JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.03 seconds.
Search: Posts Made By: chance_p
Jeep Forums: WK Grand Cherokee & XK Commander Forum   11-01-2017, 10:14 PM
Replies: 21
Views: 34,599
Posted By chance_p
That is usually indicative of bad wheel bearings....

That is usually indicative of bad wheel bearings. As you "load" and "unload" the wheel bearings by swerving the bearing will get louder/quieter.
Jeep Forums: WK Grand Cherokee & XK Commander Forum   09-27-2017, 09:14 PM
Replies: 8
Views: 722
Posted By chance_p
4 low. 4hi, no go.

4 low. 4hi, no go.
Jeep Forums: WK Grand Cherokee & XK Commander Forum   09-15-2017, 01:13 PM
Replies: 3
Views: 280
Posted By chance_p
Install rear lift minus track bar. Set vehicle...

Install rear lift minus track bar. Set vehicle down on the ground and rock it side to side. Should center itself over the axle. Then adjust the bar until it lines up with the holes.



If it...
Jeep Forums: WK Grand Cherokee & XK Commander Forum   08-31-2017, 09:11 PM
Replies: 5
Views: 399
Posted By chance_p
Did you tighten all of the bolts with the vehicle...

Did you tighten all of the bolts with the vehicle on the ground or in the air?
Jeep Forums: WK Grand Cherokee & XK Commander Forum   08-21-2017, 05:40 PM
Replies: 2
Views: 275
Posted By chance_p
I have a similar problem. grinding noise at...

I have a similar problem. grinding noise at 35mph+, vibration starts at 45mph but only when i am on the accelerator. When I let off the accelerator the vibes go away but the grinding remains. It's...
Jeep Forums: WK Grand Cherokee & XK Commander Forum   08-14-2017, 07:14 PM
Replies: 5
Views: 318
Posted By chance_p
If nitro advertises their 4.10 gear set to work...

If nitro advertises their 4.10 gear set to work with either open or LSD, I would GUESS that the factory 3.73s work with either. key word, GUESS.
Jeep Forums: WK Grand Cherokee & XK Commander Forum   08-11-2017, 06:13 PM
Replies: 22
Views: 7,881
Posted By chance_p
About 4". My cv shafts are almost perfectly...

About 4". My cv shafts are almost perfectly "flat". The diff drop does rotate your pinion upwards slightly, so probably only 3.5" lower at the pinion.
Jeep Forums: WK Grand Cherokee & XK Commander Forum   08-11-2017, 10:48 AM
Replies: 22
Views: 7,881
Posted By chance_p
If you have the superlift kit, you lower the...

If you have the superlift kit, you lower the front differential.
Jeep Forums: WK Grand Cherokee & XK Commander Forum   08-11-2017, 08:45 AM
Replies: 22
Views: 7,881
Posted By chance_p
Superlift

Superlift
Jeep Forums: WK Grand Cherokee & XK Commander Forum   08-04-2017, 11:52 PM
Replies: 7
Views: 480
Posted By chance_p
When the rumbling started, could you feel it in...

When the rumbling started, could you feel it in the floorboard?
Jeep Forums: WK Grand Cherokee & XK Commander Forum   08-02-2017, 08:22 AM
Replies: 25
Views: 2,766
Posted By chance_p
I work about a half-mile from where your avatar...

I work about a half-mile from where your avatar picture was taken lol.
Jeep Forums: WK Grand Cherokee & XK Commander Forum   08-01-2017, 10:13 PM
Replies: 25
Views: 2,766
Posted By chance_p
Just noticed your location. Are you local to me?

Just noticed your location. Are you local to me?
Jeep Forums: WK Grand Cherokee & XK Commander Forum   07-25-2017, 09:49 PM
Replies: 10
Views: 595
Posted By chance_p
I have the same issue. Noise starts lightly at...

I have the same issue. Noise starts lightly at 20mph and gets worse at 35mph. Vibration kicks in around 50mph
Jeep Forums: WK Grand Cherokee & XK Commander Forum   07-12-2017, 10:17 PM
Replies: 25
Views: 2,766
Posted By chance_p
Imo you should have tom woods build you a...

Imo you should have tom woods build you a serviceable driveshaft with a double cardan at the transfercase.

Youre getting different part numbers due to the differenr length/front pinion options....
Jeep Forums: WK Grand Cherokee & XK Commander Forum   07-09-2017, 07:30 PM
Replies: 8
Views: 493
Posted By chance_p
Can you feel it in the floor board in your feet?...

Can you feel it in the floor board in your feet? Im dealing with a similar situation and i can feel it in my feet starting around 33MPH
Jeep Forums: WK Grand Cherokee & XK Commander Forum   06-29-2017, 11:21 PM
Replies: 9
Views: 578
Posted By chance_p
Thats awesome! I bet the price was pretty good...

Thats awesome! I bet the price was pretty good too eh?
Jeep Forums: WK Grand Cherokee & XK Commander Forum   06-29-2017, 08:08 PM
Replies: 18,514
Views: 1,834,814
Posted By chance_p
Ummmm what washer? ...damnit

Ummmm what washer? ...damnit
Jeep Forums: WK Grand Cherokee & XK Commander Forum   06-27-2017, 02:30 PM
Replies: 9
Views: 578
Posted By chance_p
Well when i bought my superlift i called to...

Well when i bought my superlift i called to complain about the design of the lower control arms and they refunded my the "value" of the arms. It was over $300, so if you might as well just make some...
Jeep Forums: WK Grand Cherokee & XK Commander Forum   06-27-2017, 08:04 AM
Replies: 9
Views: 578
Posted By chance_p
That lower measurement seems close. The upper, i...

That lower measurement seems close. The upper, i am not so sure of. I have the entire SL kit so my upper control arm mounts on my axle are relocated with brackets, meaning my uppers are shorter than...
Jeep Forums: WK Grand Cherokee & XK Commander Forum   06-26-2017, 10:57 PM
Replies: 9
Views: 578
Posted By chance_p
I run iron rock offroad WJ lowers and custom made...

I run iron rock offroad WJ lowers and custom made uppers with heim joints at the axle. You *should* be able to run ZJ/TJ rear uppers on the back of the WK. Factory wk upper length is 16.125". Make...
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome