|Topic Review (Newest First)|
|05-28-2020 06:58 AM|
|05-27-2020 01:25 PM|
|jtec||when you did the priming idea did it still have same issue?|
|05-27-2020 10:58 AM|
|88formula||tried all that.... turned key.. waited turned it again... then fired up|
|05-26-2020 08:57 AM|
This is obvious but carb cleaner is flammable so take caution.
Sent from my BND-L24 using Tapatalk
|05-26-2020 08:47 AM|
when it is that HOT soak condition.
Have you tried - turn key to RUN do not start count to 3 then key off now try to start - I am thinking maybe a fuel issue.
and thats an easy suggestion.
|05-26-2020 08:34 AM|
|88formula||ok it fires right up cold... and fires fine hot if I have it off for less than 15 min... but it has to be really hot over 215-220 and sitting for more than 20min it starts up fine then 5 seconds later it starts to stumble... till you start moving then it straitens out|
|05-26-2020 07:59 AM|
when starting cold - the engine needs to crank or fires right up?
When hot - any difference?
|05-26-2020 07:37 AM|
it is a process of test and elimination .
Adding my thoughts following the clues.
1st non sensor/electrical items on my mind;
fuel - pressure leaking down.
Coolant entering cylinder.
Vacuum leaks. and EVAP system leak.
right now valve train has me thiking - more coffee and I will thik on that
|05-25-2020 10:42 PM|
|05-25-2020 07:31 PM|
trying to help, those were my 1st thoughts
Fuel pump all you said was replaced - is it NEW IDK is it good IDK.
Fuel pressure test and leak down you did not mention either. good leaves a bit of guessing.
replaced IAC did not have me thinking clean IAC air bleeds.
Are you loosing coolant?
you did not say anything about vac leaks,
>> did you try the carb spray vac leak ck - esp when HOT? to easy to dismiss.
When you had the scanner did yu look at ECT and IAT?
|05-25-2020 07:03 PM|
|05-25-2020 07:03 PM|
|88formula||please guys read what I wrote... new injectors.. proper pressure .. did a leak down test.. all good|
|05-25-2020 10:34 AM|
|05-25-2020 09:55 AM|
Any issue with AIRBAG light, it does come on for 3seconds then go out?
You are seeing correct ECT?
I am unclear did you change IAC - if so did you clean any air bypass ports?
|05-25-2020 09:52 AM|
before the vapor lock suggestion where are you located - death valley?
Will your scanner let you look at live data?
|This thread has more than 15 replies. Click here to review the whole thread.|