JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.06 seconds.
Search: Posts Made By: 90DesertTanYJ
Jeep Forums: YJ Wrangler Technical Forum   06-12-2014, 04:35 AM
Replies: 13
Views: 942
Posted By 90DesertTanYJ
If the arm still has the dog leg that attaches to...

If the arm still has the dog leg that attaches to the pipe get another hose clamp and clamp it around the pipe and dog leg. If the dog leg is gone, find another hanger that will work and clamp it...
Jeep Forums: YJ Wrangler Technical Forum   06-12-2014, 04:28 AM
Replies: 12
Views: 708
Posted By 90DesertTanYJ
Yep, clean out the tank and fuel lines. Check...

Yep, clean out the tank and fuel lines. Check fuel pressure, check spark. Air+fuel+spark=crank most of the time!
Jeep Forums: YJ Wrangler Technical Forum   06-09-2014, 04:20 AM
Replies: 5
Views: 627
Posted By 90DesertTanYJ
Just run a ground to the frame and one to the...

Just run a ground to the frame and one to the tub. Should solve your issues.
Jeep Forums: YJ Wrangler Technical Forum   06-09-2014, 04:15 AM
Replies: 3
Views: 632
Posted By 90DesertTanYJ
Doesnt sound OEM to me. I know of no wires that...

Doesnt sound OEM to me. I know of no wires that come out of the Rside firewall. Starter solenoid wires come from the battery, the starter switch mounted to the Rside firewall and the wire loom that...
Jeep Forums: YJ Wrangler Technical Forum   06-08-2014, 11:30 AM
Replies: 13
Views: 942
Posted By 90DesertTanYJ
Go to Home Depot to the plumbing department and...

Go to Home Depot to the plumbing department and get a stainless steel no hub band. Chuck the rubber part and undo the band part. Wrap it around the hole and tighten up the clamps. Fixed. Cost...
Jeep Forums: YJ Wrangler Technical Forum   06-08-2014, 11:09 AM
Replies: 12
  Tester
Views: 853
Posted By 90DesertTanYJ
:laugh: Good luck with that!

:laugh: Good luck with that!
Jeep Forums: YJ Wrangler Technical Forum   06-08-2014, 11:06 AM
Replies: 5
Views: 627
Posted By 90DesertTanYJ
I would bet on a dirty ground somewhere but get a...

I would bet on a dirty ground somewhere but get a DVM and check the alternator output. It should put out well above 13 volts.

Good luck!
Jeep Forums: YJ Wrangler Technical Forum   06-08-2014, 11:01 AM
Replies: 8
Views: 692
Posted By 90DesertTanYJ
Uh oh, you are truly f**ked if it isnt a BesTop...

Uh oh, you are truly f**ked if it isnt a BesTop Replace-a-top. BesTop is totally proprietary, using their own one of a kind hardware. And its expensive, a whole lot less likely to find in the used...
Jeep Forums: YJ Wrangler Technical Forum   05-17-2014, 06:26 AM
Replies: 8
Views: 797
Posted By 90DesertTanYJ
Your engine will run at its normal temp no matter...

Your engine will run at its normal temp no matter what thermo you install in it. If it normally runs at 210* it will always run at 210*. Now if for some reason it normally runs at 180* and you put...
Jeep Forums: Wrangler General Discussion   05-17-2014, 06:01 AM
Replies: 33
Views: 12,685
Posted By 90DesertTanYJ
I thank the JF folks who have explain why the...

I thank the JF folks who have explain why the flag is "backwards" on military uniforms and other forward moving situations like the Jeep decal. I always wondered because I was taught the Union is...
Jeep Forums: Wrangler General Discussion   05-17-2014, 04:50 AM
Replies: 2
Views: 482
Posted By 90DesertTanYJ
I thought it never rained in SoCal!!!

I thought it never rained in SoCal!!!
Jeep Forums: YJ Wrangler Technical Forum   05-16-2014, 06:39 PM
Replies: 14
Views: 748
Posted By 90DesertTanYJ
A FSM will have a pic of all connectors and the...

A FSM will have a pic of all connectors and the color of the wires going to it. I can check my 90 FSM if you give me the color of the wires. It may be the same.
Jeep Forums: YJ Wrangler Technical Forum   05-16-2014, 06:26 PM
Replies: 5
Views: 560
Posted By 90DesertTanYJ
No this is a hot air outlet.

No this is a hot air outlet.
Jeep Forums: YJ Wrangler Technical Forum   04-02-2014, 08:47 PM
Replies: 22
Views: 1,982
Posted By 90DesertTanYJ
Make sure when you tackle it to replace the seal...

Make sure when you tackle it to replace the seal sealer with something so you wont have water coming in on your feet.
Jeep Forums: YJ Wrangler Technical Forum   03-20-2014, 03:46 AM
Replies: 24
Views: 1,973
Posted By 90DesertTanYJ
Running the exhaust out the side will help. ...

Running the exhaust out the side will help. Maybe not solve but will help. Make sure the end of the pipe clears the body by a couple of inches as well.
Jeep Forums: YJ Wrangler Technical Forum   03-19-2014, 03:46 AM
Replies: 13
Views: 1,412
Posted By 90DesertTanYJ
Everybody has provided the answers you need so I...

Everybody has provided the answers you need so I will just add if you really want to learn your YJ stem to stern amd plan on doing some of your own work, go ahead and find a Factory Service Manual...
Jeep Forums: YJ Wrangler Technical Forum   03-19-2014, 03:36 AM
Replies: 29
Views: 3,623
Posted By 90DesertTanYJ
BesTop makes some of the best but remember if you...

BesTop makes some of the best but remember if you buy one of their tops with frame hardware you will ALWAYS have to reskin with BesTop products as they are proprietary and very expensive to replace. ...
Jeep Forums: Wrangler General Discussion   03-17-2014, 07:04 AM
Replies: 6
Views: 653
Posted By 90DesertTanYJ
Its just practice. I still stall out every now...

Its just practice. I still stall out every now and then. Let her know that even experienced clutch drivers will stall every now and then.
Jeep Forums: Wrangler General Discussion   03-17-2014, 06:39 AM
Replies: 7
Views: 685
Posted By 90DesertTanYJ
I know how that guy feels and what he sees every...

I know how that guy feels and what he sees every day. I start at 7am and leave the shop around 8am so I get to sit in bumper to bumper. I too wish people would see the "big picture". A little...
Jeep Forums: YJ Wrangler Technical Forum   03-16-2014, 03:55 PM
Replies: 3
Views: 635
Posted By 90DesertTanYJ
You can carefully drill a hole in the leftover...

You can carefully drill a hole in the leftover portion and thread a screw into it and hopefully be able to pull out the rest of it. If not you will need a steering wheel puller and a lock plate...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome