|Topic Review (Newest First)|
|11-20-2019 12:41 PM|
I have the exact opposite problem. My high setting doesn't work. The switch is melted around that terminal. I haven't got around to getting into it yet.
Sent from my Pixel 2 XL using Tapatalk
|11-17-2019 02:24 AM|
Had exactly the same issue with my 2005.
New resistor solved the problem.
|11-16-2019 11:06 AM|
the resistor should have 12v all 4 wires going to controls.
which one of the 4 wires the controls ground determines speed.
|11-16-2019 10:54 AM|
|TOMRR||Thanks. Looks like it is the Resistor|
|11-16-2019 10:09 AM|
There's a lot of information on this topic on the internet because this is a very common issue on TJ's.
You should start by checking the back of the switch and the connection at the resistor pack for melting/burning before replacing any parts. If that is the case your blower motor could be bad and drawing too much current. Or some say the circuit is under designed and needs relays installed. If that is not the case then you just may need to replace the resistor pack.
|11-16-2019 09:55 AM|
Heater Blower switch
2006 TJ. Only have the high setting on the heater blower motor. I t is just the switch iT self or some thing else