Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 30 Results
  1. YJ Wrangler Technical Forum
    I was poking around in my engine bay today after doing an oil change and found this connector just hanging out. Not sure what it's for. It is up near the fire wall just to the drivers side. Any clues?? Thanks!
  2. WJ Grand Cherokee Forum
    I have a 2002 Jeep grand Cherokee.... It has 213,00miles and I just had the Transmission flushed. They put 6 not 7q in and said it was fine. Now it randomly hiccups when shifting (very randomly) and this morning is shut off on me 3 separate times (back to back) when I slowed way down to park. Is...
  3. ZJ Grand Cherokee Forum
    The hose from the pcv elbow to the air box was cracked, so I replaced it. I replaced the water pump at the same time. Within 15 minutes I got a code 51. Should the elbow be this loose? Could it be the problem? Vacuum leak?
  4. XJ Cherokee Technical Forum
    Hey guys, I'm in need of some advice here. I've had enough of the shaking and rattling and popping on these Michigan roads that I have to get this fixed. I need to know if I should get a new joint and replace the entire thing, or if I can just tighten it and it'll be all good. I've looked at...
  5. MJ Comanche Technical Forum
    Okay here goes.... First of all I've searched for days on the problems and none seem like my situation. This has been an underlying problem since I bought the jeep it seems but its only gotten worse. Ive had several of my co workers and mechanic friends try to figure it out (I used to work at...
  6. JK Wrangler Technical Forum
    Hey guys my pitman arm looks loose and I have terrible wheel slop where I can't move the wheel and it has about 1/2 inch of play. When I hit bumps I go flying. tell me what you think: This shows pitman to steering box nut: This shows the arm movement and angle:
  7. XJ Cherokee Technical Forum
    Hey Fellow Jeepers: I finally got the drum hardware back on and replaced wheel cylinders and lines. So I was going to adjust my drums and I overtightened the driver side rear brake and now I can't get my drum off! I tried to loosen it: I pushed back the pivot arm that locks the adjuster...
  8. YJ Wrangler Technical Forum
    I just bought a 1993 jeep wrangler yj and I noticed the heater blower wasn't working and after further investigation I found that the previous owner wrapped the wire around the heater blower fuse (no idea why). Now the area around the fuse is melted causing the fuse to be loose. Is there...
  9. ZJ Grand Cherokee Forum
    Hi all, I've noticed that the steering on my Jeep is loose when turning right. When turning left it seems to be OK. What would cause steering to be loose on one side and not the other? Any input would be greatly appreciated, I have no idea where to start...
  10. TJ Wrangler Technical Forum
    Hi all, Recently my TJ has developed a rattle at the front left (drivers side) engine bay and I've searched the forums but am stuck and need some help. :confused: While driving normally, there is no rattle at all and everything seems fine (although I may not hear it over the engine noise etc)...
  11. XJ Cherokee Technical Forum
    So I bought my first cherokee, an 88 xj with 284k miles on craigslist, and surprise surprise, shes not perfect. My issues are some very "easy" steering, and the brake pedal needs to be SLAMMED to even slow to a stop. First, the steering. When i say the steering is easy I dont really know a...
  12. TJ Wrangler Technical Forum
    Hey everyone, I just put in my Currie steering kit and noticed my upper track bar, where it fits over the ball, is loose. Not severely terrible or anything, just a little loose. I also think that is causing the 3-4 clacks when I accelerate from a stand still. What do you guys think? Thanks...
  13. XJ Cherokee Technical Forum
    The connection from the pigtail to my TPS sensor is not working consistently. Sometimes when driving the connection fails and my ECM goes "gee your not pushing down on the throttle at all so I think I'll just tell the TCU to stay in first gear." what a pain always happens at the most...
  14. TJ Wrangler Technical Forum
    Hi Guys, Need your help bad. I just bought a 2006 TJ Sport (6 cyl, auto). It looks like it has a 2-3 inch lift with 33'' tires. Steering is a little loose at all speeds but gets worse as speed goes up. Past 35 mph its really noticable. I took it to two mechanic and they are telling me different...
  15. Cheap Tricks & Fixes
    Picked up a Smittybilt hitch mounted cargo rack the other day and it wasn't really a surprise that it fit really loose in the hitch mount. Started looking for a better solution than the dinky plastic wedge that came with the rack, which by the way didn't take up enough of the slack. I found...
  16. TJ Wrangler Technical Forum
    NEW MEMBER AND JEEP OWNER!I have a 1997 Jeep Wrangler Sport (TJ) w/ the 4.o I-6 engine. I just purchased it 3 days ago so I don't know much about it. After driving today, I noticed an oilly fluid with a green tint on the top of the front passenger fender. When I opened the hood, the same fluid...
  17. TJ Wrangler Technical Forum
    hey, i just got the LoD xtreme tire carrier/bumper for my LJ in the mail today and immediately bolted it up with little issues. although after i attached the tire to the carrier it did not fit snug against the carrier and wobbles a lot. its currently on the middle slot of the backspacing...
  18. TJ Wrangler Technical Forum
    Did anyone find a solution for those old style mirrors being so loose no matter how hard you tighten the two screws up?? :thumbdown:
  19. TJ Wrangler Technical Forum
    Hmm well today I was working on the new jeep; replacing a snapped handbrake cable on the rear passenger side. The install went somewhat smoothly, and the internals of that drum brake are pretty annoying to fit back together. While under that area of the jeep I decided to check out the muffler...
  20. TJ Wrangler Technical Forum
    This might be a silly question but, can a loose battery terminal cause an inconsistent or "rough" idle? thanks for any info
1-20 of 30 Results
Top