I know this has been beaten to death but im thinking of spraying my hardtop black tomorrow. i was thinking of using the same paint i painted the jeep with, valspar tractor enamel gloss black. will the gloss look bad?
I used Krylon Fusion. Cleaned the hardtop. Acetone and then a tack cloth. Took three cans and it looks almost like my wife's hardtop for her JK. Used a satin finish if I remember right.
Yeah, light coats. I definitely took my time and didn't rush it. Bought one of those trigger sprayers for the spray can and spent the day in the paint booth (garage).
I cleaned the hardtop and dried it real well.
Lightly sanded it with a scotch brite pad. It was a brown one from AutoZone in their paint department.
Blew the dust off with my air compressor.
Let it sit for a while in the garage to settle and dust.
Used a tack cloth (AutoZone as well) all over it.
Masked the glass with green tape and newspaper.
Used a second tack cloth where my hands may have touched the hard top.
Started spraying the top and and then sides like you would with a paint gun.
Lots of strokes releasing the trigger while still using a spraying motion. (Followed the instructions on the can regarding drying times.)
Repeated until I went through three cans of Krylon.
If you do a search of the forum, goatboy had a write up that talked about painting a hardtop. I used most of his write up for painting my hardtop. My hardtop didn't require any fiberglass repair which probably saved me.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Jeep Enthusiast Forums
18.5M posts
726.8K members
Since 2000
A forum community dedicated to all jeep owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!