JeepForum.com - Reply to Topic
Thread: Clanking with right turns Reply to Thread
Title:
Message:

Register Now



In order to be able to post messages on the JeepForum.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid e-mail address for yourself.



Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
12-10-2019 07:46 PM
TheLaidBackGuy May check front leaf spring bushings I have 95 yj and there is lateral movement on mine spring clunks when it hits the side of the shackle. I can feel it if hand is resting on the shifter. Just a thought

Sent from my SM-G975U using Tapatalk
12-05-2019 02:59 PM
sjecker Boojo35, thanks, I like that procedure. In the cold and with the plow needing to be used it seems at the exact time I have time to take her apart, lifting the front end seems easiest. I know changing the U joint is not the easiest of tasks, but at least I might know what is the problem.
12-04-2019 05:03 PM
Boojo35 @fishadventure has got a lot of great advice.

Rather than remove the front "half shaft" and drive again. Visually inspect the U Joints near the knuckles. If you see red dust around them. They are junk. If the rubber dust seals are compromised, they are junk or very near it. With the front of the vehicle in the air rotate them while providing resistance. There should be no play in them. It is the same as checking any U joint. Also turn the wheels and check for the same play and resistance. There are two of them in your front diff. A left and a right. Do not assume it is either of them. Check them both. It could be either.
12-04-2019 02:28 PM
fishadventure The outer “stub shaft” is the spindle.

The right side of a YJ front axle is two piece, but by half-shaft I’m referring to the axle shaft(s) that gave ujoints

In what you described the R side ujoint is a highly likely issue
12-04-2019 11:07 AM
sjecker Got it. The u joint therefore is between the stub shaft and half shaft.

Removing the front driveshaft would identify if it is the u joint. My vacuum mechanism stopped working before I bought the jeep, I have the fork in 4wd all the time.
12-04-2019 10:44 AM
jkbrereton Stub shaft is between the wheel bearings and the knuckle (all outside the differential housing). I believe the half shaft is between the knuckle and the vacuum joint thing inside the axle tube.

Easy way to eliminate anything else in the drive train is to pull the front drive shaft and drive it around in 2wd to see if the noise still happens. If it does not, put it in 4wd and see what happens. The vacuum should still actuate the joint and, if it IS the half shaft thing you will hear the noise and NOT feel it in the trans shifter.


Sent from my Pixel 2 XL using Tapatalk
12-04-2019 10:14 AM
sjecker At the risk of sounding stupid, (or inexperienced), I am not sure about the "halfshaft". I called Quadratec, and they told me a halfshaft is the intermediate shaft. That does not make sense, as it does not have a U joint.
Do you call the U joint for the halfshaft the U joint between the passenger side axle and the outer stub shaft axle? (I got those names from Quandratec.)
https://www.quadratec.com/vehicle/19...el%3ADana%2030
12-04-2019 06:50 AM
jkbrereton I'm leaning towards the half shaft fork thing.

Sent from my Pixel 2 XL using Tapatalk
12-04-2019 06:48 AM
sjecker I'll have to check that, thanks.
12-04-2019 06:47 AM
sjecker I don't feel it in the steering wheel. I feel it on the shifter and seemingly through the floor.
12-03-2019 05:28 PM
fishadventure ujoint in halfshaft
12-03-2019 09:17 AM
sjecker Yes, it does in both 2 and 4wd.
However, the vac switch in the front differential does not work and the fork is permanently attached. While the transfer case does engage/disengage, the fork demains in one position.
12-03-2019 08:59 AM
jkbrereton Does it do it in 2wd as well as 4wd?

Sent from my Pixel 2 XL using Tapatalk
12-03-2019 08:53 AM
sjecker It does it with or without the plow.
To tell the truth, I don't know so I'll check later today to see if I can feel it in the steering wheel.
I can feel it through the shifter.
12-03-2019 08:23 AM
jkbrereton I'm thinking bad ball joints. Does it do it without the plow mounted? Do you feel it in the steering wheel?

Sent from my Pixel 2 XL using Tapatalk
This thread has more than 15 replies. Click here to review the whole thread.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome