JeepForum.com - Reply to Topic
Thread: 2008 Grand Cherokee CRD wiring Reply to Thread
Title:
Message:

Register Now



In order to be able to post messages on the JeepForum.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid e-mail address for yourself.



Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
02-15-2020 12:35 AM
Sparkchaser1998 P0698 was the last code scanned- sensor reference voltage 3 circuit low. So far it appears that K29 white/brown wire, APPS N0. 2 Signal is shorted to ground, though I haven't disconnected the harness from the PCM yet to verify whether it is grounding through the PCM or to K167 or K400 wires. Tomorrow I'll pull out the battery and tray to get to the PCM. I found out today our local library has a subscription to AllData so I went down there and signed on to it and did a lot of digging. It appears that the factory service manual I found on Jeep Forum or somewhere has less pages (at least in the electrical section) than the online version available at AllData, plus at AllData they have a color version of some of the wiring diagrams that make following a circuit through from one end to the other easier. I'm still looking for a bit fuller version of the FSM to download for offline use. Interestingly, my Jeep's trouble code P0698 doesn't show in my copy of FSM but does show up in additional pages of the FSM shown in AllData. That's why I'm still looking for the newer edition of the FSM.
02-11-2020 06:42 PM
Tetto Just checked the FSM I have and learned it's the same as yours
02-08-2020 09:00 AM
jtec I am thinking Maybe post the code and describe issue - we could check TSB's and hopefully code specific circuits from trouble tree..
02-07-2020 10:31 PM
Sparkchaser1998
2008 Grand Cherokee CRD wiring

Hello all, I'm looking for diesel CRD-specific wiring diagrams. I already have pdf of 7000+ page FSM but it doesn't show much regarding the CRD. I also have the diesel supplement (called Chapter 9) but that only covers engine mechanicals of the diesel. I searched this site and lots of dead ends I got a color version of the wiring diagrams but those are also mostly gas-engine specific. One BIG difference I see with my CRD is the PCM is on the driver (left) side front under the battery, and has only 2 cable plugs, C1 and C2 while the gas versions have 3 plugs for the wiring harnesses and is located on passenger(right) side firewall.

I'm currently trying to troubleshoot APPS (accelerator pedal position sensor) problem. According to JSCAN the APPS always reports 89-91% position to PCM at all speeds and RPMs. The APPS has double inputs to the PCM so the vehicle still runs, but occasionally the vehicle loses power and the );( light comes on. I'm an electrician by trade so looking forward to getting better documentation for this vehicle.

Incidentally, today I found out the APPS isn't the type that has sliding contacts that wear out or get dirty after a while. It appears to be perhaps a hall-effect sensor in a sealed compartment and the moving magnet in another compartment of the same accelerator pedal assembly so no moving parts in the electronic side of the unit. Thus, I couldn't simply test the APPS with an ohmmeter.

Suggestions or comments welcome!

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome