JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.06 seconds.
Search: Posts Made By: Toms87
Jeep Forums: Maryland Jeep Forum   04-15-2014, 08:14 PM
Replies: 7
Views: 1,232
Posted By Toms87
---

---
Jeep Forums: Maryland Jeep Forum   04-15-2014, 09:55 AM
Replies: 3
Views: 816
Posted By Toms87
No idea but the website is still functional. I...

No idea but the website is still functional. I haven't seen the guy post recently in this section.
Jeep Forums: Maryland Jeep Forum   04-15-2014, 06:38 AM
Replies: 3
Views: 816
Posted By Toms87
No experience with this shop but it's in...

No experience with this shop but it's in Salisbury.
http://dorfab.com/
Jeep Forums: YJ Wrangler Technical Forum   04-10-2014, 10:54 AM
Replies: 17
Views: 1,400
Posted By Toms87
I'll throw in a random guess for power steering...

I'll throw in a random guess for power steering cooler, since trans cooler is already taken and it's a manual anyway.
Jeep Forums: TJ Wrangler Technical Forum   04-10-2014, 10:50 AM
Replies: 7
Views: 587
Posted By Toms87
I have seen a cracked terminal connector cause...

I have seen a cracked terminal connector cause all kinds of strange issues with electronics. Just a guess, if you want to inspect your connectors for cracks.
Jeep Forums: Jeep Builds   04-09-2014, 06:58 PM
Replies: 14
Views: 781
Posted By Toms87
The picture is a little blurry but the shroud...

The picture is a little blurry but the shroud looks OK to me. I might be concerned about that winch blocking the grill in standard form, but it looks like there should be plenty of airflow with the...
Jeep Forums: TJ Wrangler Technical Forum   04-08-2014, 07:02 AM
Replies: 1
Views: 420
Posted By Toms87
I used Novak bolt-in and am very satisfied. I...

I used Novak bolt-in and am very satisfied. I also don't have a welder.

I don't have a 5.3 or a TJ but there's not much practical difference here.
Jeep Forums: Jeep Builds   04-07-2014, 07:17 PM
Replies: 14
Views: 781
Posted By Toms87
I could be wrong, but I have always been under...

I could be wrong, but I have always been under the impression that hot on the highway will likely have a different cause than hot at slow speeds.



Do you have a picture of your fan setup, for...
Jeep Forums: TJ Wrangler Technical Forum   04-06-2014, 11:17 AM
Replies: 12
Views: 1,000
Posted By Toms87
I think we'd have to see pictures first to...

I think we'd have to see pictures first to determine how bad your fender is to begin with.
Jeep Forums: Jeep Builds   04-02-2014, 07:33 PM
Replies: 14
Views: 781
Posted By Toms87
I'm not running a/c. One thing I was...

I'm not running a/c.

One thing I was considering was header heat wrap to get some of the heat transferred out of the engine compartment, but since the fan & shroud fixed the problem I never got...
Jeep Forums: Jeep Builds   04-02-2014, 06:04 PM
Replies: 14
Views: 781
Posted By Toms87
I had a similar issue with my 305 on the highway....

I had a similar issue with my 305 on the highway. I swapped radiators and installed hood louvers which helped but didn't cure the problem. The problem ended up being that my fan shroud wasn't good...
Jeep Forums: YJ Wrangler Technical Forum   03-03-2014, 01:22 PM
Replies: 14
Views: 1,286
Posted By Toms87
Do they interfere with each other at all? Are...

Do they interfere with each other at all? Are they both installed at all times or do you only install the harness before four wheeling? I'm going with harnesses eventually but I'd like to keep the...
Jeep Forums: General Jeep & Off-Road Equipment   03-02-2014, 02:57 PM
Replies: 17
  Stuck
Views: 1,199
Posted By Toms87
ARB Aussie Yukon Detroit Eaton Ox ...

ARB
Aussie
Yukon
Detroit
Eaton
Ox
Spartan
Lock-Rite

I run front and rear Aussies in my Jeep but that setup wouldn't be for everyone. They are lunchbox (automatic) lockers.
Jeep Forums: General Jeep & Off-Road Equipment   03-02-2014, 02:03 PM
Replies: 17
  Stuck
Views: 1,199
Posted By Toms87
You have open differentials and to remedy that,...

You have open differentials and to remedy that, you'd want lockers.
Jeep Forums: YJ Wrangler Technical Forum   02-14-2014, 01:51 PM
Replies: 6
Views: 2,590
Posted By Toms87
Similar to what everyone else is saying, I'd jack...

Similar to what everyone else is saying, I'd jack it up and give the front end a thorough look.

Front driveshaft
Wheel bearings
U-Joints
Transfer case front output shaft
Vacuum shift

I also...
Jeep Forums: YJ Wrangler Technical Forum   02-11-2014, 09:22 PM
Replies: 15
Views: 1,104
Posted By Toms87
I rubbed the rear flares with 33s on 4" of...

I rubbed the rear flares with 33s on 4" of suspension lift going over speed bumps. TJ flares and the appropriate cutting to properly install them cured that problem.
Jeep Forums: YJ Wrangler Technical Forum   02-11-2014, 09:17 PM
Replies: 7
Views: 1,634
Posted By Toms87
Installed the new switch just now. Everything...

Installed the new switch just now. Everything seems to be working fine but I need to take a test drive sometime soon to make sure. Here is a picture of the old switch - corroded, full of dirt, and...
Jeep Forums: YJ Wrangler Technical Forum   02-11-2014, 06:11 PM
Replies: 7
Views: 1,634
Posted By Toms87
It's the headlight switch and I'm picking up a...

It's the headlight switch and I'm picking up a new one tonight. When I turn on only the parking lights, they come on. When I turn on the headlights, everything else goes off. A few times I could...
Jeep Forums: ZJ Grand Cherokee Forum   02-10-2014, 07:14 AM
Replies: 11
Views: 770
Posted By Toms87
https://www.jeepforum.com/forum/f13/95-zj-rear-hatc...

https://www.jeepforum.com/forum/f13/95-zj-rear-hatch-stuck-323320/#post2713757



Edit: just noticed you can't get inside at all.
Jeep Forums: YJ Wrangler Technical Forum   02-07-2014, 09:07 AM
Replies: 7
Views: 1,634
Posted By Toms87
That's what I figured but it took me a few...

That's what I figured but it took me a few minutes.

I'll report back here whether or not that fixes the problem when I have a chance to work on it.
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome