Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 10 Results
  1. TJ Wrangler Technical Forum
    Hi, I am new to owning a Jeep. I am trying to do all of the work on it myself as well. I have a back and forth wobble on the drivers rear side. I replaced the bearings and in the process noticed that there was play in the axle, in and out movement. Afterwards, I still have a wobble and now the...
  2. Jeep CJ Forum
    I want to replace the U-Joints in my Dana 30. Ones needs to be replaced, its clunking a little, and the other side just because I figured I should just do both at the same time. It has 4.10s, Detroit Trutrac, and the CJ-7 is lifted 4 inches with 33sx12.5s. My question is, would you replace...
  3. TJ Wrangler Technical Forum
    My wheel started jerking as its straightening out similar to when you are in 4WD on dry ground. I am thinking that it's one of the axle u-joints. I am looking at RockAuto.com and they have a large variety of them. I know that we have Spicer from factory and that spicer is THE way to go but...
  4. XJ Cherokee Technical Forum
    I am replacing the u-joints on the front axle of my 2000 and just want to clear a few things up. First, according the stock specs sticky, I need 5-297x joints (correct me if I read it wrong). It seems that the 760x joints are supposed to be the same, but stronger. Are these the same size, just...
  5. TJ Wrangler Technical Forum
    Hello there,i am on the market for 4:56 gears i have an 03 TJ with 35" rubber.can u guys have a look at the link posted and tell me if thats what i need. I have higher gearing so i will need different carriers i already know that. DANA 30 DANA 35 GEAR PACKAGE JEEP YJ XJ TJ MASTER KITS: eBay...
  6. TJ Wrangler Technical Forum
    I need to carry a spare u-joint or two for the new Rubicon's driveshafts. The Rubicon uses the 1330 u-joint for its driveshafts but this version of the 1330 uses slightly smaller bearing caps than the 1330 used with GM applications. So I'm looking for the 1330 equivalent to Spicer's 5-785x...
  7. TJ Wrangler Technical Forum
    Hi Folks: Rust of all things has conspired to grind away the seals on my front axle u joints. The insides were barely worn at 200 k kms but they each gave way on the inside trunnions and were perfect on the outers. Maybe this is a normal wear pattern but the seals were ground away on one...
  8. TJ Wrangler Technical Forum
    I'm in the process of overhauling my front drive shaft. Im not a budget and have a total of about $50 to replace all three U joints. Whats are some decent U-Joints i can get and still be inside my budget?
  9. Engines & Drivetrain
    Dana publishes their service manuals on their website and they are available free of charge. Here is the link: http://media.spicerparts.com/media
1-9 of 10 Results
Top