JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.04 seconds.
Search: Posts Made By: kloppk
Jeep Forums: YJ Wrangler Technical Forum   10-12-2015, 03:39 PM
Replies: 10
Views: 898
Posted By kloppk
Get a double flaring tool, a roll of...

Get a double flaring tool, a roll of copper-nickel brake line and some fittings and make your own lines.
Replace them all as well as the flex lines as previous mentioned.
The copper-nickel line...
Jeep Forums: YJ Wrangler Technical Forum   08-04-2015, 01:48 PM
Replies: 11
Views: 556
Posted By kloppk
I'd suspect you need to adjust your tcase...

I'd suspect you need to adjust your tcase linkage.
It might not be adjusted properly and it's not fully engaged in 4HI.
Jeep Forums: TJ Wrangler Technical Forum   07-19-2015, 07:57 AM
Replies: 8
Views: 602
Posted By kloppk
The TJ's use a single line setup. The...

The TJ's use a single line setup.
The pressure regulator is integrated into the fuel pump assembly thus eliminating the need for the regulator and return line on the fuel rail.
Jeep Forums: YJ Wrangler Technical Forum   07-18-2015, 03:53 PM
Replies: 4
Views: 1,531
Posted By kloppk
The part of the slip yoke that rides against the...

The part of the slip yoke that rides against the seal may be grooved from wear and dirt.
You can try to use some emery cloth to smooth it out.
If it still leaks and the slip yoke is smooth then it...
Jeep Forums: YJ Wrangler Technical Forum   07-18-2015, 06:44 AM
Replies: 11
Views: 1,010
Posted By kloppk
Yup - you need the Napa 11800 installed in the...

Yup - you need the Napa 11800 installed in the pumpkin on the passengers side.
Jeep Forums: YJ Wrangler Technical Forum   07-14-2015, 06:04 PM
Replies: 11
Views: 739
Posted By kloppk
That collar just pop's on and off. It takes some...

That collar just pop's on and off. It takes some coaxing with a mallet to get it on and off. It's a snug fit.
Jeep Forums: YJ Wrangler Technical Forum   07-14-2015, 05:59 PM
Replies: 8
Views: 1,574
Posted By kloppk
I'm at 84" with 43's with an 82" trailer. ...

I'm at 84" with 43's with an 82" trailer.
Built these a few years back out of scrap 2x6's. Made them just long enough so that the F&R tires rest against the ends once loaded. Exactly positions...
Jeep Forums: YJ Wrangler Technical Forum   07-11-2015, 04:07 PM
Replies: 8
Views: 1,574
Posted By kloppk
Front Axle - HP Ford D60 WMS 70" Rims Allied 5"...

Front Axle - HP Ford D60 WMS 70" Rims Allied 5" back spacing (custom built) Tires 43" Inerco SX Stickies. Section Width 14.2. Overall 84.2"
Rear Axle - Ford D60 WMS 66" Rims Allied 5" back...
Jeep Forums: TJ Wrangler Technical Forum   07-10-2015, 08:29 AM
Replies: 13
Views: 775
Posted By kloppk
X2 :rolleyes:

X2 :rolleyes:
Jeep Forums: YJ Wrangler Technical Forum   07-10-2015, 08:23 AM
Replies: 13
Views: 1,449
Posted By kloppk
I suspect the clutch disc isn't lined up...

I suspect the clutch disc isn't lined up correctly with the pilot bearing.
Did you use a clutch alignment tool when installing the clutch and pressure plate?
Jeep Forums: TJ Wrangler Technical Forum   07-01-2015, 05:44 PM
Replies: 4
Views: 672
Posted By kloppk
Check out... ...

Check out... http://www.jeep4x4center.com/knowledge-base/index.htm#catalogs

You can view them on-line at Morris 4x4 Center
Jeep Forums: YJ Wrangler Technical Forum   06-30-2015, 06:46 AM
Replies: 9
Views: 935
Posted By kloppk
For the front it doesn't matter which side. The...

For the front it doesn't matter which side.
The dual booster setup made a big difference in my YJ.
Jeep Forums: YJ Wrangler Technical Forum   06-28-2015, 06:57 AM
Replies: 10
Views: 737
Posted By kloppk
The brake light will also come on if your e-brake...

The brake light will also come on if your e-brake isn't fully reset (off).


The no-start may be due to an intermittent Neutral Safety Switch (NSS) on your automatic transmission.
Jeep Forums: TJ Wrangler Technical Forum   05-13-2015, 06:57 PM
Replies: 5
Views: 675
Posted By kloppk
You can buy a new one. Easy to install. Set in...

You can buy a new one.
Easy to install. Set in place and tap the center of it with a hammer to expand it. It will lock itself into place.
Or you can just tack weld the one you have back into...
Jeep Forums: YJ Wrangler Technical Forum   04-23-2015, 04:41 PM
Replies: 32
Views: 2,085
Posted By kloppk
I did the small latch thing years ago to my YJ. ...

I did the small latch thing years ago to my YJ.
Glad to see someone else thought of it too and posted up the pics.
Jeep Forums: TJ Wrangler Technical Forum   04-10-2015, 05:40 PM
Replies: 8
Views: 807
Posted By kloppk
The position shown in the picture with the yellow...

The position shown in the picture with the yellow arrow is 2HI
(Just installed the Novak kit into a buddy's TJ last weekend)
Jeep Forums: WK2 Grand Cherokee Forum   04-10-2015, 05:34 PM
Replies: 12
Views: 1,319
Posted By kloppk
If you have the time I'd suggest Rausch Creek. ...

If you have the time I'd suggest Rausch Creek. It's about 1:30 from Tobyhanna.
Miles and miles of trials from easy to crazy.
I go there at least twice a year with my Jeep.
http://rc4x4.org/
Jeep Forums: YJ Wrangler Technical Forum   03-25-2015, 07:57 PM
Replies: 1
Views: 357
Posted By kloppk
Just 1 seal on the pinion.

Just 1 seal on the pinion.
Jeep Forums: YJ Wrangler Technical Forum   03-15-2015, 05:33 PM
Replies: 4
Views: 686
Posted By kloppk
1) Make sure the parking brake is fully released...

1) Make sure the parking brake is fully released and not triggering the light.


You can verify the light is on due to the prop valve by temporarily disconnecting the wire from it.

2) Start...
Jeep Forums: YJ Wrangler Technical Forum   03-15-2015, 07:54 AM
Replies: 21
Views: 10,795
Posted By kloppk
For those starting to take those two bolts out...

For those starting to take those two bolts out it's best to start with the correct socket.
A 12 point socket kinda fits but is prone to slipping and rounding the head.
It's best to use an "E12"...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome