Jeep Enthusiast Forums banner

my jeep pics and my little mods(so far)!

126K views 304 replies 113 participants last post by  jeep2008 
#1 · (Edited)
My jeep pics and my little mods(so far)!

INSIDE:electric windows from spal seat risers and here the bracket to move the driver seat further back cause I'm 6.3'' footrest that comes up to clean-remove carpet and here mopar trunk and central locking(the picture is only from the mode in the rear so you can also use your third stop light) !i also have a sub under the rear seat but it's not worth posting it :)!:cheers2: now lets go to the outside...
 
See less See more
7
#2 · (Edited)
OUTSIDE:my summer cover clear lenses,mopar tubular bar,fog lights and the quadratec bumper ends putting the 31's,on the left are the old 225's my USA lights and my reverse light the 31's sticking a little bit out because of my 1,25'' spidetrax mopar bikini here are the 225's and you can see the bestop fuel door that's it so far!next is a 2'' re bb,procomp black alloys(8069,8179) and a rockslider(a-z,arb,warn) :cheers2:!thanks for your time,any comment is welcome :2thumbsup:!
 
#6 ·
That looks like an awesome garage. Where did you get the clear lenses?
 
#57 ·
#12 ·
I put 2 " seat risers in my '06 for two reasons. The seats are 1" lower than in my '00. Since I was making up the lost inch I added a 2nd inch so I can see the corners better.
I'm 5'7" and this also came with a welcome side effect I didnt realize beforehand, The sun visors are actually useful now!!! I always used to look just below them directly into the sun it seemed.

:wave:
 
#24 ·
the third brake light uses these contacts to work so if you want to take power from the 3d brake light wire and not put a new power wire from the front to the back of your Jeep ,to power an accessory like power locks in the talegate you have to buy from Jeep another set of these ground contacts!is the best solution if you don't want any wires hugging from the back!!
 
#26 ·
sweet rig, you need (imo) to get some black headlight bezels, looks like that's the last bit of chrome you have...
 
#27 ·
Sweet looking and clean... GET IT DIRTY! Looks better than my 06 does now.

Of topic...but whey do people cover up their liscense (sp?) plate numbers in pictures? Couldn't I just as easily see the info as your driving down the road?
 
#29 ·
Of topic...but whey do people cover up their liscense (sp?) plate numbers in pictures?
I cover mine up because there are a lot more people on the internet that could be doing shady stuff than the few people who see me on my commute.

Also most people list all their mods here, many of which are not visible, so now you have a grocery list of modifications and the license plate.

Lastly, the less personal info I leave on the World Wide Web the better, you never know who you are talking to on the Web.

I am probably paranoid....

Nice Jeep by the way....
 
#33 ·
ok,i installed my 2''re bb yesterday with some problems though you can read in another thread!anyway all is well now and here are some pictures of the lift:BEFORE AFTER BEFORE AFTER :cheers2:!i dare to say that the ride is better now and not harder than before as i was expecting it to be!new wheels tommorrow...:cheers:
 
#39 ·
ok,i painted the wheels to take out some of the chrome thing on them,installed front re ca's and the rear relocation track bar bracket!pictures coming later on!!!also purchased arb rock sliders(fantastic!!!) and they are to be installed by saturday....keep tuned!:cheers2:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top