JeepForum.com - Reply to Topic
Thread: 4.7 crankcase breather install Reply to Thread
Title:
Message:
Post Icons
You may choose an icon for your message from the following list:
 
 
 
   

Register Now



In order to be able to post messages on the JeepForum.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid e-mail address for yourself.



Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
03-21-2020 07:52 PM
OneSock
Quote:
Originally Posted by jtpeters View Post
@OneSock
I just changed out my Passenger Side Valve Cover gasket. This photo shows the CCV I believe you're referring to.
Yours looks slightly different than mine. My CCV is ALL the way at the back behind the valve cover. Interesting.
03-21-2020 07:47 PM
OneSock Well, I got it in. Had to simultaneously use a ratchet strap and a prybar to hold the wiring out of the way.
03-21-2020 04:28 PM
jtpeters @OneSock
I just changed out my Passenger Side Valve Cover gasket. This photo shows the CCV I believe you're referring to.
The cable you see just above the lower right connector houses the coil and fuel injector wiring.
If I were you, I would disconnect all coil and fuel injector connections, dislodge the wiring loom from the valve cover studs (I believe 2 ea studs), maneuver the cable above the valve cover and into a position near the rear of the valve cover resembling this photo.
Perhaps this will open up the CCV > head path.
03-20-2020 05:30 PM
Livewire9 Its tuff it get to ok darn near impossible unless u disconnect the last 3 coils & injectors pull the harness up tie it off & be patient with it skinny hands help greatly I don't so bleeding inspired your gloves is just part of the deal .. Good luck.
03-20-2020 05:23 PM
rickfaulks II went outside and took some pics of my 04 4.7HO, but I am a new member and evidently I am not allowed to upload pics yet.
03-20-2020 04:52 PM
OneSock
4.7 crankcase breather install

I have removed and reinstalled a 4.7 engine in a 2001 Grand Cherokee. I got a couple of new crankcase breathers since the old ones were broken. These are the ones that stick up almost vertical on the back of each cylinder head. I put the left breather in, no problem, but on the right side there's a great big bundle of wires directly over the breather hole leaving no room to install the breather. I'm wondering if the wiring got routed wrong during engine install, but I don't see how else it could go. It has the fuel injector and ignition connectors on it, and they are all where they need to be. Anyone got a picture?

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome