their tuner to the ECU serial...

Hypertech locks their tuner to the ECU serial number. I emailed them once and asked if I bought a used unit if they would unlock their programmer for use on another ECU. They said they could for...
Jeep Forums: XJ Cherokee Technical Forum   10-03-2008, 02:31 PM
Replies: 2
Views: 299
Posted By Paul_C
Might have better luck in the ZJ section but have...

Might have better luck in the ZJ section but have you tried pushing in the volume knob when the radio is on.
Jeep Forums: XJ Cherokee Technical Forum   09-26-2008, 06:31 PM
Replies: 7
Views: 469
Posted By Paul_C
Nope, the key cycle for codes doesn't work on the...

Nope, the key cycle for codes doesn't work on the XJ.
Jeep Forums: XJ Cherokee Technical Forum   09-26-2008, 06:27 PM
Replies: 10
Views: 8,436
Posted By Paul_C
There's a plunger switch on the back top of the...

There's a plunger switch on the back top of the transfer case. You can test the harness and dash light by shorting the switch connecter pins to ground. If that works then the switch is bad.
Jeep Forums: XJ Cherokee Technical Forum   09-25-2008, 06:26 PM
Replies: 11
Views: 1,868
Posted By Paul_C
A relay will also allow you to keep the lighting...

A relay will also allow you to keep the lighting harness much shorter because you won't need to route heavy gauge wires through the firewall and back. Also using a relay will allow you to pick any...
Jeep Forums: XJ Cherokee Technical Forum   09-18-2008, 06:37 PM
Replies: 5
Views: 531
Posted By Paul_C
They should be close enough if there was any...

They should be close enough if there was any changes at all. 2000 was the first year with the coil pack so the engine diagnostics should be the same.
Jeep Forums: XJ Cherokee Technical Forum   09-17-2008, 06:03 PM
Replies: 7
Views: 850
Posted By Paul_C
My 2000 has a drivers side auto down. There is a...

My 2000 has a drivers side auto down. There is a relay on the power window switch board for the auto down but I never investigated what releases it when it reaches the down position. There isn't an...
Jeep Forums: XJ Cherokee Technical Forum   09-16-2008, 09:46 PM
Replies: 9
Views: 648
Posted By Paul_C
A sidewall should never be repaired and run on a...

A sidewall should never be repaired and run on a street. Failure is immenent and consequences undesired.
Jeep Forums: XJ/MJ Cherokee Non-Technical Forum   09-16-2008, 09:38 PM
Replies: 61
Views: 7,741
Posted By Paul_C
Should have made this a poll. Personally with...

Should have made this a poll. Personally with steel rims blackwalls look better but with aluminum whites out. I went whites out on my aluminum rims with BFG TA KO's. Looks good on a white Jeep. With...
Jeep Forums: XJ Cherokee Technical Forum   09-16-2008, 03:31 PM
Replies: 6
Views: 701
Posted By Paul_C
Any worn suspension component can cause death...

Any worn suspension component can cause death wobble. If nothing else is obvious then a likely culprit is the track bar bushing on the axle.
Jeep Forums: XJ Cherokee Technical Forum   09-16-2008, 03:16 PM
Replies: 14
Views: 2,689
Posted By Paul_C
Maybe some useful info. ...

Maybe some useful info.

https://www.jeepforum.com/forum/showthread.php?t=482618&highlight=range+rover
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome