JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 116
Search took 0.01 seconds.
Search: Posts Made By: cglax6
Jeep Forums: Jeep CJ Forum   07-21-2021, 09:25 AM
Replies: 32
Views: 2,339
Posted By cglax6
Being an owner of a Sniper, here's the best...

Being an owner of a Sniper, here's the best advice I can give you: Follow the directions from Holley to a T.

If you install it with 5/16" fuel line and you end up having fuel delivery issues and...
Jeep Forums: Jeep CJ Forum   07-21-2021, 07:33 AM
Replies: 17
Views: 1,868
Posted By cglax6
Do yourself a favor and replace the nuts on the...

Do yourself a favor and replace the nuts on the back of the speedo (the ones that hold it in) with wing-nuts...you'll thank me later.
Jeep Forums: Jeep CJ Forum   07-20-2021, 10:28 AM
Replies: 5
Views: 809
Posted By cglax6
Here's my plug: Replace them...even if you...

Here's my plug:

Replace them...even if you still have the body on.

If the body is off, it's pretty easy to replace with pre-formed lines. If you do that, get stainless.

If the body is on,...
Jeep Forums: Jeep CJ Forum   07-12-2021, 07:28 PM
Replies: 15
Views: 1,809
Posted By cglax6
You're right about that. Depending on how you...

You're right about that. Depending on how you install the extender, it takes about an extra 3/4" of extra throttle cable travel. I have an adjustable pedal, so it was a quick turn of a screw.

In...
Jeep Forums: Jeep CJ Forum   07-12-2021, 12:49 PM
Replies: 15
Views: 1,809
Posted By cglax6
I wouldn't recommend the progressive or...

I wouldn't recommend the progressive or adjustable progressive linkage. I tried it on mine, and after properly setting up the tables inside the Holly software, and was not happy with the results. I...
Jeep Forums: Jeep CJ Forum   07-12-2021, 09:55 AM
Replies: 5
Views: 469
Posted By cglax6
Gears are probably worn down from years of trying...

Gears are probably worn down from years of trying to engage while it's still spinning since it's not synchronized. 2 choices...

1. Ignore it and don't use 1st...starting from a stop in 2nd is...
Jeep Forums: Jeep CJ Forum   07-12-2021, 06:27 AM
Replies: 15
Views: 1,809
Posted By cglax6
I have a Sniper with Hyperspark ignition to...

I have a Sniper with Hyperspark ignition to control timing in my 351w swapped CJ5 and I couldn't be happier with it. I did a ton of research before purchasing and settled on the in-tank returnless...
Jeep Forums: Jeep CJ Forum   06-29-2021, 10:31 AM
Replies: 10
Views: 669
Posted By cglax6
The PO of my 76 CJ5 swapped in a 304, but did an...

The PO of my 76 CJ5 swapped in a 304, but did an awful job of rebuilding it. Well, at least he claimed that he rebuilt it. I knew I was going to replace it, but I wasn't sure with what. I've done...
Jeep Forums: Jeep CJ Forum   06-28-2021, 09:36 AM
Replies: 15
Views: 857
Posted By cglax6
I used the Holly Retrofit in-tank returnless...

I used the Holly Retrofit in-tank returnless pump. It's internally regulated @60psi, so no need for a return line off the Sniper. A lot of folks have been complaining about the regulator in the...
Jeep Forums: Jeep CJ Forum   06-28-2021, 07:18 AM
Replies: 38
Views: 6,547
Posted By cglax6
Those AFR numbers are pretty rich. Have you...

Those AFR numbers are pretty rich. Have you pulled the plugs to see what they look like? They'll tell you what you need to do with AFR. Honestly, you really need to get in touch with a remote...
Jeep Forums: Jeep CJ Forum   06-28-2021, 07:09 AM
Replies: 15
Views: 857
Posted By cglax6
I have mine screwed into the firewall next to the...

I have mine screwed into the firewall next to the battery and it's above the valve cover on the v8 I have in there, but it's a little offset. Other than having some electrical issue with the...
Jeep Forums: Jeep CJ Forum   06-09-2021, 11:21 AM
Replies: 5
Views: 428
Posted By cglax6
Behind the driver's side wheel well...there's a...

Behind the driver's side wheel well...there's a place to mount it. Under the tub, between the back of the wheel well and the rear of the tub...on the wheel well
Jeep Forums: Jeep CJ Forum   06-09-2021, 06:40 AM
Replies: 5
Views: 428
Posted By cglax6
You can get anything fuel system related from...

You can get anything fuel system related from MTS.

If you are talking about the check valve attached to the vent line, they sell those. I bought one for my 76 and works perfectly. Part number:...
Jeep Forums: Jeep CJ Forum   06-07-2021, 06:16 AM
Replies: 17
Views: 970
Posted By cglax6
I have a policy through American Collectors on my...

I have a policy through American Collectors on my 76 CJ5. Agreed value is $25k...I also have the same coverage on it as I do with all of my other vehicles because I drive it a good amount on busy...
Jeep Forums: Jeep CJ Forum   06-04-2021, 06:32 AM
Replies: 38
Views: 6,547
Posted By cglax6
EFISystemPro will answer any question that you...

EFISystemPro will answer any question that you have before you buy. I spent a good 3 hours on the phone with the owner of the company before I bought anything from him. They're just as...
Jeep Forums: Jeep CJ Forum   06-03-2021, 07:28 AM
Replies: 8
Views: 771
Posted By cglax6
I have mine coated in LINE-X premium and it looks...

I have mine coated in LINE-X premium and it looks great. The premium coating will keep its shine. The PO did a terrible job attempting to coat it in epoxy, and it was flaking off badly in places. ...
Jeep Forums: Jeep CJ Forum   05-31-2021, 10:13 AM
Replies: 38
Views: 6,547
Posted By cglax6
Do yourself a favor and call Magnecor and get a...

Do yourself a favor and call Magnecor and get a set from them. You won't get any RFI from them, which can be an issue with the Sniper.

Sent from my SM-G998U1 using Tapatalk
Jeep Forums: Jeep CJ Forum   05-22-2021, 11:54 AM
Replies: 8
Views: 776
Posted By cglax6
Never heard that the piping didn't hold up. I...

Never heard that the piping didn't hold up. I have a blind, autistic, nonverbal child whole loved to ride with me and he really beats it up. No complaints on them...

Sent from my SM-G998U1 using...
Jeep Forums: Jeep CJ Forum   05-22-2021, 11:11 AM
Replies: 8
Views: 776
Posted By cglax6
I got a set of daily drivers for mine last fall....

I got a set of daily drivers for mine last fall. I'm 6'1" and I'm glad I got the option for the taller back. I'm in SE Virginia and would melt in my old vinyl seats. I did the faux suede for the Grey...
Jeep Forums: Jeep CJ Forum   05-19-2021, 10:34 AM
Replies: 20
Views: 2,575
Posted By cglax6
Body lift has nothing to do with the length of...

Body lift has nothing to do with the length of your shocks. The shocks mount to the axle and the frame...not to the body. One way to figure out the correct length compressed and extended is to jack...
Showing results 1 to 20 of 116

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome