JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 183
Search took 0.03 seconds.
Search: Posts Made By: skjeep
Jeep Forums: Audio, CB & Ham Radios, GPS, & Electrical   09-08-2021, 03:52 AM
Replies: 0
Views: 343
Posted By skjeep
SBEC/SBECII internal schematics

hi,


please does anyone have an internal circuit diagram (not car wiring or connector) of the YJ ERA PCMs? The black one with 1 60pin connector.

There are several version of this from 1991...
Jeep Forums: TJ Wrangler Technical Forum   06-30-2021, 06:03 AM
Replies: 38
Views: 1,945
Posted By skjeep
Cam/Crank relearn is a bit different. It just...

Cam/Crank relearn is a bit different. It just resets the learned values for cam/crank sensor after a major repair. It is done with ignition on/engine off. Common on HEMIs or other later model...
Jeep Forums: TJ Wrangler Technical Forum   06-29-2021, 02:59 PM
Replies: 38
Views: 1,945
Posted By skjeep
very interesting thread... fought similar issues...

very interesting thread... fought similar issues some time ago. With Crown OPDA.
Mechanicaly everything perfect, solid timing chain, no wear anywhere... threw a code
DRB III displayed that the...
Jeep Forums: XJ Cherokee Technical Forum   06-11-2021, 09:19 AM
Replies: 12
Views: 892
Posted By skjeep
if you have a dremel or similar tool you could...

if you have a dremel or similar tool you could mill the rest out.
Ask your dentist for used dental milling bits These are from slined carbide and hard enough to mill out the broken extractorTakes a...
Jeep Forums: JK Wrangler Technical Forum   06-10-2021, 04:57 PM
Replies: 4
Views: 1,016
Posted By skjeep
stripped pan bolts on NAG 1 are quite common. So...

stripped pan bolts on NAG 1 are quite common. So are the thread repairs.
It is a 6mm metric thread. Helicoil (the "spring" insert) does not work quite well
Far better solution is to use solid ...
Jeep Forums: YJ Wrangler Technical Forum   06-10-2021, 04:52 PM
Replies: 10
Views: 577
Posted By skjeep
if it an fuel injected engine (post 90) then...

if it an fuel injected engine (post 90) then cruise from an XJ will bolt on
If its carbed 4.2 then iŽd look for some universal aftermarket solution
Jeep Forums: WK Grand Cherokee & XK Commander Forum   05-31-2021, 01:07 PM
Replies: 35
Views: 4,716
Posted By skjeep
Did not read the whole story, but before...

Did not read the whole story, but before replacing the PCM, chcek PCM connectors for corroded terminals. On CRD the PCM is under battery and acid fumes from the batt vent can eat it pretty badly....
Jeep Forums: ZJ Grand Cherokee Forum   05-28-2021, 02:52 PM
Replies: 5
Views: 895
Posted By skjeep
Just an update. Made an adapter for big 20 lbs...

Just an update.
Made an adapter for big 20 lbs reverse hammer to clamp the intermediate shaft and after few dozen of good whacks it came apart.
It separated at intermediate shaft snap ring so i...
Jeep Forums: XJ Cherokee Technical Forum   05-27-2021, 04:19 AM
Replies: 10
Views: 1,194
Posted By skjeep
SKIM is the same for both Euro and US version and...

SKIM is the same for both Euro and US version and in late XJs it is the same as in TJ or WJ. The only difference is in the communication bus architectrure.
XJ and early TJ uses CCD bus. Later TJ and...
Jeep Forums: XJ Cherokee Technical Forum   05-22-2021, 09:04 AM
Replies: 8
Views: 1,288
Posted By skjeep
if yours is an automatic then there should be...

if yours is an automatic then there should be allready a plugged hole near the brake booster.
There is a clutch master cylinder with manual trans
Jeep Forums: XJ Cherokee Technical Forum   05-20-2021, 03:09 PM
Replies: 5
Views: 730
Posted By skjeep
SBEC (SingleBoardEngineController) PCM of that...

SBEC (SingleBoardEngineController) PCM of that era is a quite sophisticated unit (for that time) It uses calculations instead of fixed maps for the engine control.
It does not need that signal to...
Jeep Forums: XJ Cherokee Technical Forum   05-19-2021, 01:26 PM
Replies: 10
Views: 1,194
Posted By skjeep
What earlier chips do you mean? SKIM was...

What earlier chips do you mean? SKIM was introduced in 1998, for XJ from MY 1999. So that is the first generation

Up to 1998 the security system was tied to RKE, not key.




And yes, you...
Jeep Forums: ZJ Grand Cherokee Forum   05-19-2021, 06:57 AM
Replies: 5
Views: 895
Posted By skjeep
wingless can not take pics right now, but on...

wingless
can not take pics right now, but on your picture there is an intermediate shaft with outer shell in the front (that metal dish with teeth)
The input shaft with front and rear clutches goes...
Jeep Forums: XJ Cherokee Technical Forum   05-19-2021, 06:31 AM
Replies: 10
Views: 1,194
Posted By skjeep
Yes but being a 2001 it has a SKIM security key...

Yes but being a 2001 it has a SKIM security key with chip.
So the best way how to do it is to buy a new uncoded ignition lock cylinder and have it coded for the original key.
Any locksmith should...
Jeep Forums: XJ Cherokee Technical Forum   05-18-2021, 03:50 PM
Replies: 10
Views: 1,194
Posted By skjeep
I think that the ignition lock is so worn out,...

I think that the ignition lock is so worn out, that you are able to pull the key out of it in the "minus 1 position"
That way remains your accessory under power without a key.
So do not turn the...
Jeep Forums: JK Wrangler Technical Forum   05-18-2021, 03:45 PM
Replies: 48
Views: 155,329
Posted By skjeep
I am also in. :( After 2 days of heavy rain...

I am also in. :(

After 2 days of heavy rain i have a visible water run down the B-pillar on both sides
The mucket seals are new, door weatherstrips also, middle freedom top seal new....
I have...
Jeep Forums: ZJ Grand Cherokee Forum   05-18-2021, 03:10 PM
Replies: 5
Views: 895
Posted By skjeep
Tryed to search, but no avail :( The only...

Tryed to search, but no avail :(

The only info i found is to place a 1/2" thick plywood sheet on the ground and drop the drum assy from aproox 3 feet against the plywood and repeat until the...
Jeep Forums: ZJ Grand Cherokee Forum   05-18-2021, 01:53 PM
Replies: 5
Views: 895
Posted By skjeep
44RE transmission - problem with disassembly

Hi all


as allready written in the thread title, i have a problem with disassembly of a 44RE (A500) transmission out of a 5.2 ZJ.
Standard teardown procedure is done (pan, OD unit, valvebody,...
Jeep Forums: WJ Grand Cherokee Forum   03-11-2021, 05:14 AM
Replies: 29
Views: 1,986
Posted By skjeep
Jeepinpgh it depends on situation. As a first i...

Jeepinpgh
it depends on situation. As a first i have to say that failed PCM is the last resort. At least today. These are build to outlast most of the components.
Most of the time the way how these...
Jeep Forums: WJ Grand Cherokee Forum   03-10-2021, 02:58 PM
Replies: 29
Views: 1,986
Posted By skjeep
Nazimuss great you did the pcm repair. To be...

Nazimuss
great you did the pcm repair. To be sure for the future, check the 4 big connectors on both sides of lower dash for corrosion. 2of them are on left side near fuse box and 2 are on rigt...
Showing results 1 to 20 of 183

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome