JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.05 seconds.
Search: Posts Made By: Billwill
Jeep Forums: KJ Liberty Forum   11-02-2017, 10:02 AM
Replies: 4
Views: 406
Posted By Billwill
Can we just clear up the SKIS Red LED.....it...

Can we just clear up the SKIS Red LED.....it should go ON for a few seconds when ignition is turned ON then it should go OFF. If this LED stays ON or flashes ON/OFF all the time when ignition is ON...
Jeep Forums: KJ Liberty Forum   11-02-2017, 03:20 AM
Replies: 4
Views: 406
Posted By Billwill
OK when you jumper pins 30 and 87 together inside...

OK when you jumper pins 30 and 87 together inside the starter relay socket the engine turns over.

At this time do you have the ignition switched ON? Must be On for engine to fire.

You sure your...
Jeep Forums: KJ Liberty Forum   11-01-2017, 06:54 AM
Replies: 17
Views: 4,690
Posted By Billwill
OK so are you still getting the No Bus Error? ...

OK so are you still getting the No Bus Error?

Which flow chart are you following? My copy of the 2002 KJ Service Manual I downloaded years ago for the 2002 KJ from...
Jeep Forums: KJ Liberty Forum   10-31-2017, 01:32 AM
Replies: 17
Views: 4,690
Posted By Billwill
I doubt that the 2002 KJ came with tire pressure...

I doubt that the 2002 KJ came with tire pressure sensors.

Maybe refit your original cluster if you still have it?

Anyhow at least it looks like dirty fuse connections were your problem.....good...
Jeep Forums: KJ Liberty Forum   10-30-2017, 07:14 AM
Replies: 17
Views: 4,690
Posted By Billwill
Check page 8Wa-18-1 in the wiring...

Check page 8Wa-18-1 in the wiring diagrams....shows where the PCI bus goes.

Also shows that Fuse #33 on the interior fuse panel is involved....check and re-plug that fuse.

I agree with jtect...
Jeep Forums: KJ Liberty Forum   10-30-2017, 05:02 AM
Replies: 17
Views: 4,690
Posted By Billwill
Yes this is a very difficult problem to try...

Yes this is a very difficult problem to try find....you may end up replacing virtually all the modules in the Jeep at great expense while somewhere the Bus wire is intermittently chafing through to...
Jeep Forums: KJ Liberty Forum   10-29-2017, 02:54 AM
Replies: 1
Views: 272
Posted By Billwill
Fuse 22 on the interior fuse panel may be...

Fuse 22 on the interior fuse panel may be relevant.

There is a micro-switch on the rear door handle that gives problems and also one in the flip-up window.

I do not have 2007 wiring diagrams...
Jeep Forums: KJ Liberty Forum   10-29-2017, 02:43 AM
Replies: 17
Views: 4,690
Posted By Billwill
If you look at the wiring diagram page 8Wa-43-2...

If you look at the wiring diagram page 8Wa-43-2 you will see that the airbag control module does have the PCI bus going into it....a Yellow/Violet/Orange wire....so it is probably again related to a...
Jeep Forums: KJ Liberty Forum   10-28-2017, 01:21 AM
Replies: 17
Views: 4,690
Posted By Billwill
"No Bus" errors are very difficult to find. The...

"No Bus" errors are very difficult to find. The Bus on the 2002 models is a serial PCI bus that runs around the whole vehicle....it sends and receives serial data to and from various components.
...
Jeep Forums: KJ Liberty Forum   10-27-2017, 05:35 AM
Replies: 5
Views: 1,596
Posted By Billwill
You can remove the Fuel Pump Relay and inside the...

You can remove the Fuel Pump Relay and inside the empty relay socket locate pins 30 and 87 and jumper them together...you should hear the pump run.

You should have the red LED for the SKIS...
Jeep Forums: KJ Liberty Forum   10-21-2017, 01:24 AM
Replies: 6
Views: 2,095
Posted By Billwill
The fuse panel inside the cabin is actually...

The fuse panel inside the cabin is actually called the Junction Block.

If you remove it and flip it over you will see a whole lot of relays...not marked.

You can download the 2006 KJ Service...
Jeep Forums: KJ Liberty Forum   10-21-2017, 01:05 AM
Replies: 11
Views: 934
Posted By Billwill
Definitely replace the clockspring to fix your...

Definitely replace the clockspring to fix your airbag problem and cruise control problem but SKIS and wipers do not go through there...possibly the clockspring itself is OK but leads going to it are...
Jeep Forums: KJ Liberty Forum   10-19-2017, 03:14 AM
Replies: 4
Views: 454
Posted By Billwill
If the SKIS system is failing ie. the RED LED on...

If the SKIS system is failing ie. the RED LED on left of cluster is flashing or is ON solid then there is a problem with the SKIS system...if this RED LED goes off after a few seconds then that is...
Jeep Forums: KJ Liberty Forum   10-19-2017, 02:46 AM
Replies: 11
Views: 934
Posted By Billwill
I am a bit confused as to what you did originally...

I am a bit confused as to what you did originally replace but the theory is as follows as to how the SKIS system works.

The chipped key talks to the SKIM module that sits at the top of the...
Jeep Forums: KJ Liberty Forum   10-13-2017, 03:48 AM
Replies: 4
Views: 1,864
Posted By Billwill
The daytime driving light feature is only for...

The daytime driving light feature is only for Canada so your USA model will not have this large relay with heat fins on it....I am presuming St Augustine is in the USA?
Jeep Forums: KJ Liberty Forum   10-09-2017, 09:22 AM
Replies: 3
Views: 407
Posted By Billwill
I doubt it has anything to do with the high beam...

I doubt it has anything to do with the high beam switch...turning on the high beams lets the BCM know that someone is in control so the BCM probably decides to turn off the Dome lights.

I agree...
Jeep Forums: KJ Liberty Forum   10-09-2017, 09:02 AM
Replies: 4
Views: 1,864
Posted By Billwill
The internal fuse panel is actually the Junction...

The internal fuse panel is actually the Junction Module.....you will notice on the bottom of the panel a relay which is the High Beam Relay..on the reverse side of this Junction Module are more...
Jeep Forums: KJ Liberty Forum   10-07-2017, 08:57 AM
Replies: 7
Views: 443
Posted By Billwill
When you say "it wont crank" do you mean the...

When you say "it wont crank" do you mean the engine does not turn over with the ignition key?

You need to rotate the engine manualy with a large spanner on the crankshaft end to check that it has...
Jeep Forums: KJ Liberty Forum   09-28-2017, 11:51 PM
Replies: 3
Views: 398
Posted By Billwill
NGK plugs are the most recommened plugs if gapped...

NGK plugs are the most recommened plugs if gapped properly.

What codes are you getting?
Jeep Forums: KJ Liberty Forum   09-23-2017, 12:27 AM
Replies: 3
Views: 416
Posted By Billwill
Make sure when you buy a new Multifunction Switch...

Make sure when you buy a new Multifunction Switch as it is named that there are two different types...one for KJs fitted with front fog lights and one for KJs without front fog lights.
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome