Jeep Enthusiast Forums banner

Stock radio cut out dimensions

3K views 15 replies 8 participants last post by  weapon 
#1 ·
I looking for dimensions for the the stock radio cut out in dashboard for 84 CJ7. PO cut out for standard DIN size radio and I want to restore it back to original size. Believe main cut out is 4 1/4" by 2" but would like confirmation as well as the diameter and spacing of radio knob holes on either side.
 

Attachments

See less See more
1
#2 ·
So I take it that you're going to do a restoration of a shaft radio then?
 
#4 ·
Ohh I see. mine was already cut out to single DIN size too, I'm sure someone has an unmolested dash panel out here.
 
#5 ·
Mine is 4 1/4" x 2". Holes are 5 1/2" Center to center with the diameter of 9/16". Also, note the hole on the right has a key way. This is on a '77 CJ5 if that matters to you.



Sent from my iPhone using Tapatalk
 
#7 ·
Thanks Bob. Would be the best way to do it, but I don't have the radio at the moment and want to complete the refurb of the dash panel ASAP.

Mine is 4 1/4" x 2". Holes are 5 1/2" Center to center with the diameter of 9/16". Also, note the hole on the right has a key way. This is on a '77 CJ5 if that matters to you.



Sent from my iPhone using Tapatalk
Thanks for the info seth. May ignore the keyway asI don't think I would need for the radio I am installing. Will post pic once I complete dash panel refurb.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top