JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.06 seconds.
Search: Posts Made By: jeepdaddy2000
Jeep Forums: Engines & Drivetrain   Yesterday, 11:08 PM
Replies: 5
Views: 223
Posted By jeepdaddy2000
With all emission controls removed, vacuum from...

With all emission controls removed, vacuum from the ported nipple on the carburetor runs directly to the distributor. The vacuum signal is controlled by the throttle plate position. A properly tuned...
Jeep Forums: Jeep CJ Forum   Yesterday, 08:45 AM
Replies: 7
Views: 380
Posted By jeepdaddy2000
The mid plate is designed not only to eliminate...

The mid plate is designed not only to eliminate the need to surface the pump flat but also to give a hard surface for the gears to run on. The only concern is the added gasket that may leak.

...
Jeep Forums: Engines & Drivetrain   10-21-2020, 09:01 PM
Replies: 3
Views: 140
Posted By jeepdaddy2000
Impossible to tell without having some idea how...

Impossible to tell without having some idea how hot it got. I suggest you fill it with water and inspect for leaks. If none, then test drive it a while. If the engine runs fine and there isn't water...
Jeep Forums: Jeep CJ Forum   10-21-2020, 08:48 PM
Replies: 18
Views: 513
Posted By jeepdaddy2000
There is nothing exact about the knuckle arm. If...

There is nothing exact about the knuckle arm. If other options fail, I wouldn't hesitate to heat it up cherry red and bend it back as close as possible. As long as there aren't any cracks, it should...
Jeep Forums: Jeep CJ Forum   10-21-2020, 05:33 AM
Replies: 18
Views: 513
Posted By jeepdaddy2000
I would love to see the actual knuckle damage. ...

I would love to see the actual knuckle damage.

Does the frame need to be checked?
Jeep Forums: Engines & Drivetrain   10-20-2020, 05:42 AM
Replies: 5
Views: 223
Posted By jeepdaddy2000
Engines in their most basic forms require intake...

Engines in their most basic forms require intake vacuum for the PCV valve, choke hot air (if equipped), and vacuum advance (ported). There may also be a need for vacuum to the brakes.
Jeep Forums: Engines & Drivetrain   10-20-2020, 05:35 AM
Replies: 1
Views: 130
Posted By jeepdaddy2000
All later CJ drum brakes had a cable adjusted...

All later CJ drum brakes had a cable adjusted self adjusting brakes. Be sure to inspect the adjusters, as they have a tendency to freeze and the adjuster will ruin the teeth.

You might want to do...
Jeep Forums: Jeep CJ Forum   10-20-2020, 05:23 AM
Replies: 5
Views: 320
Posted By jeepdaddy2000
The AIR system is stand alone and doesn't effect...

The AIR system is stand alone and doesn't effect the intake mixture. You can remove it in it's entirety without having to adjust anything.
I suggest you keep the entire system so if (when:frown2:)...
Jeep Forums: General Jeep & Off-Road Equipment   10-18-2020, 07:24 AM
Replies: 4
Views: 289
Posted By jeepdaddy2000
Your biggest issue is emission law. Be sure your...

Your biggest issue is emission law. Be sure your state supports your upgrades and looks to maintain your ability to run that configuration for a while longer. Whatever you do, don't throw anything...
Jeep Forums: Jeep CJ Forum   10-17-2020, 07:39 AM
Replies: 9
Views: 557
Posted By jeepdaddy2000
The first thing to do is find the leak. Locate...

The first thing to do is find the leak. Locate where the puddle is and work back from there.
Under the body: heater core. Usually accompanied with fogging of the windshield with the defroster on and...
Jeep Forums: Engines & Drivetrain   10-16-2020, 08:42 PM
Replies: 2
Views: 186
Posted By jeepdaddy2000
looks like this

looks like this
Jeep Forums: Jeep CJ Forum   10-16-2020, 08:33 PM
Replies: 7
Views: 271
Posted By jeepdaddy2000
You can also rock the engine in gear. This can...

You can also rock the engine in gear. This can also release a stuck Bendix drive.
On a side note, live the pict of the hand crank. I had a 67 Nissan Patrol many years ago. Lost the solenoid and...
Jeep Forums: Jeep CJ Forum   10-16-2020, 08:25 PM
Replies: 14
Views: 905
Posted By jeepdaddy2000
So, in order to center your box, you will have...

So, in order to center your box, you will have to:
drop the drag link.
Turn the steering lock to lock.
Rotate back 1/2 the number to turns. This will be the center of the box. You should fee/seel...
Jeep Forums: Jeep CJ Forum   10-16-2020, 05:59 AM
Replies: 2
Views: 223
Posted By jeepdaddy2000
I can help with picture 2 and 4. The capped...

I can help with picture 2 and 4.

The capped pipe in #4 should be connected to the intake in #2. This is the fresh air intake for the choke heating tube bolted into the intake manifold choke tube...
Jeep Forums: Jeep CJ Forum   10-15-2020, 10:45 PM
Replies: 24
Views: 3,885
Posted By jeepdaddy2000
My wife runs spacers on her Z3 M series with no...

My wife runs spacers on her Z3 M series with no issues (and we push it a bit>:)). I would have no issues running a set on a CJ.
Jeep Forums: Engines & Drivetrain   10-14-2020, 05:56 AM
Replies: 2
Views: 136
Posted By jeepdaddy2000
Rotational creaking is the first sign of loose...

Rotational creaking is the first sign of loose lug nuts. I would start there.
Jeep Forums: Engines & Drivetrain   10-12-2020, 11:13 PM
Replies: 11
Views: 566
Posted By jeepdaddy2000
No block/crank is going to fail with a stock...

No block/crank is going to fail with a stock setup, baring a manufacturing flaw or massive driver abuse. Modern engines are also protected by the computer, which limits RPM and controls ignition and...
Jeep Forums: Jeep CJ Forum   10-12-2020, 10:34 PM
Replies: 11
Views: 589
Posted By jeepdaddy2000
Park brake engaged and foot on the brake. I have...

Park brake engaged and foot on the brake. I have no issues falling under a rig and observe the driveline, u joints, pinion yoke, and pinpoint a noise.

He is looking for a clunk, meaning all...
Jeep Forums: Engines & Drivetrain   10-12-2020, 06:10 AM
Replies: 11
Views: 566
Posted By jeepdaddy2000
Tough question to answer. Since you are looking...

Tough question to answer. Since you are looking at stock configurations (no afterrmarket support) I'd be hard pressed to see where one could overtax the existing architecture without adding massive...
Jeep Forums: General Jeep & Off-Road Equipment   10-12-2020, 05:58 AM
Replies: 4
Views: 280
Posted By jeepdaddy2000
Is the width the issue or the weight capacity?...

Is the width the issue or the weight capacity? Motorcycle/ATV/UTV ratchet straps come in a variety of sizes and lengths, including multiple short side strap configurations.

Can you loop the end...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome