JeepForum.com - Search Results
Advanced Search
Showing results 1 to 20 of 250
Search took 0.03 seconds.
Search: Posts Made By: Fourtrail
Jeep Forums: Jeep CJ Forum   09-23-2021, 03:43 PM
Replies: 3
Views: 380
Posted By Fourtrail
How much drop is on the transfercase...

How much drop is on the transfercase crossmember/skidplate? If there is a big drop, then yes, the shifter boot and possibly interference with the tub can cause the problem you are having from...
Jeep Forums: Jeep CJ Forum   09-23-2021, 07:40 AM
Replies: 10
Views: 625
Posted By Fourtrail
Leave that small hole open, you have to let air...

Leave that small hole open, you have to let air in and out of the slip as the driveshaft extends/compresses. The plug I was talking about is the silver disc in the center. 5 pumps is a good...
Jeep Forums: Jeep CJ Forum   09-22-2021, 12:10 PM
Replies: 27,888
Views: 2,327,987
Posted By Fourtrail
Double throw switch, one way always on, center...

Double throw switch, one way always on, center off, other way functions with the headlights. Looks just like a normal switch at inspection.
Jeep Forums: Jeep CJ Forum   09-22-2021, 07:05 AM
Replies: 10
Views: 625
Posted By Fourtrail
It doesn't make a difference, but most times the...

It doesn't make a difference, but most times the slip goes at the axle.
Jeep Forums: Engines & Drivetrain   09-21-2021, 10:56 PM
Replies: 1
Views: 389
Posted By Fourtrail
Sounds like the security system. Look into VTSS...

Sounds like the security system. Look into VTSS and the SKIM. You are using the correct key with the big grey head, not a generic cut key to start it?
Jeep Forums: Jeep CJ Forum   09-21-2021, 10:29 PM
Replies: 2
Views: 562
Posted By Fourtrail
Looks like a combination of multiple Jeeps there....

Looks like a combination of multiple Jeeps there. The tub looks to be M38A1 with a tailgate cut in. Civilian dash and grill. Serial number plate for the CJ-5 would be just above the heater on the...
Jeep Forums: Jeep CJ Forum   09-21-2021, 10:18 PM
Replies: 4
Views: 822
Posted By Fourtrail
They should be for 5/16 inverted flare tube, i.e....

They should be for 5/16 inverted flare tube, i.e. brake or fuel line. The threads are 1/2"-20.
Jeep Forums: Jeep CJ Forum   09-21-2021, 04:14 PM
Replies: 8
Views: 643
Posted By Fourtrail
I would hand tighten the nut down at the speedo,...

I would hand tighten the nut down at the speedo, then back it off a turn and see what happens. The nut at the speedo doesn't need to be extremely tight and shouldn't unthread itself.
Jeep Forums: Jeep CJ Forum   09-21-2021, 04:04 PM
Replies: 10
Views: 625
Posted By Fourtrail
That is a dust cap that yes, can be removed. You...

That is a dust cap that yes, can be removed. You can mark the 2 halves of the shaft, then pull them apart to clean the male and female ends of the slip yoke. Be sure that when you put the...
Jeep Forums: Jeep CJ Forum   09-21-2021, 02:27 PM
Replies: 1
Views: 379
Posted By Fourtrail
I have been very happy with the Corbeau Baja SS...

I have been very happy with the Corbeau Baja SS seats in my '6 and in dad's '7. Very comfy and don't sit too high. They do have taller side bolsters though. You may want to look at the Baja JP as...
Jeep Forums: Engines & Drivetrain   09-20-2021, 04:20 PM
Replies: 1
Views: 608
Posted By Fourtrail
Correct, the temp sensor screws into the...

Correct, the temp sensor screws into the passenger side of the head just past the distributor. the oil pressure line is on the drivers side rear almost to the bellhousing. It is the clear plastic...
Jeep Forums: General Jeep & Off-Road Equipment   09-20-2021, 04:11 PM
Replies: 7
Views: 386
Posted By Fourtrail
Looks like a socket head M20-1.5 o-ring plug. ...

Looks like a socket head M20-1.5 o-ring plug. Worth a try before ordering a new radiator or jb welding the hole closed


https://www.amazon.com/Moroso-22738-20mm-1-5mm-Drain/dp/B009RL2KGK

...
Jeep Forums: Jeep CJ Forum   09-20-2021, 02:51 PM
Replies: 11
Views: 576
Posted By Fourtrail
This right here, with the Z bar upside down and...

This right here, with the Z bar upside down and the long arm connected to the clutch pushrod and the short arm connected to the clutch pedal, you are losing your mechanical advantage. Flip the Z bar...
Jeep Forums: Jeep CJ Forum   09-20-2021, 11:11 AM
Replies: 13
Views: 815
Posted By Fourtrail
I really want to play with the new Spal brushless...

I really want to play with the new Spal brushless fans and the control options.


How is your condenser fan mounted in relation to the shroud for the two puller fans? You may need to put flaps in...
Jeep Forums: Engines & Drivetrain   09-15-2021, 10:48 AM
Replies: 2
Views: 556
Posted By Fourtrail
The play is likely from the lifters going bad. ...

The play is likely from the lifters going bad. Did you start the engine before checking the free play? If not, the oil drains out of the lifter and you will have excessive clearance. Need to run...
Jeep Forums: JeepForum.com Forum Help Desk   09-15-2021, 10:40 AM
Replies: 1
Views: 368
Posted By Fourtrail
You can't delete post/thread as a normal member. ...

You can't delete post/thread as a normal member. You should be able to edit the post and take out all info and just leave the minimum amount of characters in the post. Below is a link that shows...
Jeep Forums: Jeep CJ Forum   09-14-2021, 01:22 PM
Replies: 12
Views: 912
Posted By Fourtrail
If the caps are on nation wide backorder, you can...

If the caps are on nation wide backorder, you can just replace them with 1 piece axle shafts... ;)
Jeep Forums: Jeep CJ Forum   09-14-2021, 01:08 PM
Replies: 13
Views: 1,293
Posted By Fourtrail
Table showing wire size and length for amperage. ...

Table showing wire size and length for amperage. If your 6 wires are 14 gauge/rated for 30 amp at 7' running distance, then 6*30=180 amp possible, so a #8 wire from the ground block to the battery...
Jeep Forums: Jeep CJ Forum   09-14-2021, 12:30 PM
Replies: 19
Views: 927
Posted By Fourtrail
the mileage is nice, they have put over 10,000...

the mileage is nice, they have put over 10,000 miles on it in the two years since the build. Had to do a fair amount of work to get the front end to behave with the weight of the motor, heavy...
Jeep Forums: Jeep CJ Forum   09-14-2021, 12:25 PM
Replies: 19
Views: 927
Posted By Fourtrail
Just saying be prepared, they ran into a lot of...

Just saying be prepared, they ran into a lot of little things when doing the swap. Follow donscottwheels on instagram to see more pictures from the build.
Showing results 1 to 20 of 250

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome