JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 133
Search took 0.03 seconds.
Search: Posts Made By: KG4MXV
Jeep Forums: KK Liberty Forum   10-17-2018, 02:54 PM
Replies: 5
Views: 1,120
Posted By KG4MXV
Well I bought it the it had 160k mi. and dropped...

Well I bought it the it had 160k mi. and dropped $1,000.00 on doing a full body lube and 4WD service including
replacing two CV joint boots. Replaced two actuators in the HVAC system and flushing...
Jeep Forums: KK Liberty Forum   10-15-2018, 08:29 PM
Replies: 5
Views: 1,120
Posted By KG4MXV
Do's and Don'ts of changing spark plugs

My 2012 KK 3.7 gas has over 170kmi and is burning up a 1/4 tank in 40mil
And I am sure that the plugs are orig.
I am doing what I can for a tune up. Changing plugs and Air filter.

The...
Jeep Forums: KK Liberty Forum   10-10-2018, 08:35 AM
Replies: 4
Views: 412
Posted By KG4MXV
Just spit balling, did you check the wheel bering...

Just spit balling, did you check the wheel bering for slop?
Jeep Forums: KK Liberty Forum   09-25-2018, 08:52 PM
Replies: 4,757
Views: 691,202
Posted By KG4MXV
Thats $286.00 more than I have at the moment. ...

Thats $286.00 more than I have at the moment.
Been out of work for almost 10 months.
Got an interview tomorrow, Keeping hopes high.
Jeep Forums: KK Liberty Forum   09-23-2018, 08:17 PM
Replies: 4,757
Views: 691,202
Posted By KG4MXV
Rally jealous, I would love to have a complete...

Rally jealous, I would love to have a complete set of skid plates but just can't afford it.
Jeep Forums: KK Liberty Forum   09-06-2018, 08:19 PM
Replies: 18
Views: 1,354
Posted By KG4MXV
If I had the cash I would take you up on that. ...

If I had the cash I would take you up on that.
But been out of work for almost a year.
Jeep Forums: KK Liberty Forum   09-06-2018, 07:07 AM
Replies: 18
Views: 1,354
Posted By KG4MXV
Can I ask where did you get them?

Can I ask where did you get them?
Jeep Forums: KK Liberty Forum   09-03-2018, 03:56 PM
Replies: 8
Views: 837
Posted By KG4MXV
I would check the ground connections and wiring. ...

I would check the ground connections and wiring.
I would check voltages with and with out the headlight on.
Here is a wiring diagram for a 2012 but it should be the same.
Jeep Forums: KK Liberty Forum   09-02-2018, 05:41 PM
Replies: 8
Views: 516
Posted By KG4MXV
A volt meter would let you know.

A volt meter would let you know.
Jeep Forums: KK Liberty Forum   08-31-2018, 05:49 PM
Replies: 14
Views: 1,015
Posted By KG4MXV
BTW the label 18GY/OR just means position 18...

BTW the label 18GY/OR just means position 18 in the connector with the main color of Grey with an orange stripe. I am pretty sure about that.
Jeep Forums: KK Liberty Forum   08-31-2018, 05:44 PM
Replies: 14
Views: 1,015
Posted By KG4MXV
I am currently running some new two way radio...

I am currently running some new two way radio cables in the jeep and have access to the regular radio antenna.
I pulled the connector off and measured the voltage while the radio was off and when...
Jeep Forums: KK Liberty Forum   08-30-2018, 09:48 AM
Replies: 14
Views: 1,015
Posted By KG4MXV
OK, Lets see if the antenna is getting 12V after...

OK, Lets see if the antenna is getting 12V after the install of your aftermarket HU unit.
It is real easy to get at the antenna connector.
Open the rear hatch.
Look at the top plastic peace at...
Jeep Forums: KK Liberty Forum   08-28-2018, 08:44 AM
Replies: 2
Views: 404
Posted By KG4MXV
I would suspect a problem with the windshield...

I would suspect a problem with the windshield wiper control stalk.
If you have a LKQ parts yard near you I would try to get a used stalk and temporally plug it in and see if the problem persists....
Jeep Forums: KK Liberty Forum   08-28-2018, 08:36 AM
Replies: 4,757
Views: 691,202
Posted By KG4MXV
Just got the marine grade heat shrink and...

Just got the marine grade heat shrink and finished most of the cabling and power wiring.
Now just to build the control center console for the radio heads.
I plan on using aluminum diamond tread...
Jeep Forums: KK Liberty Forum   08-26-2018, 04:53 PM
Replies: 8
Views: 516
Posted By KG4MXV
Removed, I didn't read the entire first post

Removed, I didn't read the entire first post
Jeep Forums: KK Liberty Forum   08-26-2018, 11:00 AM
Replies: 4,757
Views: 691,202
Posted By KG4MXV
Agreed another poor design is the elimination of...

Agreed another poor design is the elimination of the valve that cuts off the flow to the heater core.
The core stays at the 200F during the operation of the jeep. And heats up the air box. Even...
Jeep Forums: KK Liberty Forum   08-24-2018, 04:44 PM
Replies: 4,757
Views: 691,202
Posted By KG4MXV
After resealing the Sky slider roof with aluminum...

After resealing the Sky slider roof with aluminum strips and over 100 screws, 2 coats of flex seal.
And fixing the roof skin from over torquing the the roof rack studs.
I finally got the...
Jeep Forums: KK Liberty Forum   08-18-2018, 03:47 PM
Replies: 8
Views: 713
Posted By KG4MXV
Yep made sure it was UV resistant. The stuff...

Yep made sure it was UV resistant.
The stuff in the spray cans wasn't even though it might have said it was.
Jeep Forums: KK Liberty Forum   08-17-2018, 06:13 AM
Replies: 8
Views: 713
Posted By KG4MXV
The flex seal in the spray can is crap. I used...

The flex seal in the spray can is crap. I used it first and after 2 weeks of direct sun it turned grayish and started cracking.
The flex seal in the regular paint cans is much better.
I only...
Jeep Forums: KK Liberty Forum   08-16-2018, 06:56 AM
Replies: 8
Views: 713
Posted By KG4MXV
BTW if anyone wants to do this. Make sure to...

BTW if anyone wants to do this. Make sure to remove the masking while the sealant is still wet.
IF you wait too long it will peel the edges off.
Showing results 1 to 20 of 133

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome