2007 Jeep Grand Cherokee
So I have this what I call a death rattle in the front end of my 2007 Grand Cherokee 4 wheel drive I have replaced upper lower control arms tourettes lower ball joints end link bushings and sway bar bushings. The rattle still exist. I have been purchased new upper strut mount bearing plates a rack and pinion bushings enter outer tie rods which is not been installed yet. Labor is a fortune and by the way the coils and struts are Detroit Axle only two years old 8,000 miles on them no off-roading. What am I missing to find this rattle from hell? If I install the new upper strut mount bushing plates and tie rods inner outer will it stop the problem or is it a CV axle joint issue? Any comments are greatly appreciated thank you I'm at my Wit's End and I've dumped a ton of money into this.