Jeep Enthusiast Forums banner

Windshield molding?

2K views 5 replies 5 participants last post by  zjosh93 
#1 ·
On my 94 ZJ, the windshield 'trim' has been broken down and peeling for a while. This is NOT the seal itself, but the black, rubber 'coating' over the chrome/silver bezel. Is there a part number for this, or something else people have used to replace this? I'll try to grab a picture later.
 
#2 ·
I was dealing withnthe same issue on my Dakota. I was going to pull it, finish stripping it, and coat it with bedliner

Sent from my LM-V405 using Tapatalk
 
#3 ·
Yeah, when I had those pieces off to install my a-pillar lights I stripped the factory coating off and sprayed on flat black. Looks better than it used to.
 
#4 ·
I sprayed them with black plasti-dip. You can access all the fasteners under the weather stripping and they come right off. The plasti-dip has help up well for about 8 months now.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top