Jeep Enthusiast Forums banner

Front bumper spray on liner

6K views 23 replies 14 participants last post by  Dean O 
#1 ·
Anyone use the rattle can spray on liner on their bumpers? How is it holding up and what did you do for prep? Just got my Rokmen in, the Besrk should be here in August and I was pondering spraying both with rattle can liner. Pics would be great. Thanks
 
#7 ·
x2 Krylon fusion for the prep work washed with soap and water and then wiped them down with acetone. Did the fenders in April holding up great to the rocks and mud no chips or anything like that. If you get gas on them it stains it I have noticed that but looks great and it's cheap I used the Ultra Flat Black.
 
#8 ·
:2c:In my opinion, DO NOT USE DUPLICOLOR!!! I have used it on the bumpers of my wife's TJ and found it to be a terrible product. It chips, flakes, and is just all-around garbage. Her front bumper had to be stripped back down to bare metal and refinished, and her rear bumper had rusted bad enough because of the poor finish/seal of the duplicolor, that I had to replace it.

I since have had a great experience with Herculiner roll-on bedliner on my bumpers, sliders,fender flares, grill, and inside the tub.
 
#10 ·
Pics??????

:2c:in my opinion, do not use duplicolor!!! i have used it on the bumpers of my wife's tj and found it to be a terrible product. It chips, flakes, and is just all-around garbage. Her front bumper had to be stripped back down to bare metal and refinished, and her rear bumper had rusted bad enough because of the poor finish/seal of the duplicolor, that i had to replace it.

I since have had a great experience with herculiner roll-on bedliner on my bumpers, sliders,fender flares, grill, and inside the tub.
 
#9 ·
#23 ·
I was going to herc it for 2 reasons. The first being that I was thinking that it would hold up better to chipping and abuse. The second is because of the texture. Kind of a stupid reason, but If i ever decide to stand on it, I won't slip lol
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top