JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 78
Search took 0.02 seconds.
Search: Posts Made By: RVC
Jeep Forums: TJ Wrangler Technical Forum   10-14-2013, 06:30 PM
Replies: 4
Views: 491
Posted By RVC
I just figured it out....it has been raining alot...

I just figured it out....it has been raining alot and the jeep was sitting for a week and the clutch siezed to the flywheel. I started it in gear and it popped and now it works fine...crazy.
Jeep Forums: TJ Wrangler Technical Forum   10-14-2013, 06:11 PM
Replies: 4
Views: 491
Posted By RVC
Clutch just stopped working....

So today I went to move my jeep and it would not go into gear. I checked the fluid and it was full, the clutch felt normal. So I put it into gear held the clutch in and bumped the starter and the...
Jeep Forums: TJ Wrangler Technical Forum   10-01-2013, 02:29 PM
Replies: 1
Views: 451
Posted By RVC
Water in fuel tank maybe?

Water in fuel tank maybe?
Jeep Forums: TJ Wrangler Technical Forum   10-01-2013, 08:55 AM
Replies: 1
Views: 451
Posted By RVC
Yet another sputtering, hitching, missing, and backfiring thread!!

So I have done alot of reading and figured I had a problem with my upstream o2 sensors. My Jeep runs like crap, it has lost power and misses, bucks, and sputters. It idles fine and does not miss...
Jeep Forums: TJ Wrangler Technical Forum   04-29-2012, 09:49 AM
Replies: 26
Views: 1,669
Posted By RVC
Scam...

Scam...
Jeep Forums: TJ Wrangler Technical Forum   04-29-2012, 12:16 AM
Replies: 5
  gauges
Views: 499
Posted By RVC
It you have tow package check wiring harness that...

It you have tow package check wiring harness that connects to the trailer...I pinched mine between a rock and the bumper and it cut the harness and shorted it out causing all kinds of problems with...
Jeep Forums: TJ Wrangler Technical Forum   04-28-2012, 11:25 PM
Replies: 13
Views: 730
Posted By RVC
Yeah you were right, it was not too bad so I just...

Yeah you were right, it was not too bad so I just got the switch and it works...the only problem is that is is stuck on defrost. Won't shift to face or floor. Any ideas?
Jeep Forums: TJ Wrangler Technical Forum   04-28-2012, 02:07 PM
Replies: 13
Views: 730
Posted By RVC
Mine is the rotary panel...behind the mode...

Mine is the rotary panel...behind the mode control switch is where it is melted.
Jeep Forums: TJ Wrangler Technical Forum   04-28-2012, 01:21 PM
Replies: 13
Views: 730
Posted By RVC
Yes the whole panel is melted.

Yes the whole panel is melted.
Jeep Forums: TJ Wrangler Technical Forum   04-28-2012, 11:59 AM
Replies: 13
Views: 730
Posted By RVC
Thanks for the info, I will do the relay mod but...

Thanks for the info, I will do the relay mod but my control panel is trashed. Will the 05-06 panel work in he 99? Thanks!
Jeep Forums: TJ Wrangler Technical Forum   04-28-2012, 11:45 AM
Replies: 13
Views: 730
Posted By RVC
Just the mode control. I have fixed it once but...

Just the mode control. I have fixed it once but now it's done for good!
Jeep Forums: TJ Wrangler Technical Forum   04-28-2012, 11:30 AM
Replies: 13
Views: 730
Posted By RVC
99' blower motor control panel

I was looking to replace my heater/ac control panel, it's melted in the back. I was looking online and I found one for a 99-04 for around $100 ant one for an 05-06 for around $60. They look the...
Jeep Forums: TJ Wrangler Technical Forum   10-26-2011, 10:21 AM
Replies: 9
Views: 5,128
Posted By RVC
Control arm bushings probably could use some...

Control arm bushings probably could use some attention. It is not in 4wd for sure. I will check the wheel bearings. U- joints have recently been replaced but i will re- check them. How about the...
Jeep Forums: TJ Wrangler Technical Forum   10-25-2011, 10:44 PM
Replies: 9
Views: 5,128
Posted By RVC
Steering wheel shakes only when turning.

As the title says the steering wheel shakes back and forth only when turning. It does not do it when driving straight. Its got new ball joints, steering stabilizer, and new adjustable track bar. ...
Jeep Forums: TJ Wrangler Technical Forum   10-19-2010, 09:27 PM
Replies: 4
Views: 522
Posted By RVC
It was the switches.....

It was the switches.....
Jeep Forums: TJ Wrangler Technical Forum   10-19-2010, 07:22 AM
Replies: 4
Views: 522
Posted By RVC
Which connectors are you speaking of?

Which connectors are you speaking of?
Jeep Forums: TJ Wrangler Technical Forum   10-18-2010, 08:10 PM
Replies: 4
Views: 522
Posted By RVC
Another electrical issue

Well my wipers and turn signals just quit working on my 1999 TJ, they were working yesterday! Fuses are good, trailer hitch wiring good, all other lights and electronics work fine. The only other...
Jeep Forums: TJ Wrangler Technical Forum   08-17-2010, 07:53 AM
Replies: 7
Views: 585
Posted By RVC
Thanks guys, I will replace the multi function...

Thanks guys, I will replace the multi function switch and check to make sure the correct bulbs are installed.
Jeep Forums: TJ Wrangler Technical Forum   08-16-2010, 10:13 AM
Replies: 7
Views: 585
Posted By RVC
Anyone? Bump....

Anyone? Bump....
Jeep Forums: TJ Wrangler Technical Forum   08-15-2010, 06:32 PM
Replies: 7
Views: 585
Posted By RVC
Unusual dash board problem

Ok, this just started. My turn signals stopped working but my hazards work but when the hazards are on the odometer blinks too. When i put the brakes on the odometer goes out. The blinkers...
Showing results 1 to 20 of 78

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome